TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197793 Discussions
  • Not Answered

    DM368 APPRO : Capture Noise after audio overrun 0 Locked

    909 views
    3 replies
    Latest over 10 years ago
    by Lodge
  • Not Answered

    AM5728 Processor Max supported ddr3l Clock Frequency 0 Locked

    1665 views
    1 reply
    Latest over 10 years ago
    by Biser Gatchev-XID
  • Answered

    [C6655] via diameter 0 Locked

    406 views
    4 replies
    Latest over 10 years ago
    by Naoki Kawada
  • Suggested Answer

    DDR initializing for OMAP-L138 EDMA3 mcsdk example 0 Locked

    504 views
    5 replies
    Latest over 10 years ago
    by Titusrathinaraj Stalin
  • Not Answered

    HEVC encoder integration 0 Locked

    396 views
    1 reply
    Latest over 10 years ago
    by Ramamohana Reddy
  • Answered

    DM8127 u-boot problem 0 Locked

    5274 views
    24 replies
    Latest over 10 years ago
    by Pavel Botev
  • Not Answered

    DM8127 issue 0 Locked

    1488 views
    6 replies
    Latest over 10 years ago
    by tejas patil
  • Not Answered

    I2C multi-master arbitration question 0 Locked

    547 views
    1 reply
    Latest over 10 years ago
    by Markus Moll
  • Not Answered

    problem whit uboot logo 0 Locked

    359 views
    4 replies
    Latest over 10 years ago
    by jinlong liao
  • Not Answered

    Capture encode demo failed on dm8168: FVID Control GetChipId Failed 0 Locked

    1110 views
    9 replies
    Latest over 10 years ago
    by Margarita Gashova
  • Answered

    TI-RTOS NDK two port switch mode problem 0 Locked

    1328 views
    11 replies
    Latest over 10 years ago
    by Bin Hu
  • Answered

    Booting AM335x 0 Locked

    103 views
    1 reply
    Latest over 10 years ago
    by Biser Gatchev-XID
  • Answered

    What is the physical address of memory mapped hardware breakpoint registers? 0 Locked

    2090 views
    10 replies
    Latest over 10 years ago
    by Matthijs van Duin
  • Answered

    emmc flashing with u-boot.img & image.fit images onto BBB 0 Locked

    9683 views
    18 replies
    Latest over 10 years ago
    by Titusrathinaraj Stalin
  • Answered

    Need guidance for ARM processor design 0 Locked

    422 views
    2 replies
    Latest over 10 years ago
    by Senthilkumar Srinivasan
  • Answered

    [C6655] LM10011 is really required ? 0 Locked

    384 views
    2 replies
    Latest over 10 years ago
    by Naoki Kawada
  • Suggested Answer

    C6748 build Project for .out , use AISgen Generate AIS,load .ais ,then star-up board didn't operated. 0 Locked

    971 views
    5 replies
    Latest over 10 years ago
    by Shankari G
  • Not Answered

    Does ucd9248 need repeated start to probe? 0 Locked

    231 views
    1 reply
    Latest over 10 years ago
    by Yordan Kovachev
  • Answered

    edma engine, kernel 3.17.0 on am1808 0 Locked

    1866 views
    11 replies
    Latest over 10 years ago
    by Titusrathinaraj Stalin
  • Not Answered

    66AK2H14 does not generate an exception on illegal crosspath usage 0 Locked

    257 views
    1 reply
    Latest over 10 years ago
    by kraajaa
<>