Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] How to flash GPMC-NAND with Lauterbach JTAG on AM62x

    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62-LP Tool/software: AM62x boot rom supports booting from parallel GPMC NAND. From "5.4.9.1 GPMC NAND Bootloader Operation" in AM62x TRM "GPMC NAND boot only supports boot from ONFI 1.0…

  • [FAQ] PROCESSOR-SDK-AM64X: How to generate GPIO interrupt on both falling and rising edge?

    Part Number: PROCESSOR-SDK-AM64X Tool/software: How to configure GPIO interrupt for both rising and falling edge? How to identify which edge (i.e. rising or falling) generates interrupt?

  • [FAQ] : AM6X Device Reset Troubleshooting Document

    Part Number: AM6442 Tool/software: Many users are asking how to investigate the Reset source when the device continuously getting resting. The below FAQ brief can be helpful to find the Reset reason . The FAQ mainly focuses on AM64X devices, but this…

  • [FAQ] AM625: Configuring Am625 ALW usb0 in host mode

    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SK-AM62-LP , SK-AM62B , SK-AM62-SIP Tool/software: Hi all, we are trying to configure usb0 to work as host so that when we connect a device like usb it will read the data from the usb. our…

  • [FAQ] TDA4VL-Q1: Decode H264 and H265 data using V4L2 and Display the same using RTOS driver

    Part Number: TDA4VL-Q1 Tool/software: An application to Decode H264 and H265 data using V4L2 and Display the same using RTOS driver

  • [FAQ] AM625 / AM623 / AM62A / AM62P / AM64x / AM243x Design Recommendations / Custom board hardware design – Dynamic Voltage Scaling

    Part Number: AM625 Tool/software: HI TI experts, I have a question on the SOC ROC and Dynamic Voltage scaling. Is see the Core Voltage being 0.75V or 0.85V Does the AM6x processor families support dynamic voltage scaling

  • [FAQ] AM625 / AM623 / AM62A / AM62P / AM64x / AM243x Design Recommendations / Custom board hardware design - Starter kit / EVM variants and Key components list

    Part Number: AM625 Other Parts Discussed in Thread: TMDS64EVM , SK-AM64B , SK-AM62B-P1 , SK-AM62-LP , SK-AM62B , SK-AM62-SIP , SK-AM62A-LP , SK-AM62P-LP Tool/software: Hi TI Experts, Is there a list of TI SK/EVMs for AM6x processor families and key components…

  • [FAQ] TDA4VM-Q1: How do we set/configure a specific MAC address for an ETHFW virtual client?

    Part Number: TDA4VM-Q1 Tool/software: How do we set/configure a specific MAC address for an ETHFW virtual client?

  • [FAQ] AM62A1-Q1: IBIS Model Inquiry

    Part Number: AM62A1-Q1 Other Parts Discussed in Thread: AM62A3 , AM62A7 Tool/software: Hi Team, Hope you're doing well. Could you share the IBIS model of AM62A12AQMSIAMBRQ1 under different temp?(-40oC/25oC/85oC) Thank you.

  • [FAQ] AM6422: SK and EVM EXT_REFCLK1 CLKOUT0 use case and configuration

    Part Number: AM6422 Other Parts Discussed in Thread: SK-AM64B , , CDCLVC1310 Tool/software: Hi, In AM6422 evaluation board SK-AM64B. It connect the EXT_REFCLK1 to CLKOUT0 signal. i have some question about it. 1. EXT_REFCLK1 is 3.3V. Why it connect to a 1…

View FAQ threads
  • Threads 187743 Discussions