TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM654x, AM652x : Data sheet Documentation (about timing) of the power sequencing

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM6548 Tool/software: Hi TI experts, On page 142 of the datasheet "AM654x, AM652x Sitara Processors Silicon Revision 2.1 datasheet (Rev. C)", Figure 6-4. Power-Up Sequencing using On Chip Power-on-reset (POR) has labels such as "Note…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM6422: How to configure the PCIe align with the simulation results.?

    wang shu
    wang shu
    Part Number: AM6422 Tool/software: Hi, I am setting the PCIe configuration. We simulated the PCIe using the IBIS model of AM6422. Below picture is the configuration we could get best simulation results. We don't know how to set it in AM6422 software…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP: eMMC0_DAT0 not enabled pull up by ROM

    Tony Tang
    Tony Tang
    Part Number: AM625 Tool/software: #1. On my customer board using eMMC0 boot, did not pull up eMMC0_DAT0, occasionally can't boot up by Power On, but can boot up by warm reset or power cycle. #2. Add pull up on eMMC_DAT0, can boot up always so far…
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Data sheet Pin Attributes and Pin connectivity related queries

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, I have the below query regarding the data sheet Pin attributes Pin attributes I have a number of IOs that are not used, is there a connection recommendation Is there a recommendation for the…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Current Data sheet revision, updates, revision backup and usage notes

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P , AM62L Tool/software: Hi TI Experts, I have the below query Currently available data sheet revision How do i verify i am using the latest revision Is there a way i can receive…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM69: How to run GStreamer pipeline with RTSP source

    Fabiana Jaimes
    Fabiana Jaimes
    Part Number: SK-AM69 Tool/software: How to stream H.264 encoded streams from a RTSP compliant IP camera or via RTSP server running on remote PC using GStreamer?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM5728: Build and Test Guide for AM57xx Driver Examples using CCS

    Karthikeyan S
    Karthikeyan S
    Part Number: AM5728 Tool/software: Hi, How can I build and test an AM57xx driver example Using CCS?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM623: Can eMMC0 support DDR50 mode

    Tony Tang
    Tony Tang
    Part Number: AM623 Tool/software: Can MMC0 port support eMMC DDR50? In the datasheet, list only 3 modes for eMMC application. DDR50 in SD Card application but not for eMMC. Although list all features in TRM, but we was told follow datasheet…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] How to flash u-boot to GPMC-NAND with USB-DFU on AM62x

    Hong Guan64
    Hong Guan64
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62-LP Tool/software: AM62x boot ROM supports booting from parallel GPMC NAND. From "5.4.9.1 GPMC NAND Bootloader Operation" in AM62x TRM "GPMC NAND boot only supports boot from ONFI 1.0 compatible…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: What is the purpose of --operation=flash-phy-tuning-data ?

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: SK-AM64B Tool/software: Greetings All, In MCU PLUS SDK offering, across Sitara SoCs, one must have come across different configuration files. These configuration files are located inside the directory: MCU_PLUS_SDK_INSTALL_PATH\tools…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198373 Discussions
  • Answered

    EDMA3 6678 Transfers failing for "larger" A and B counts 0 Locked

    1438 views
    12 replies
    Latest over 14 years ago
    by Tim Wentz
  • Not Answered

    c5515 4-bit ecc 0 Locked

    152 views
    1 reply
    Latest over 14 years ago
    by Hyun Kim
  • Not Answered

    Advance setting problems about H.264 encoder 0 Locked

    161 views
    1 reply
    Latest over 14 years ago
    by MarcPyne
  • Answered

    Understanding OMAP-L138 Linux McASP driver (davinci-mcasp.c) 0 Locked

    856 views
    3 replies
    Latest over 14 years ago
    by GrantHatamosa
  • Answered

    Why can't I find OMAPL138_tixds560.ccs ? 0 Locked

    177 views
    1 reply
    Latest over 14 years ago
    by stanley h
  • Not Answered

    DM3730 USB OTG Documentation Errors 0 Locked

    236 views
    0 replies
    Started over 14 years ago
    by David Stewart
  • Answered

    dm365 h263 codec implementation 0 Locked

    902 views
    6 replies
    Latest over 14 years ago
    by James Ni
  • Not Answered

    power pins used in the DM8148 EVM and are not mentione in the DM8148 datasheet 0 Locked

    296 views
    1 reply
    Latest over 14 years ago
    by ScottB
  • Not Answered

    bootloader 0 Locked

    465 views
    8 replies
    Latest over 14 years ago
    by seeni vasan
  • Not Answered

    Issue trying to set interrupts on the OMAP 3530 IVA module 0 Locked

    222 views
    0 replies
    Started over 14 years ago
    by Ram Krishnan75260
  • Answered

    C6748 Silicon errata 2.0.1 0 Locked

    343 views
    2 replies
    Latest over 14 years ago
    by Mukul Bhatnagar
  • Not Answered

    C5515 CSL Audio Class problem 0 Locked

    297 views
    3 replies
    Latest over 14 years ago
    by Juliana Mansell
  • Not Answered

    DM6446 Evaluation Module Orcad Schematic Symbol 0 Locked

    279 views
    2 replies
    Latest over 14 years ago
    by Kenneth Tu
  • Not Answered

    Beagleboard-xM DVSDK4.01 Encoder not working 0 Locked

    174 views
    0 replies
    Started over 14 years ago
    by Naveen Kumar.S
  • Not Answered

    C6747 rom verion D800K003? 0 Locked

    375 views
    3 replies
    Latest over 14 years ago
    by jc-ti
  • Not Answered

    Unable to import matrix_tui 0 Locked

    291 views
    1 reply
    Latest over 14 years ago
    by Jeff L
  • Not Answered

    AM3715 use the WINCE to develope a industry PDA,I want to know how to flash the EBOOT and the program into the FLASH 0 Locked

    558 views
    2 replies
    Latest over 14 years ago
    by Pierre Savary
  • Not Answered

    Multi spi in OMAP-L138 0 Locked

    346 views
    2 replies
    Latest over 14 years ago
    by ranchu
  • Answered

    DM814x routing guidelines planned? 0 Locked

    391 views
    2 replies
    Latest over 14 years ago
    by KevenC
  • Discussion

    SEM_pend() timeout problem Locked

    1539 views
    3 replies
    Latest over 14 years ago
    by ToddMullanix
<>