TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197680 Discussions
  • Not Answered

    Is there any way to display graphics on TMDXEVM3503 board using Java? 0 Locked

    303 views
    4 replies
    Latest over 13 years ago
    by Charvi Mehta
  • Not Answered

    Java/JVM support for AM/DM37xx EVM 0 Locked

    411 views
    4 replies
    Latest over 13 years ago
    by Charvi Mehta
  • Not Answered

    Embedded java in omap3530 0 Locked

    238 views
    1 reply
    Latest over 13 years ago
    by Charvi Mehta
  • Answered

    kernel git source for dvsdk 3.10.00.19 0 Locked

    429 views
    1 reply
    Latest over 13 years ago
    by Anil
  • Not Answered

    OTG full speed support on ISP1507 0 Locked

    209 views
    0 replies
    Started over 13 years ago
    by James Li
  • Answered

    OMAP4430 MEMORY MAP OVERVIEW 0 Locked

    3033 views
    9 replies
    Latest over 13 years ago
    by studinstru sggs
  • Not Answered

    DM365 MPEG2Encoder Problem 0 Locked

    327 views
    5 replies
    Latest over 13 years ago
    by Yashwant Dutt
  • Not Answered

    DMA mode support for nand prefetch/post-write engine 0 Locked

    1025 views
    3 replies
    Latest over 13 years ago
    by Jim Mobashery
  • Not Answered

    HDVPSS lockup. 0 Locked

    396 views
    6 replies
    Latest over 13 years ago
    by Bitlord
  • Answered

    Severe problem on versions confliction 0 Locked

    1349 views
    3 replies
    Latest over 13 years ago
    by David Allen
  • Not Answered

    Create USB communication on OMAP-L138 LOGICPD 0 Locked

    118 views
    0 replies
    Started over 13 years ago
    by Vincent St-Pierre
  • Not Answered

    c5535 audio corruption when using i2c 0 Locked

    152 views
    0 replies
    Started over 13 years ago
    by michael swanson
  • Not Answered

    How to generate ECC and syndrome with C5505? 0 Locked

    153 views
    0 replies
    Started over 13 years ago
    by Jiří Babka
  • Not Answered

    Does CBR mean CVBR? 0 Locked

    775 views
    5 replies
    Latest over 13 years ago
    by YOJI YASUDA
  • Not Answered

    Looking for recommendation for Beagleboard-xM video demo/capability 0 Locked

    183 views
    0 replies
    Started over 13 years ago
    by Chuck Palmer
  • Answered

    Port DSPLink to DM814x 0 Locked

    949 views
    11 replies
    Latest over 13 years ago
    by Victor Chan
  • Not Answered

    Asynchronous Reads with Wait on EMIF 0 Locked

    636 views
    8 replies
    Latest over 13 years ago
    by Derick Voegeli
  • Answered

    Issue with OMAP 4430 GPMC interface on Panda Board 0 Locked

    787 views
    2 replies
    Latest over 13 years ago
    by David Anders
  • Not Answered

    Problem with FIR filter in ezdsp C5502 0 Locked

    732 views
    1 reply
    Latest over 13 years ago
    by Avik Dayal
  • Answered

    transfert DATA from externanl memory DDR to internal memory LL2RAM using EDMA3 of C6472 DSP 0 Locked

    464 views
    4 replies
    Latest over 13 years ago
    by David wilson
<>