Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] What resources are available for TI-RTOS based or baremetal AM335x/AM437x SW development?

    Other Parts Discussed in Thread: AMIC110 , AMIC120 I'm going to start SW development for AM335x/AM437x. SW will be either TI-RTOS based or baremetal. What kind of resources are available to help my development? . Note that TI no longer provides support…

  • [FAQ] TDA4VM: How to boot TDA4VM from eMMC UDA partition using SBL in SDK 8.1

    Part Number: TDA4VM I want to boot TDA4VM from eMMC UDA partition using SBL. I am using SDK 8.1. Can someone share the process?

  • [FAQ] How can I access the Processor SDK RTOS training videos?

    I was trying to watch the training videos contained in the Processor SDK RTOS Getting Started Guide : Introduction to Processor SDK RTOS Part 1 Introduction to Processor SDK RTOS Part 2 Application Development Using Processor SDK RTOS It seems…

  • [FAQ] DRA821U: How to use DDR BIST engine for filling up pattern.

    Part Number: DRA821U Other Parts Discussed in Thread: DRA821 Dear support, For DDR ECC per-load, we use the BIST engine for SDRAM initilization, but it fails, the following is the registers configured, Could you help me check whether the configuration…

  • [FAQ] DRA821U: Test on SDK8.1 for Ethernet Firmware

    Part Number: DRA821U Hi Champs There're questions about Ethernet Firmware Test on SDK8.1 release. My customer has tried to activate 4-ports of CPSW-5g on top of SDK 8.1-prebuilt image. They found issues below. (with followings were executed…

  • [FAQ] TDA4VM: Large size of tispl.bin after integrating custom DM firmware for MCU R5

    Part Number: TDA4VM Other Parts Discussed in Thread: TI-CGT I have updated the Linux SDK top level Makefile to add my custom firmware for MCU1_0 (MCU R5). As I understand the path to the ELF image needs to be set as UBOOT_DM in the Makefile. But after…

  • [FAQ] TDA4VM: Not able to receive messages for a particular CAN ID, how to debug?

    Part Number: TDA4VM I am using MCAL CAN driver and able to transmit any message from the TDA4 using MCU MCAN0. However when I try to receive messages for a particular CAN ID from an external CAN emulator, I am not getting that on the TDA4's MCU MCAN0…

  • [FAQ] 66AK2E05: How to load and run the ARM gel file on K2E EVM

    Part Number: 66AK2E05 Hi, How to load and run the ARM gel file on K2E EVM ?

  • [FAQ] 66AK2E05: How to load and run the DSP gel file on K2E EVM

    Part Number: 66AK2E05 Hi, How to load and run the DSP gel file on K2E EVM?

  • [FAQ] 66AK2E05: How to create "Target configuration" and do "Test connection" on K2E EVM.

    Part Number: 66AK2E05 Hi, How to create "Target configuration" and do "Test connection" on K2E EVM?

View FAQ threads
  • Threads 198379 Discussions