TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    TX7332EVM: Change TR Switch Clock Rate? 0 Locked

    439 views
    5 replies
    Latest over 5 years ago
    by Kevin Huang5
  • Suggested Answer

    DAC5689: DAC will not start. It is not converting 0 Locked

    335 views
    2 replies
    Latest over 5 years ago
    by Kang Hsia
  • Answered

    ADS131A02: Can we remove the STATUS data on DOUT? 0 Locked

    314 views
    1 reply
    Latest over 5 years ago
    by Joseph Wu
  • Not Answered

    ADS8684A: REFIO/REFCAP cap layout path 0 Locked

    377 views
    1 reply
    Latest over 5 years ago
    by Dale Li
  • Answered

    ADS1292R: Can this be used with dry electrodes? 0 Locked

    447 views
    1 reply
    Latest over 5 years ago
    by Alexander Smith
  • Answered

    ADS8638: VREF and AVDD connection 0 Locked

    289 views
    2 replies
    Latest over 5 years ago
    by Takahiro Saito
  • Answered

    AMC7812B: AMC7812B 0 Locked

    402 views
    4 replies
    Latest over 5 years ago
    by benny aberman
  • Answered

    ADS127L01: schematic request 0 Locked

    445 views
    5 replies
    Latest over 5 years ago
    by Tommy Tzeng
  • Suggested Answer

    ADS1298: lower input bias request for 24bit ADC 0 Locked

    322 views
    3 replies
    Latest over 5 years ago
    by Ben Kuo
  • Suggested Answer

    CCS/ADS1220: How can I get the CCS example code of ADS1220? 0 Locked

    358 views
    2 replies
    Latest over 5 years ago
    by Jaehoon Lee
  • Answered

    ADS1299: Wrong my data conversion 0 Locked

    497 views
    2 replies
    Latest over 5 years ago
    by Hidetaka Kudo
  • Suggested Answer

    ADS1299: Not sure if the internal reference is working properly 0 Locked

    247 views
    5 replies
    Latest over 5 years ago
    by Ryan Andrews
  • Answered

    DAC80501: Would this DAC work for 250Vdc supply that is adjustable from 5V – 250V @ 3kW, industrial power supply. 0 Locked

    386 views
    3 replies
    Latest over 5 years ago
    by Randhir Kalsi
  • Answered

    ADS1115: Actual/Total Noise 0 Locked

    302 views
    1 reply
    Latest over 5 years ago
    by Joseph Wu
  • Answered

    DAC8563: DAC8563 Breakout Communication Problem 0 Locked

    1563 views
    7 replies
    Latest over 5 years ago
    by tbatuhan
  • Suggested Answer

    ADS8688A: Junction temp 0 Locked

    185 views
    1 reply
    Latest over 5 years ago
    by Dale Li
  • Suggested Answer

    ADS1299EEGFE-PDK: Problem achieving the lower noise floor for this amplifier model 0 Locked

    616 views
    12 replies
    Latest over 5 years ago
    by Ryan Andrews
  • Suggested Answer

    AMC7834: Critical maximum ambient temperature 0 Locked

    215 views
    1 reply
    Latest over 5 years ago
    by Paul_Frost
  • Suggested Answer

    DAC121S101QML-SP: DAC121S101WGMPR 0 Locked

    267 views
    2 replies
    Latest over 5 years ago
    by Paul_Frost
  • Suggested Answer

    ADS1298: Usage with a TENS machine 0 Locked

    327 views
    1 reply
    Latest over 5 years ago
    by Alexander Smith
<>