TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198295 Discussions
  • Suggested Answer

    does the dm643x bootloader perform ddr2 VTP calibration? 0 Locked

    319 views
    1 reply
    Latest over 16 years ago
    by Brad Griffis
  • Answered

    [C6727] Power Measurement 0 Locked

    237 views
    2 replies
    Latest over 16 years ago
    by RandyP
  • Not Answered

    Code Composer Studio v4 Beta available 0 Locked

    1531 views
    14 replies
    Latest over 16 years ago
    by George Mock
  • Not Answered

    UART 2 0 Locked

    337 views
    6 replies
    Latest over 16 years ago
    by Brendan Cassidy
  • Answered

    allocating constant tables in flash 0 Locked

    387 views
    3 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    MPEG4 playback in Windows Media Player, MPlayer, and VLC Locked

    1797 views
    4 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    Storage of data in L2 of the DSP TMS320C6474 0 Locked

    353 views
    3 replies
    Latest over 16 years ago
    by RandyP
  • Suggested Answer

    VICP and TI's H.264 Encoder 0 Locked

    235 views
    2 replies
    Latest over 16 years ago
    by Gabriel Quintana
  • Answered

    [OMAP3503] VDDS_MMC1A(VDDS_SIM) powered from 3.0V? 0 Locked

    224 views
    1 reply
    Latest over 16 years ago
    by Brad Griffis
  • Answered

    Printf delaying SRIO interrupts on C6474 EVM target. 0 Locked

    365 views
    2 replies
    Latest over 16 years ago
    by gareth james
  • Answered

    [C6711] Audio Output Channel Select Help 0 Locked

    343 views
    1 reply
    Latest over 16 years ago
    by RandyP
  • Suggested Answer

    SmartReflex document 0 Locked

    418 views
    2 replies
    Latest over 16 years ago
    by RandyP
  • Suggested Answer

    Power on reset of DaVinci 0 Locked

    314 views
    1 reply
    Latest over 16 years ago
    by Brad Griffis
  • Answered

    How could I get the test source code with DaVinci EVM for CCS 0 Locked

    285 views
    1 reply
    Latest over 16 years ago
    by Brad Griffis
  • Not Answered

    proper lcd for omapl137 evm 0 Locked

    219 views
    0 replies
    Started over 16 years ago
    by YongchaoDeng
  • Not Answered

    How to check if the message is sent out using SRIO in C6455 EVM? 0 Locked

    441 views
    2 replies
    Latest over 16 years ago
    by tscheck
  • Not Answered

    Display issue on OMAP 35x EVM board 0 Locked

    190 views
    0 replies
    Started over 16 years ago
    by Krupa
  • Not Answered

    Orcad symbol for DM355 0 Locked

    242 views
    2 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    dct on vicp (dm6446) 0 Locked

    534 views
    6 replies
    Latest over 16 years ago
    by Victor Cheng
  • Not Answered

    OMAP-L137 DSP needs synchronous DMA 0 Locked

    360 views
    7 replies
    Latest over 16 years ago
    by Juan Gonzales
<>