TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM654x, AM652x : Data sheet Documentation (about timing) of the power sequencing

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM6548 Tool/software: Hi TI experts, On page 142 of the datasheet "AM654x, AM652x Sitara Processors Silicon Revision 2.1 datasheet (Rev. C)", Figure 6-4. Power-Up Sequencing using On Chip Power-on-reset (POR) has labels such as "Note…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM6422: How to configure the PCIe align with the simulation results.?

    wang shu
    wang shu
    Part Number: AM6422 Tool/software: Hi, I am setting the PCIe configuration. We simulated the PCIe using the IBIS model of AM6422. Below picture is the configuration we could get best simulation results. We don't know how to set it in AM6422 software…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP: eMMC0_DAT0 not enabled pull up by ROM

    Tony Tang
    Tony Tang
    Part Number: AM625 Tool/software: #1. On my customer board using eMMC0 boot, did not pull up eMMC0_DAT0, occasionally can't boot up by Power On, but can boot up by warm reset or power cycle. #2. Add pull up on eMMC_DAT0, can boot up always so far…
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Data sheet Pin Attributes and Pin connectivity related queries

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, I have the below query regarding the data sheet Pin attributes Pin attributes I have a number of IOs that are not used, is there a connection recommendation Is there a recommendation for the…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Current Data sheet revision, updates, revision backup and usage notes

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P , AM62L Tool/software: Hi TI Experts, I have the below query Currently available data sheet revision How do i verify i am using the latest revision Is there a way i can receive…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM69: How to run GStreamer pipeline with RTSP source

    Fabiana Jaimes
    Fabiana Jaimes
    Part Number: SK-AM69 Tool/software: How to stream H.264 encoded streams from a RTSP compliant IP camera or via RTSP server running on remote PC using GStreamer?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM5728: Build and Test Guide for AM57xx Driver Examples using CCS

    Karthikeyan S
    Karthikeyan S
    Part Number: AM5728 Tool/software: Hi, How can I build and test an AM57xx driver example Using CCS?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM623: Can eMMC0 support DDR50 mode

    Tony Tang
    Tony Tang
    Part Number: AM623 Tool/software: Can MMC0 port support eMMC DDR50? In the datasheet, list only 3 modes for eMMC application. DDR50 in SD Card application but not for eMMC. Although list all features in TRM, but we was told follow datasheet…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] How to flash u-boot to GPMC-NAND with USB-DFU on AM62x

    Hong Guan64
    Hong Guan64
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62-LP Tool/software: AM62x boot ROM supports booting from parallel GPMC NAND. From "5.4.9.1 GPMC NAND Bootloader Operation" in AM62x TRM "GPMC NAND boot only supports boot from ONFI 1.0 compatible…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: What is the purpose of --operation=flash-phy-tuning-data ?

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: SK-AM64B Tool/software: Greetings All, In MCU PLUS SDK offering, across Sitara SoCs, one must have come across different configuration files. These configuration files are located inside the directory: MCU_PLUS_SDK_INSTALL_PATH\tools…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198379 Discussions
  • Not Answered

    L137 McASP (occasional lock-ups) 0 Locked

    239 views
    3 replies
    Latest over 16 years ago
    by Joseph Woodward
  • Not Answered

    how can I use usb mouse in a GUI application on OMAP35x EVM Linux sdk 1.0.2? 0 Locked

    527 views
    9 replies
    Latest over 16 years ago
    by RamaDevi7842
  • Not Answered

    dvevm_1_20 resize_example pix_fmt question 0 Locked

    304 views
    4 replies
    Latest over 16 years ago
    by Prathap Srinivas
  • Answered

    dvevm demo DVI output? 0 Locked

    320 views
    4 replies
    Latest over 16 years ago
    by Prathap Srinivas
  • Discussion

    TMS320C6452 EVM Locked

    407 views
    3 replies
    Latest over 16 years ago
    by adnan khurshid
  • Not Answered

    DM648 - confusions - ethernet 0 Locked

    383 views
    2 replies
    Latest over 16 years ago
    by Amna Rasul
  • Suggested Answer

    how to clear the RXPKTRDY bit in the HOST_CSR0 register? 0 Locked

    233 views
    1 reply
    Latest over 16 years ago
    by BrandonAzbell
  • Not Answered

    Simple audio loop-back for DSK 5510. 0 Locked

    426 views
    2 replies
    Latest over 16 years ago
    by TommyG
  • Suggested Answer

    HANDLE of statically created objects (BIOS) 0 Locked

    238 views
    1 reply
    Latest over 16 years ago
    by Mariana
  • Suggested Answer

    DM6437 cycle accurate simulator? 0 Locked

    559 views
    7 replies
    Latest over 16 years ago
    by RobbySun
  • Suggested Answer

    is it possible to use DMA from both ARM and DSP side with DSPLINK only, without the need to work with Codec Engine? 0 Locked

    412 views
    3 replies
    Latest over 16 years ago
    by Brad Griffis
  • Suggested Answer

    Gel File and Linker CMD file 0 Locked

    691 views
    4 replies
    Latest over 16 years ago
    by Brad Griffis
  • Suggested Answer

    Visual linker still available? 0 Locked

    329 views
    2 replies
    Latest over 16 years ago
    by Brad Griffis
  • Discussion

    [OT] short survey - how do you value codec engine? Locked

    177 views
    0 replies
    Started over 16 years ago
    by GiPa
  • Discussion

    [OT] short survey - how do you value codec engine? Locked

    220 views
    0 replies
    Started over 16 years ago
    by GiPa
  • Answered

    DM355 and CMEMK insert 0 Locked

    689 views
    4 replies
    Latest over 16 years ago
    by Guillaume ROCHE10734
  • Not Answered

    OMAP3530 USB port1 how to make work? 0 Locked

    546 views
    0 replies
    Started over 16 years ago
    by jodan
  • Not Answered

    USB Storage gadget 0 Locked

    918 views
    8 replies
    Latest over 16 years ago
    by Brendan Cassidy
  • Not Answered

    omapl137 's USB transmission Speed 0 Locked

    220 views
    3 replies
    Latest over 16 years ago
    by swami
  • Suggested Answer

    how to use codec engine for application development on Windows CE with OMAP EVM 3530? 0 Locked

    378 views
    2 replies
    Latest over 16 years ago
    by Brad Griffis
<>