TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197738 Discussions
  • Not Answered

    LCD interface to DM355 EVM 0 Locked

    413 views
    2 replies
    Latest over 17 years ago
    by Juan Gonzales
  • Not Answered

    Loading U-Boot 0 Locked

    1023 views
    9 replies
    Latest over 17 years ago
    by SJackson
  • Discussion

    EDMA Problems Locked

    483 views
    0 replies
    Started over 17 years ago
    by sressler
  • Not Answered

    DM648 cache coherency problem 0 Locked

    548 views
    1 reply
    Latest over 17 years ago
    by Brad Griffis
  • Discussion

    DM648 GPIO0-7 pins and/or Pin Mux Register Select Locked

    649 views
    2 replies
    Latest over 17 years ago
    by JRasmussen
  • Discussion

    OMAP35xx L3 interconnect Locked

    409 views
    1 reply
    Latest over 17 years ago
    by Bernie Thompson TI
  • Answered

    [C6713] C++ exceptions 0 Locked

    714 views
    2 replies
    Latest over 17 years ago
    by Brad Griffis
  • Discussion

    XDS510 USB and DM355 Locked

    515 views
    1 reply
    Latest over 17 years ago
    by BrandonAzbell
  • Not Answered

    Linking problems with Reuse Startup Code Space option set 0 Locked

    425 views
    2 replies
    Latest over 17 years ago
    by TimHarron
  • Answered

    PROBLEM ABOUT THE C6720 BOOTLOADER 0 Locked

    475 views
    1 reply
    Latest over 17 years ago
    by TimHarron
  • Discussion

    Perl version to run C672x Bootloader Utilities Locked

    575 views
    0 replies
    Started over 17 years ago
    by Mariana
  • Discussion

    L2 ram latency Locked

    387 views
    1 reply
    Latest over 17 years ago
    by Brad Griffis
  • Not Answered

    DM648 BIOS Cache Configuration Problem... 0 Locked

    721 views
    3 replies
    Latest over 17 years ago
    by Bernie Thompson TI
  • Not Answered

    A question for our developers out there 0 Locked

    250 views
    0 replies
    Started over 17 years ago
    by Michael Sandoval
  • Not Answered

    Powering the USB and RTC Module on TMS320VC5509A/07/06/03 devices. 0 Locked

    376 views
    0 replies
    Started over 17 years ago
    by Naser S.
  • Not Answered

    For C5000 devices( C54X and C55X), what is the recommendation on what to do with interrupt pins if unused. 0 Locked

    291 views
    0 replies
    Started over 17 years ago
    by Naser S.
  • Discussion

    Can analog and digital video outputs on DM6446 display different images? Locked

    433 views
    2 replies
    Latest over 17 years ago
    by Juan Gonzales
  • Not Answered

    CSL for C6455 and CCS 0 Locked

    405 views
    0 replies
    Started over 17 years ago
    by Mariana
  • Discussion

    How do I build u-boot for NAND? Locked

    397 views
    0 replies
    Started over 17 years ago
    by Juan Gonzales
  • Not Answered

    I get resizer errors when I try to run the demos included with the DVSDK 0 Locked

    407 views
    0 replies
    Started over 17 years ago
    by Juan Gonzales
<>