Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM6442
Hello TI experts,
I want to make the SOC reset from software. How can I do it?
What is the difference between POR (power on reset) and warm reset?
This FAQ mainly explains how to Reset the SOC. And what are the registers used…
Part Number: PROCESSOR-SDK-J721E By default, McSPI/SPI Drivers in PSDKRA uses packet descriptors for transferring or for receiving data to/from the SPI slave device. Sometimes it might require to use TR descriptors, because TR supports additional functionalities…
Part Number: AM62A7-Q1
SD cards is not need in our project using AM62A7-Q1. if SD card is not used, how to connect the pin net VDDSHV4, VDDSHV5, and VDDSHV6 of AM62A7-Q1? leave it open or connected directly to VSS or ?
Part Number: EDGE-AI-STUDIO
Texas Instruments has a multitude of resources available for machine learning at the edge (Edge AI). These are spread across ti.com, dev.ti.com (TI Developer Zone + Edge AI Studio), and github. The majority of these resources…
Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: SYSCONFIG
Hi,
Can you please help me to access DDR from a PRU core?
.
The information in this FAQ applies to all Sitara processors with a PRU_ICSSG: AM24x, AM64x, AM65x. The example…
Hi,
For running a executable through CCS following steps needs to be performed.
Open the Code Composer Studio(CCS).
Launch the target configuration file.
Load the executable to the desired core.
Execute the main() function.
To…
