TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197753 Discussions
  • Not Answered

    evm5515 code composer 3.3 +dsp/bios 0 Locked

    470 views
    6 replies
    Latest over 14 years ago
    by talmor zilberman
  • Not Answered

    FPGA(with SRIO IP core) and DSP (C6455 DSK board) connection issues-How get the Nwrite package's address field? 0 Locked

    564 views
    1 reply
    Latest over 14 years ago
    by RandyP
  • Not Answered

    Questions on ezsdk_c6a816x-evm_5_00_00_56_setuplinux 0 Locked

    240 views
    3 replies
    Latest over 14 years ago
    by RV
  • Not Answered

    DM365 and XDS560 PCI JTAG Emulator 0 Locked

    451 views
    5 replies
    Latest over 14 years ago
    by YJ Liu
  • Answered

    DM36X MPEG4 compressed 3M (2048X1536) 0 Locked

    329 views
    2 replies
    Latest over 14 years ago
    by Akshay Panday
  • Answered

    DSPLib FFT input scaling question 0 Locked

    414 views
    1 reply
    Latest over 14 years ago
    by RandyP
  • Answered

    Converting COFF file to binary image on C6454 0 Locked

    1192 views
    2 replies
    Latest over 14 years ago
    by Joel Schoen
  • Suggested Answer

    What are the theoretical maximum Video Port Display and Capture Rates for Raw Data mode? 0 Locked

    342 views
    1 reply
    Latest over 14 years ago
    by TimHarron
  • Answered

    about OMAP-L138 connect with slow device 0 Locked

    446 views
    9 replies
    Latest over 14 years ago
    by Daniel Allred
  • Not Answered

    AM3517 USB OTG document 0 Locked

    348 views
    2 replies
    Latest over 14 years ago
    by Yingbo Hu
  • Not Answered

    DM64xx MAC address 0 Locked

    242 views
    1 reply
    Latest over 14 years ago
    by Zegeye Alemu
  • Suggested Answer

    Enabling cache on ARM in OMAP-L138? 0 Locked

    1204 views
    2 replies
    Latest over 14 years ago
    by MikeH
  • Not Answered

    Can DM6467 work with GigE Vision Camera ? 0 Locked

    366 views
    1 reply
    Latest over 14 years ago
    by srirami
  • Not Answered

    question about PLL1 0 Locked

    282 views
    5 replies
    Latest over 14 years ago
    by dabuan
  • Not Answered

    regarding UART 0 Locked

    624 views
    7 replies
    Latest over 14 years ago
    by Hyun Kim
  • Not Answered

    recommend method for initiating reset from software 0 Locked

    257 views
    3 replies
    Latest over 14 years ago
    by Power Pan
  • Answered

    AM1808 using DDR2 0 Locked

    381 views
    6 replies
    Latest over 14 years ago
    by Power Pan
  • Not Answered

    Suspend hangs with mounted SD card using OMAP_03.00.01.06 on DM37x 0 Locked

    219 views
    0 replies
    Started over 14 years ago
    by Peter Barada67018
  • Not Answered

    mcasp using dmax in c672x 0 Locked

    213 views
    1 reply
    Latest over 14 years ago
    by dabuan
  • Not Answered

    Error connecting to the target 0 Locked

    493 views
    1 reply
    Latest over 14 years ago
    by dabuan
<>