Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask technical support questions on everything from precision and general purpose operational amplifiers (op amps) to instrumentation and differential amplifiers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] What is a 4-20mA current transmitter?

    What is a 4-20mA current transmitter?

  • [FAQ] Does TI have integrated 4-20mA transmitters for inputs from RTDs?

    Other Parts Discussed in Thread: XTR105 , XTR112 , XTR108 Does TI have integrated 4-20mA transmitters for inputs from RTDs (resistive temperature detectors)?

  • [FAQ] Does TI have integrated 4-20mA transmitters for inputs from bridge sensors?

    Other Parts Discussed in Thread: XTR106 , PGA309 , XTR117 Does TI have integrated 4-20mA transmitters for inputs from bridge sensors?

  • [FAQ] Can I use multiple XTR devices if I have multiple DAC outputs or multiple sensors that share a supply and ground?

    Other Parts Discussed in Thread: ISO7340C , ISO7310C I have multiple sensors going into a DAC with multiple output channels. Can I use multiple XTR devices to transmit the 4-20mA current signals for each sensor?

  • [FAQ] Are there reference designs that can help me build a 4-20mA transmitter?

    Other Parts Discussed in Thread: XTR105 , XTR112 , XTR116 , XTR117 , XTR111 , XTR300 , XTR305 , DAC8771 , DAC8775 , DAC8760 Are there reference designs that can help me build a 4-20mA transmitter? Where can I find them? How do I incorporate IEC protection…

  • [FAQ] The minimum output current of my 2-wire 4-20mA transmitter is greater than 4mA.

    Other Parts Discussed in Thread: XTR116 The minimum output current of my 2-wire 4-20mA transmitter is greater than 4mA. Why is that? How can I lower it?

  • [FAQ] Can I use a 2-wire 4-20mA transmitter with a sensor or microcontroller that uses its own supply?

    Other Parts Discussed in Thread: ISO7340C , ISO7310C 2-wire 4-20mA transmitters are loop powered, and the sensor and its associated circuitry are supplied by the transmitter. Is it possible to use a sensor or microcontroller that uses a separate supply…

  • [FAQ] Why does my 2-wire 4-20mA transmitter output not reach the full 20mA?

    Why does my 2-wire 4-20mA transmitter output not reach the full 20mA? When I change the load resistance or decrease the supply, the output changes. What can I do to fix this?

  • [FAQ] Voltage scaling for almost any application (single ended)

    The technical article “ Three ways to scale an analog input ” only covered options for non-inverting and attenuating voltage scaling. Is there a voltage scaling solution for any single ended input range to a desired output range?

  • [FAQ] Automotive amplifiers: Is the LM2904B-Q1 a cross reference replacement for the LM2904-Q1?

    Part Number: LM2904-Q1 Other Parts Discussed in Thread: LM2904B-Q1 Hello, Can you explain why it would be better to use the newly released LM2904B-Q1 in place of the older LM2904-Q1 version when selecting an amplifier for my automotive system designs…

View FAQ threads