TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM64X/ AM62X : How to Reset the SOC when WDT timer expires in AM64X and AM62X?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Introduction: The primary application of a watchdog timer is as a system monitor to detect and reset an "out of control" SOC. When program execution goes wrong or software or devices are not functioning properly, the watchdog…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH/AM62A: How to create the CAC mesh LUT for DCC tuning tool input?

    Gang Hua
    Gang Hua
    CAC in VPAC3-VISS or VPAC3L-VISS is very similar to LDC in VPAC. To prepare the CAC LUT for DCC tuning tool input, we may use similar matlab/octave script as LDC. You may refer to the LDC FAQ in the link below for more details. e2e.ti.com/.../faq-tda4vm…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] DRA821: canTxstatus is busy even after Cancellation of Finished messages is set for respective Tx Buffer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customer has enabled AUTO retransmission of messages, and Using the CAN channel on TDA4x device to continuously send messages, and then remove other nodes on the CAN bus. Later it entered into Error passive state , and the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J784S4: How Do I Build Yocto Images and Packages for J7 Devices?

    Jared McArthur
    Jared McArthur
    Part Number: PROCESSOR-SDK-J784S4 Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , AM68 , AM69 , SK-AM68 , SK-AM69 How do I build the default yocto images and install new packages for J7 devices?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP : LFOSC usage in the processor

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P-Q1 , , AM62A7-Q1 , AM623 Hi, I have a question from my customer for LFOSC (external 32.668kHz). According to datasheet section 7.11.4.1 Input Clocks / Oscillators, it seems the clock…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62A7 / AM62A3 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Custom board hardware design – EXTINTn pin pullup connection

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Hi TI Experts, I have the below queries regarding the use of EXTINTn pin. Termination recommendations when used. Termination recommendations when not used. Let me know your thoughts.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62A-LP , AM62P , TMUX1308-Q1 , TPS65224-Q1 Hi Board designers, Refer FAQs listed below related to custom board design for AM62Ax and AM62D-Q1 processor families that could be used along with other available…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625, AM623, AM620-Q1, AM625-Q1, AM625SIP Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62 , SK-AM62B-P1 , SK-AM62-LP , SK-AM62-SIP , SK-AM62B , AM62P , TMUX1308-Q1 , TPS65219 Hi Board designers, Refer FAQs listed below related to custom board design for AM62x processor family that could…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1 / AM625-Q1 Custom board hardware design – Collaterals to Get started

    Lavanya M R
    Lavanya M R
    Part Number: AM625-Q1 Other Parts Discussed in Thread: AM620-Q1 , AM625 , AM623 , , AM625SIP , AM62D-Q1 , TPS65219 , SK-AM62-LP , SK-AM62B-P1 , SYSCONFIG Hi TI Experts, Can you provide a List of collaterals that can be referred when starting a custom…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VL How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198149 Discussions
  • Answered

    Attempt to send UDP packets of size 32k per sendto. (EVM6678L) 0 Locked

    2159 views
    7 replies
    Latest over 10 years ago
    by Pubesh
  • Not Answered

    C674x : how to implement Exception 0 Locked

    343 views
    1 reply
    Latest over 10 years ago
    by Shankari G
  • Answered

    AC coupling location in PCIe lanes on Keystone I devices 0 Locked

    374 views
    2 replies
    Latest over 10 years ago
    by Senthilkumar Srinivasan
  • Answered

    PCIe Clock Frequency (C6657) 0 Locked

    468 views
    2 replies
    Latest over 10 years ago
    by Senthilkumar Srinivasan
  • Suggested Answer

    c6745 connect 0 Locked

    483 views
    2 replies
    Latest over 10 years ago
    by Shankari G
  • Not Answered

    FVID_create() failed to configure DM648 VPORT register 0 Locked

    216 views
    0 replies
    Started over 10 years ago
    by Joshua Xu
  • Not Answered

    mcbsp config to slave mode 0 Locked

    297 views
    2 replies
    Latest over 10 years ago
    by Senthilkumar Srinivasan
  • Answered

    C6638 SRIO Maintenance Recovery Procedure 0 Locked

    906 views
    3 replies
    Latest over 10 years ago
    by Ganapathi Dhandapani95
  • Answered

    Customized board of C6713 with minimum size. 0 Locked

    444 views
    2 replies
    Latest over 10 years ago
    by Titusrathinaraj Stalin
  • Answered

    Simultaneously write data to C6678 erro by using RapidIO 0 Locked

    406 views
    4 replies
    Latest over 10 years ago
    by Ganapathi Dhandapani95
  • Answered

    Is AM437x supporting twin-die DDR3? 0 Locked

    739 views
    5 replies
    Latest over 10 years ago
    by g.f.
  • Answered

    pnc rdk 3.5 how to scale stream from 2592x2128 to 1920x1080 ? 0 Locked

    2641 views
    28 replies
    Latest over 10 years ago
    by yue gu1
  • Answered

    NDK: DHCP - Ip.autoIp = true; 0 Locked

    1956 views
    5 replies
    Latest over 10 years ago
    by Soumyajit Das
  • Discussion

    DHCP Enable/Disable during Run-time in NDK Locked

    921 views
    3 replies
    Latest over 10 years ago
    by Soumyajit Das
  • Not Answered

    AM335x Linux 3D Graphic Demo Issue 0 Locked

    394 views
    2 replies
    Latest over 10 years ago
    by user1834270
  • Answered

    Compile error in GPIO.xs no property named 'devicePinSetting' 0 Locked

    1457 views
    11 replies
    Latest over 10 years ago
    by Robert Drummey
  • Suggested Answer

    Using EDMA3 to transfer 1Mx16 bit from EMIFA 0 Locked

    891 views
    3 replies
    Latest over 10 years ago
    by RandyP
  • Not Answered

    DM8168 DVRRDK3.5 probabilistic process appears to hang, sleep problems, the mouse can not stop 0 Locked

    562 views
    3 replies
    Latest over 10 years ago
    by user user1
  • Not Answered

    the conflict between NDK scheduling and the receiving data of the uart`s hwi 0 Locked

    490 views
    3 replies
    Latest over 10 years ago
    by n li
  • Suggested Answer

    WHERE CAN i FOUND c code of Fixed-point C code of 2.4 kbps MELP? 0 Locked

    2261 views
    2 replies
    Latest over 10 years ago
    by RandyP
<>