Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] TDA4VM: Steps for executing linux DSS on SDK

    Part Number: TDA4VM What are the steps for executing linux DSS on SDK?

  • [FAQ] AM625: How to measure interrupt latency on multicore Sitara devices using cyclictest?

    Part Number: AM625 Other Parts Discussed in Thread: AM3357 , , AM6442 How can I measure interrupt latency on Sitara multicore devices such as AM625 and compare the results to single core devices such as AM3357? . For more information on testing…

  • [FAQ] TMS320C6657: How to run the direct SPI-BOOT example on TI-C6657-EVM without IBL ?

    Part Number: TMS320C6657 Hi, How to run the direct SPI-BOOT example on TI-C6657-EVM without IBL ? Regards Shankari G

  • [FAQ] SK-TDA4VM: How to reset the system using main domain watchdog

    Part Number: SK-TDA4VM There are multiple instances of watchdogs on the main domain. How to enable full SoC reset upon a main domain watchdog timer expiry.

  • [FAQ] TI's EdgeAI @ Electronica 2022 : Evaluate examples

    Hello, Here is a quick look at live demonstrations on TI's Edge AI Platform shown at Electronica 2022 . Featured Edge AI Applications in Real world enabled on TI Processors at Electronica 2022 Robotics & Automation…

  • [FAQ] TDA4VM: How to read the DDR frequency from Linux

    Part Number: TDA4VM Other Parts Discussed in Thread: DRA821 The DDR is configured by R5 SPL/SBL. Is there a way to check the frequency of DDR from Linux at runtime?

  • [FAQ] AM64x: How to customize QSPI/OSPI flash layout for SPL/u-boot booting from QSPI/OSPI with TI AM64x Linux SDK

    I’m working on customer board porting, and want to know how to modify QSPI/OSPI flash layout for SPL/u-boot booting from QSPI/OSPI with TI AM64x Linux SDK.

  • [FAQ] AM62x: How to check and configure eMMC flash RST_N signal to support WARM_RESET from eMMC booting on AM62x-SK E2

    eMMC flash and boot work as expected on AM62x-SK E2 board from Power-On-Reset (POR), but an issue as listed below is observed on AM62x-SK E2. The Issue observed After successful eMMC boot from cold POR, WARM RESET options as listed below doesn’t re-boot…

  • [FAQ] AM625: PMIC + FET to control 1.8 VPP

    Part Number: AM625 Hi, my customer has a question about using an output from the TPS6593 PMIC + a FET to control ON/OFF for 1.8V VPP on the processor? They are trying to see if they can get by without using a dedicated LDO for 1.8V VPP.

  • [FAQ] 66AK2E05: Flashing UBI Image

    Part Number: 66AK2E05 How to Flash UBI Image into NAND from U-Boot Terminal ?

View FAQ threads
  • Threads 198210 Discussions