TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM64X/ AM62X : How to Reset the SOC when WDT timer expires in AM64X and AM62X?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Introduction: The primary application of a watchdog timer is as a system monitor to detect and reset an "out of control" SOC. When program execution goes wrong or software or devices are not functioning properly, the watchdog…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH/AM62A: How to create the CAC mesh LUT for DCC tuning tool input?

    Gang Hua
    Gang Hua
    CAC in VPAC3-VISS or VPAC3L-VISS is very similar to LDC in VPAC. To prepare the CAC LUT for DCC tuning tool input, we may use similar matlab/octave script as LDC. You may refer to the LDC FAQ in the link below for more details. e2e.ti.com/.../faq-tda4vm…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] DRA821: canTxstatus is busy even after Cancellation of Finished messages is set for respective Tx Buffer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customer has enabled AUTO retransmission of messages, and Using the CAN channel on TDA4x device to continuously send messages, and then remove other nodes on the CAN bus. Later it entered into Error passive state , and the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J784S4: How Do I Build Yocto Images and Packages for J7 Devices?

    Jared McArthur
    Jared McArthur
    Part Number: PROCESSOR-SDK-J784S4 Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , AM68 , AM69 , SK-AM68 , SK-AM69 How do I build the default yocto images and install new packages for J7 devices?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP : LFOSC usage in the processor

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P-Q1 , , AM62A7-Q1 , AM623 Hi, I have a question from my customer for LFOSC (external 32.668kHz). According to datasheet section 7.11.4.1 Input Clocks / Oscillators, it seems the clock…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62A7 / AM62A3 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Custom board hardware design – EXTINTn pin pullup connection

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Hi TI Experts, I have the below queries regarding the use of EXTINTn pin. Termination recommendations when used. Termination recommendations when not used. Let me know your thoughts.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62A-LP , AM62P , TMUX1308-Q1 , TPS65224-Q1 Hi Board designers, Refer FAQs listed below related to custom board design for AM62Ax and AM62D-Q1 processor families that could be used along with other available…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625, AM623, AM620-Q1, AM625-Q1, AM625SIP Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62 , SK-AM62B-P1 , SK-AM62-LP , SK-AM62-SIP , SK-AM62B , AM62P , TMUX1308-Q1 , TPS65219 Hi Board designers, Refer FAQs listed below related to custom board design for AM62x processor family that could…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1 / AM625-Q1 Custom board hardware design – Collaterals to Get started

    Lavanya M R
    Lavanya M R
    Part Number: AM625-Q1 Other Parts Discussed in Thread: AM620-Q1 , AM625 , AM623 , , AM625SIP , AM62D-Q1 , TPS65219 , SK-AM62-LP , SK-AM62B-P1 , SYSCONFIG Hi TI Experts, Can you provide a List of collaterals that can be referred when starting a custom…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VL How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198177 Discussions
  • Answered

    Can a server load balance between running codecs on ARM and DSP automatically? 0 Locked

    190 views
    1 reply
    Latest over 15 years ago
    by Chris Ring
  • Not Answered

    multiple pointers supported on DSP side? 0 Locked

    169 views
    0 replies
    Started over 15 years ago
    by dave li
  • Not Answered

    I have some question about PCI boot mode 0 Locked

    399 views
    2 replies
    Latest over 15 years ago
    by RandyP
  • Not Answered

    Unable to mount usb storage in rowboat on AM3517evm 0 Locked

    542 views
    3 replies
    Latest over 15 years ago
    by Syed Mohammed Khasim
  • Suggested Answer

    Crystal maximum ESR versus Rs 0 Locked

    1104 views
    12 replies
    Latest over 15 years ago
    by Brian Willoughby
  • Not Answered

    am1808 and usb program software 0 Locked

    170 views
    1 reply
    Latest over 15 years ago
    by tlee
  • Answered

    [C672x] Can dMAX be used for a SPI Master Mode transfer, if so how? 0 Locked

    363 views
    2 replies
    Latest over 15 years ago
    by Paul45899
  • Answered

    C6713 McBSP1 intermittent reception problem 0 Locked

    334 views
    3 replies
    Latest over 15 years ago
    by tlee
  • Answered

    AM3715 Mass 0 Locked

    324 views
    1 reply
    Latest over 15 years ago
    by peaves
  • Answered

    Are there any Physical limitians associated with C6713? 0 Locked

    315 views
    3 replies
    Latest over 15 years ago
    by tlee
  • Answered

    OMAPL138 GPIO Acknowledge in INTSTAT 0 Locked

    295 views
    1 reply
    Latest over 15 years ago
    by Brad Griffis
  • Answered

    Examples that will run on non-EVM? 0 Locked

    245 views
    1 reply
    Latest over 15 years ago
    by CoolAJ86
  • Answered

    Appropriate memory location for cmemk.ko 0 Locked

    702 views
    2 replies
    Latest over 15 years ago
    by CoolAJ86
  • Answered

    Where to find ISP / CCDC Documentation as it relates to the Linux Kernel? 0 Locked

    508 views
    4 replies
    Latest over 15 years ago
    by CoolAJ86
  • Answered

    ISP / CCDC raw (custom) capture with ISP vsync / hsync as master 0 Locked

    626 views
    4 replies
    Latest over 15 years ago
    by CoolAJ86
  • Not Answered

    OMAP PSP WebEx Presentation, Broken Link 0 Locked

    255 views
    4 replies
    Latest over 15 years ago
    by CoolAJ86
  • Not Answered

    Problems adding new BT.656 device 0 Locked

    324 views
    3 replies
    Latest over 15 years ago
    by CoolAJ86
  • Not Answered

    NAND ECC support for DM6446 DSP 0 Locked

    456 views
    2 replies
    Latest over 15 years ago
    by Brad Griffis
  • Not Answered

    ALSA arecord or mic input to TPS issue 0 Locked

    651 views
    2 replies
    Latest over 15 years ago
    by Jake Salmi
  • Discussion

    What is the roadmap for OMAP3525/OMAP3530 devices? Locked

    663 views
    4 replies
    Latest over 15 years ago
    by Brad Griffis
<>