TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM64x / AM243x / AM62Ax / AM62Px / AM62D-Q1 / AM62L - Bootmode implementation without isolation buffers

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62A-LP , AM62L , AM62P Tool/software: Hi TI Experts, Do you have suggestions to optimize the BOOTMODE configuration on custom board compared to implementation on the SK or the EVM schematics…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625SIP / AM625-Q1 / AM62Ax / AM62Px Custom board hardware design – CSI-2 capabilities

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, I have the below queries regarding the CSI-2 interface Supported data rate Does the CSI-2 interface provide provision for internal termination Links to useful threads Let me know your…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6442: Running Raw Serdes

    Tony Spagnolia
    Tony Spagnolia
    Part Number: AM6442 Tool/software: We have a desire to use the SERDES as a raw interface without a protocol on top. The idea would be to just run 8b/10b and limit our packet size to 10 -40 bits. Is this possible or do we need to run PCIE or USB using…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AH-Q1: How to edit/change ONNX graph to remove unsupported layers by TIDL and add supported ones

    Pratik Kedar
    Pratik Kedar
    Part Number: TDA4AH-Q1 Tool/software: I have ONNX graph with below mentioned layer structure. Which tools can i use to change the unsupported layer (HardSwish) to Supported ones ?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] SK-TDA4VM: No graphics acceleration on SDK 9.x in Wayland (Weston)

    JB LIM
    JB LIM
    Part Number: SK-TDA4VM Other Parts Discussed in Thread: TDA4VM Tool/software: Hi, TI Team I run an opencv example program(drawing and media play) in Wayland(western). But drawing(graphics) is little bit slow and media play occurs a stuttering frames…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM623: 4GB LPDDR4

    Kim Yue
    Kim Yue
    Part Number: AM623 Tool/software: Hi team, A customer wants to have 4GB LPDDR4 (single channel topology). They could not find 4GB 16-bit single-channel LPDDR4, there is only 2GB option. Can they use a 32-bit device and only connect one channel?…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62P: How to measure wakeup latency for Low Power Modes on AM62x/A/P

    Anshu Madwesh
    Anshu Madwesh
    Part Number: AM62P Tool/software: How can you measure the wakeup latency for Low Power Modes on AM62x/A/P? Low Power Mode's wakeup latency is the amount of time required from triggering a wakeup event to resuming normal operation. This FAQ shows to…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62x, AM62Ax, AM62D-Q1, AM62L, AM62Px, AM64x, AM243x, Custom board hardware design – How to handle Used / Unused Pins / Peripherals and add pullup or pulldown? (e.g. GPIOs, SERDES, USB, CSI, MMC (eMMC, SD-card), CSI, OLDI, DSI, CAP_VDDSx, .......

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, Is there any application note with information about how to connect IOs or Peripherals - Used or Unused Details on the connections to be done when used. When not used, should these IOs or Peripherals…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH-Q1: How to change the ATF to print on MCU_UART in SBL bootflow

    Nikhil Dasan
    Nikhil Dasan
    Part Number: TDA4VH-Q1 Tool/software: In the SBL bootflow, using BootApp, how to print ATF logs on MCU_UART or WKUP_UART?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to enable switching capability between GPO and GPI operation for PRU GPIO?

    Nitika Verma
    Nitika Verma
    Part Number: AM6442 Other Parts Discussed in Thread: SYSCONFIG Tool/software: Each PRU_ICSSG PRU processor implements fast GPO through its R30 register and fast GPI through R31 register. AM64x/AM243x has 20 pinned out PRU GPIO pins and the device…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198401 Discussions
  • Answered

    Problems when writting into the IPC register 0 Locked

    494 views
    1 reply
    Latest over 13 years ago
    by ArunMani
  • Not Answered

    i need the eeprom example code for pci boot on the dm648. 0 Locked

    200 views
    0 replies
    Started over 13 years ago
    by kim kwang joo
  • Answered

    Rebuilding SYS/BIOS 0 Locked

    3452 views
    17 replies
    Latest over 13 years ago
    by Tom Kopriva
  • Answered

    Unable to flash the u-boot.bin into NOR Flash (by following DM816x/AM389x PSP Flashing Tools Guide) 0 Locked

    615 views
    2 replies
    Latest over 13 years ago
    by Michael Brooks
  • Not Answered

    getting glib.h not found error on Beagleboard-xM rev.C 0 Locked

    333 views
    0 replies
    Started over 13 years ago
    by shravan kulkarni
  • Not Answered

    having glib error on Beagleboard-xM Rev.C 0 Locked

    261 views
    0 replies
    Started over 13 years ago
    by shravan kulkarni
  • Not Answered

    some bugs in DM365_DVR_DVSDK3_00.02.00.00.zip 0 Locked

    430 views
    1 reply
    Latest over 13 years ago
    by Prabhakar Lad
  • Not Answered

    How can I use CODEC ENGINE APIs in QT application? 0 Locked

    476 views
    8 replies
    Latest over 13 years ago
    by baomin li87233
  • Not Answered

    Makefile dependency problem 0 Locked

    285 views
    0 replies
    Started over 13 years ago
    by Rolf Christensen
  • Not Answered

    MIcroSD card in place of SD card on DM816x or any procesor 0 Locked

    166 views
    0 replies
    Started over 13 years ago
    by K Md Feroz Irfan
  • Not Answered

    IPIPE DM8148 vs DM8127 0 Locked

    4255 views
    11 replies
    Latest over 13 years ago
    by Raghu Kudva
  • Not Answered

    mean of "30% of supply for up to 30% signal period" (overshoot/undershoot spec) 0 Locked

    230 views
    0 replies
    Started over 13 years ago
    by Motoyasu Hattori
  • Answered

    VFP 0 Locked

    667 views
    2 replies
    Latest over 13 years ago
    by Patrick1
  • Answered

    Vector Floating Point( vfp or vfpv3) -------- AM3517 0 Locked

    479 views
    2 replies
    Latest over 13 years ago
    by Patrick1
  • Answered

    DDR2 corners in traces 0 Locked

    519 views
    4 replies
    Latest over 13 years ago
    by Mohammad Ali Koteich
  • Suggested Answer

    WAVEDEV2\HWCTXT MCBSP Question 0 Locked

    299 views
    1 reply
    Latest over 13 years ago
    by Adeneo Embedded support team
  • Answered

    Opening ASCII file on OMAP-L138 Zoom EVM board, WinCE 6.0, VS2005 0 Locked

    384 views
    1 reply
    Latest over 13 years ago
    by Adeneo Embedded support team
  • Answered

    VPFE problem using Image Tuning Tool 0 Locked

    835 views
    10 replies
    Latest over 13 years ago
    by wq p
  • Not Answered

    UART2 in CIR mode for TI 8148 0 Locked

    418 views
    4 replies
    Latest over 13 years ago
    by REHAN KHAN
  • Answered

    DMA from GPINT2 0 Locked

    219 views
    2 replies
    Latest over 13 years ago
    by Chris Thomas
<>