TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    ADS1115: Inaccurate readings at high voltages 0 Locked

    933 views
    3 replies
    Latest over 3 years ago
    by Aaron Estrada
  • Answered

    DAC8734: Issues reading the default values from the command register 0 Locked

    383 views
    3 replies
    Latest over 3 years ago
    by Heidelberg
  • Answered

    AFE5832LPEVM: HSDCPro automation dll licenses 0 Locked

    371 views
    2 replies
    Latest over 3 years ago
    by jim s
  • Suggested Answer

    ADS1263: Will ADS1262EVM-PDK support ADS1263? 0 Locked

    381 views
    4 replies
    Latest over 3 years ago
    by Bryan Lizon86
  • Answered

    ADS114S06: Single end input, data 0V to 3.3V with AVDD=3.3V 0 Locked

    478 views
    8 replies
    Latest over 3 years ago
    by Bryan Lizon86
  • Answered

    TSW12D1620EVM-CVAL: How to use trigger option for TSW12D1620EVM-CVAL and TSW14DL3200EVM hardware 0 Locked

    443 views
    3 replies
    Latest over 3 years ago
    by jim s
  • Answered

    AMC1305M05: Looking for ADC like a non-isolated equivalent to AMC1305M05 0 Locked

    268 views
    1 reply
    Latest over 3 years ago
    by Tom Hendrick
  • Answered

    DAC81404: Timing in Daisy Chain (Write only) ? 0 Locked

    250 views
    1 reply
    Latest over 3 years ago
    by Katlynne Jones
  • Suggested Answer

    DAC81416: DAC 81416 coding problem- sclk and cs 0 Locked

    390 views
    1 reply
    Latest over 3 years ago
    by Katlynne Jones
  • Suggested Answer

    ADS1114: EVM Usage 0 Locked

    478 views
    11 replies
    Latest over 3 years ago
    by Aaron Estrada
  • Suggested Answer

    ADS1298R: Respiration Circuit MISMATCH in TI several documents 0 Locked

    487 views
    1 reply
    Latest over 3 years ago
    by ChienChun Yang
  • Answered

    ADS8167: Noise on internal reference, and on REFby2 0 Locked

    306 views
    5 replies
    Latest over 3 years ago
    by Chip Weller
  • Suggested Answer

    ADS54J40: ADS54J40 : ADC analog input schematic 0 Locked

    392 views
    7 replies
    Latest over 3 years ago
    by Sima Jalaleddine
  • Answered

    BP-DAC11001EVM: How can I get EXP432E401Y code? ( project document , co-work with DAC11001EVM ) 0 Locked

    582 views
    4 replies
    Latest over 3 years ago
    by meriton
  • Answered

    ADS7883: About Min value of SCLK 0 Locked

    272 views
    2 replies
    Latest over 3 years ago
    by Hide
  • Answered

    AMC7836EVM: Clamp oupput load current 0 Locked

    465 views
    7 replies
    Latest over 3 years ago
    by ?? ?
  • Answered

    ADS131M08: The smallest measurable voltage value? 0 Locked

    693 views
    4 replies
    Latest over 3 years ago
    by kwon
  • Answered

    AFE4960P: Use DC lead off detection to wake up whole system 0 Locked

    291 views
    2 replies
    Latest over 3 years ago
    by Michael Li
  • Answered

    ADC128S102: Seeing the correct ADC output from the previous read - looks like data is coming out of the ADC the next conversion 0 Locked

    220 views
    1 reply
    Latest over 3 years ago
    by Keith Nicholas
  • Answered

    ADC3663: FCLK error in DDC bypass 0 Locked

    699 views
    12 replies
    Latest over 3 years ago
    by Chase W
<>