Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM62A7 Other Parts Discussed in Thread: SYSCONFIG
Tool/software:
From release 10.00.00.14 onwards, BBM has been implemented in TI Drivers for NAND Flash Parts.
AM62A MCU SDK: https://www.ti.com/tool/download/MCU-PLUS-SDK-AM62A/10.00…
Part Number: TPS62867
Tool/software:
Hi Experts,
Customer is using the below device
The input is 3.6V - 5%
The output is 3.3V + 5%
Current 1-2 A.
Is there a min voltage difference that is required between the output and the input.
Regards…
Part Number: AM625
Tool/software:
HI TI experts,
I have a question on the SOC ROC.
Can i consider the ROC to be ±5% of the Nominal value for the supply rails or should i be considering the values mentioned in the data sheet ( some of the supplies…
Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62L
Tool/software:
HI TI experts,
Could you provide recommendations on CAP_VDDSx, cap value and effect of the capacitor not mounted or shorted.
Part Number: PROCESSOR-SDK-AM57X Tool/software: This is a patch to made for U-boot as an example of how to implement the workaround for AM57xx errata i2446:
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1
Tool/software:
Hello,
May I have question about SoC clock?
Q1
In this document,
https://www.ti.com/lit/an/sprad21e/sprad21e.pdf
It says EPHY need match clock to SoC.
Is the…
Part Number: SK-AM64B
Tool/software:
Hi Team,
I found in the schematic of EVM, we only use one piece of LMK1C1103PWR to buffer clock signal to 2 pieces of Ethernet PHY. Does it necessary to use one clock buffer? Can the different Ethernet PHY use…
Part Number: AM6442
Tool/software:
Hi Team,
We are using AM6442 for our new design. We are connected eMMC to MMC0 and we want to connect wifi module's SDIO signals to MMC1. Wifi module SDIO signal voltage level is 1.8v. We just want to confirm what…
Part Number: AM6442
Tool/software:
This FAQ provides a comprehensive guide to configuring and debugging the watchdog timer with a focus on all SITARA MPU devices in different real time use cases .
The guide addresses key concepts such as whether…
Part Number: AM625 Other Parts Discussed in Thread: AM62L , AM62P
Tool/software:
Hi TI Experts,
Do you have any suggestion on configuring the bootmode pins for alternate functions? I am using the bootmode resistors + buffers to configure the SOC…
