TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198111 Discussions
  • Not Answered

    Vendor ID for EVM 8168 board 0 Locked

    191 views
    0 replies
    Started over 13 years ago
    by Soibam Singh
  • Not Answered

    TI_android_froyo-devkit2.2 not boot 0 Locked

    336 views
    6 replies
    Latest over 13 years ago
    by Pankaj Bharadiya
  • Answered

    WHICH IS BEST FOR CODING ? 0 Locked

    360 views
    3 replies
    Latest over 13 years ago
    by RandyP
  • Answered

    C6672 power-down sequencing 0 Locked

    469 views
    3 replies
    Latest over 13 years ago
    by RandyP
  • Answered

    DM816x H.264 Encoder 0 Locked

    362 views
    2 replies
    Latest over 13 years ago
    by SandroM
  • Not Answered

    How to see the messages generated by Log_print()? 0 Locked

    271 views
    0 replies
    Started over 13 years ago
    by Jason Ma72757
  • Not Answered

    About H.264 resolution of IPNC 2.6 0 Locked

    249 views
    4 replies
    Latest over 13 years ago
    by gomo
  • Answered

    What's the interrupt selection number for McBSP? 0 Locked

    363 views
    2 replies
    Latest over 13 years ago
    by Kei Mochida
  • Not Answered

    OMAP3530 ISP: CCDC to Previewer 0 Locked

    188 views
    1 reply
    Latest over 13 years ago
    by Vaibhav Hiremath
  • Answered

    EDMA3 PaRAM Link - PaRAM load time 0 Locked

    430 views
    2 replies
    Latest over 13 years ago
    by Shintaro
  • Not Answered

    Cannot set GPMC_WAIT3 in mode 4 to high 0 Locked

    126 views
    1 reply
    Latest over 13 years ago
    by Vaibhav Hiremath
  • Discussion

    Working with H264 encoder version 1.12.00 at DM6437. Locked

    221 views
    2 replies
    Latest over 13 years ago
    by Roopesh Rajashekharaiah Nataraja
  • Not Answered

    Decode Dolby AC3 audio data from a MPEG-2 Transport Stream 0 Locked

    399 views
    0 replies
    Started over 13 years ago
    by Gary Cochran
  • Not Answered

    Can we attach P-ATA or S-ATA type HDD to DM368 EMIF Bus 0 Locked

    311 views
    2 replies
    Latest over 13 years ago
    by 123 123
  • Answered

    Making your own development board 0 Locked

    766 views
    3 replies
    Latest over 13 years ago
    by BrandonAzbell
  • Not Answered

    C6672 datasheet power sequencing 0 Locked

    581 views
    1 reply
    Latest over 13 years ago
    by RandyP
  • Not Answered

    PowerVR PVR2D api document 0 Locked

    1618 views
    3 replies
    Latest over 13 years ago
    by Prabindh Sundareson
  • Answered

    How can I improve the H264 performance? 0 Locked

    384 views
    5 replies
    Latest over 13 years ago
    by Yashwant Dutt
  • Answered

    DMA channel is not enough on DM365 0 Locked

    441 views
    1 reply
    Latest over 13 years ago
    by Yashwant Dutt
  • Answered

    C6678 DDR3 simulation models 0 Locked

    511 views
    4 replies
    Latest over 13 years ago
    by Shareef
<>