TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    AMC131M03EVM: GUI support for Windows 11 0 Locked

    246 views
    1 reply
    Latest over 1 year ago
    by Saleh Ahmad
  • Not Answered

    ADS8355: Reference code for ADS8355 0 Locked

    254 views
    3 replies
    Latest over 1 year ago
    by Yolanda Gonzalez
  • Suggested Answer

    ADC081C027: I2C ADC with many addresses 0 Locked

    767 views
    3 replies
    Latest over 1 year ago
    by Joel Meraz
  • Suggested Answer

    DAC39RF10EVM: How to control LMX1204 in DAC39RF10EVM 0 Locked

    337 views
    3 replies
    Latest over 1 year ago
    by Matthew Kramer
  • Answered

    ADS1263EVM-PDK: Plug-in required 0 Locked

    448 views
    3 replies
    Latest over 1 year ago
    by Christopher Hall
  • Suggested Answer

    ADC3683EVM: Access to 20-bit mode GUI selection and bit deserialization using FCLK phase 0 Locked

    410 views
    3 replies
    Latest over 1 year ago
    by Drew Harrell
  • Not Answered

    ADC12DJ3200: adc12dj3200 0 Locked

    294 views
    2 replies
    Latest over 1 year ago
    by Eric Kleckner
  • Suggested Answer

    ADS131M08: How are the metrology-fir-table.c generated in ADCEnergyMetrologyLibrary SW_1.03? 0 Locked

    451 views
    4 replies
    Latest over 1 year ago
    by Dennis Lehman
  • Answered

    TLA2518: Lack of Channel Data when Appended 0 Locked

    498 views
    7 replies
    Latest over 1 year ago
    by Jason Gillies
  • Answered

    LM27313: Marking 0 Locked

    284 views
    1 reply
    Latest over 1 year ago
    by Lei Zhong
  • Suggested Answer

    AFE4960PEVM: Dual AFE 0 Locked

    449 views
    6 replies
    Latest over 1 year ago
    by Iasikha V
  • Answered

    AFE781H1: UART Break communication is not reliable 0 Locked

    317 views
    2 replies
    Latest over 1 year ago
    by Bhushan Khole
  • Answered

    AMC130M02: Method for converting single end into differential signal 0 Locked

    491 views
    2 replies
    Latest over 1 year ago
    by R.Fukunaga
  • Answered

    DAC3482: VCO frequency range 0 Locked

    273 views
    1 reply
    Latest over 1 year ago
    by Kang Hsia
  • Suggested Answer

    ADS4145: Register read value : address 4Ah 0 Locked

    457 views
    8 replies
    Latest over 1 year ago
    by Rob Reeder
  • Not Answered

    ADS131M08: START / STOP conversion of ADS131M08 0 Locked

    343 views
    3 replies
    Latest over 1 year ago
    by Joachim Wuerker
  • Not Answered

    DDC112: FAA number 0 Locked

    137 views
    0 replies
    Started over 1 year ago
    by yogesh th
  • Not Answered

    DDC112: share minimum range 0 Locked

    173 views
    0 replies
    Started over 1 year ago
    by yogesh th
  • Not Answered

    DDC112: count is not stable 0 Locked

    200 views
    0 replies
    Started over 1 year ago
    by yogesh th
  • Answered

    ADS1282: Calibration sequence clarification and SDATAC questions 0 Locked

    547 views
    6 replies
    Latest over 1 year ago
    by Keith Nicholas
<>