Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: TDA4VM Other Parts Discussed in Thread: , J721EXSOMXEVM , J721EXCPXEVM , PCM3168A , TPS25750 , TCA9543A , CDCEL937-Q1 , CDCI6214 , DS90UH981-Q1 , INA226 , PCM3168A-Q1 , DS90UB926Q-Q1
The goal of this thread is to help engineers differentiate…
Part Number: 66AK2H14 Hi,
I would like to know the list of examples available for K2H.
In the processor SDK, the steps to create CCS PDK examples for K2H are more generic for the series of processors.
Please provide the steps, particularly for k2H…
Part Number: TMS320C6678 Other Parts Discussed in Thread: CCSTUDIO
Hi,
Would you please provide a " Quick set up Guide or development guide or start up guide for C6678 and C6678-EVM " to enable a quick product development ?
Part Number: TMS320C6678 Hi,
I would like to know the list of examples available for C6678.
In the processor SDK, the steps to create CCS PDK examples for C6678 are more generic for the series of processors.
Please provide the steps, particularly…
Part Number: TMS320C6678 Other Parts Discussed in Thread: PROCESSOR-SDK-C667X Hi,
How to re-build the PDK and SDK of PROCESSOR-SDK-C667X 6.3 for C6678?
Part Number: TMS320C6657 Other Parts Discussed in Thread: CCSTUDIO
Hi,
Would you please provide a " Quick start Guide C6657 and C6657-EVM " to enable a quick product development ?
Part Number: AM6442
Team,
I have a question about "Figure 7-16. MCU_OSC0 Start-up Time" from the datasheet. Here it looks like that MCU_OSC0 is only allowed to start when VDD_MCU is ramping. In reality the osciallation starts already with VDDS_OSC0…
In below diagram, CLKOUT0 to drive 4 terminal need external buffer.
If CLKOUT0 only drive 2 terminal, can it just connected together or with resistors like below.
Other Parts Discussed in Thread: TDA4VL Hi experts,
Using TDA4VL board and 8.0.3 SDK, build and make SD card by default setting, it boot normally but don't display by DP port, and can't get any info about display driver by command: modetest -M tidss…
Part Number: TDA4VM Hi,
I am trying to build SBL in debug mode using BUILD_PROFILE=debug flag, but the build fails with the error “gmake: *** No rule to make target 'sbl_mmcsd_img'. Stop.”.
Is there a way to build SBL in debug mode?
