TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DP83867CR: How to generate recovered clock using DP83867?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867CR To generate clock in sync with the link-partner (recovered clock of 125MHz or 25MHz) on the CLKOUT pin of DP83867 : program register 0x0170[12:8] = 00000 for 125MHz program register 0x0170[12:8] = 00100 for 25MHz Note…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] ESD and TVS Protection Devices: All Technical Documentation

    Chris Murphy
    Chris Murphy
    Application Notes Protecting Automotive Can Bus Systems from ESD Overvoltage Events ESD and Surge Protection for USB Interfaces Automotive SerDes ESD Protection MSP430 System-Level ESD Considerations (Rev. B)…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: Can we use a transformer instead of Capacitor for AC coupling on the MDI side for DP83TD510?

    Hillman Lin
    Hillman Lin
    Part Number: DP83TD510E Yes, transformer can be used for filtering out the DC signal when the data is passing through the MDI side. In fact, we use transformer to filter out the AC signal in the Power over Data Line (PoDL) application. Here are the…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] What is the difference between RMII slave signaling and RMII master signaling?

    Hillman Lin
    Hillman Lin
    RMII slave signaling is connecting 50MHz Crystal to two XI pin of the PHY and/or MAC RMII master signaling is connection 25MHz Crystal to one Master and provide a 50MHz reference lock through REF_CLK pin to the XI pin of the slave side. Slave side does…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812R-Q1: How can I connect PHYs back to back over RMII?

    Hillman Lin
    Hillman Lin
    Part Number: DP83TC812R-Q1 There are two type of mode that RMII can support: RMII normal mode and RMII Repeater mode: RMII normal mode is also known as MAC to PHY RMII connection. This mode is set as default mode in DP83TC812 so it did not need…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC811S-Q1: Why is Slave/Managed mode PHY linking up with Master/Autonomous PHY link partner?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83TC811S-Q1 Other Parts Discussed in Thread: DP83TC811R-Q1 When using DP83TC811S-Q1 (or DP83TC811R-Q1), and setting the PHY into managed mode as a slave device via bootstrapping settings, if this device is connected to a master link partner…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH949-Q1: Disable HDCP to work with UB Deserializer

    Alex Reid1
    Alex Reid1
    Part Number: DS90UH949-Q1 Hello, My customer would like to use DS90 UH949 -Q1 devices in place of the DS90 UB949A -Q1 to keep production running. In reviewing the details they have the following questions. Can the HDCP function be disabled? If…
    • Answered
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] Why am I getting "clause-45 not supported" and "error-95" errors with PHY drivers?

    Vikram Sharma
    Vikram Sharma
    Possible reason can be : - "phy_read_mmd" and "phy_write_mmd" are not supported in your kernel version (if version is old). Possible solution to be evaluated : - Change "phy_write_mmd" to "phy_write_mmd_indirect" function and do the corresponding…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UB960-Q1: BIST Duration

    ReedKacz
    ReedKacz
    Part Number: DS90UB960-Q1 Hi Team, What is the recommended duration to run the BIST? Thanks Reed
    • Answered
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] How to select correct RGMII delay mode for PHY and MAC?

    Vikram Sharma
    Vikram Sharma
    RGMII standard asks for the introduction of delay in the clock (RX_CLK/TX_CLK) with respect to the respective data (RX_D*/RX_CTRL or TX_D*/TX_CTRL). This delay can be introduced at the source of the clock or at the receiver side. Following table should…
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    eMMC 5.0 CID read 0 Locked

    737 views
    2 replies
    Latest over 5 years ago
    by Thomas Hecht
  • Answered

    TPS65988: Mosfet switch control 0 Locked

    439 views
    3 replies
    Latest over 5 years ago
    by Prajith Cheerakkoda
  • Answered

    TPS65988: Power Role Swap 0 Locked

    693 views
    3 replies
    Latest over 5 years ago
    by Prajith Cheerakkoda
  • Answered

    TPS65988: Total FRS implementation time 0 Locked

    580 views
    5 replies
    Latest over 5 years ago
    by Prajith Cheerakkoda
  • Suggested Answer

    TPS65982: No USB 2.0 in 4-lane DP mode 0 Locked

    312 views
    5 replies
    Latest over 5 years ago
    by Eriks Austrums
  • Not Answered

    DP83822EVM: Problems configuring the PHY in RMII Mode 0 Locked

    892 views
    12 replies
    Latest over 5 years ago
    by Cecilia Reyes
  • Suggested Answer

    PCA9306: About use for HDMI DDC bus 0 Locked

    348 views
    1 reply
    Latest over 5 years ago
    by BOBBY
  • Answered

    TPS65986: PP_5V Current limit setting 0 Locked

    361 views
    2 replies
    Latest over 5 years ago
    by Hari Patel1
  • Suggested Answer

    DS90UB953-Q1: Please review schematic 0 Locked

    210 views
    2 replies
    Latest over 5 years ago
    by Jiashow Ho
  • Not Answered

    DP83TC811R-Q1: Number of Vias 0 Locked

    148 views
    6 replies
    Latest over 5 years ago
    by Cecilia Reyes
  • Not Answered

    Looking for an IC with I2C port to communicate with Li-ion battery RRC2054-2 (digital interface for this battery) 0 Locked

    489 views
    1 reply
    Latest over 5 years ago
    by JD Crutchfield
  • Answered

    SN65HVD75: Schematic review 0 Locked

    3246 views
    8 replies
    Latest over 5 years ago
    by Hao L
  • Not Answered

    TUSB8041-Q1: USB Hub Throughput performance of TUSB8041 vs TUSB8042 0 Locked

    495 views
    3 replies
    Latest over 5 years ago
    by JMMN
  • Suggested Answer

    SN65HVD3082E: mvb solution 0 Locked

    479 views
    1 reply
    Latest over 5 years ago
    by Hao L
  • Answered

    TPS65987D: Switch between sink and source while external power is still present 0 Locked

    860 views
    5 replies
    Latest over 5 years ago
    by Tom Siegel
  • Not Answered

    TLK105: Periodic power-up prolems. 0 Locked

    213 views
    1 reply
    Latest over 5 years ago
    by Aniruddha Khadye
  • Suggested Answer

    DP83867ERGZ-R-EVM: DP83867 0 Locked

    350 views
    1 reply
    Latest over 5 years ago
    by Aniruddha Khadye
  • Suggested Answer

    Quote# QB9B7B4 - Ethernet PHY/Transceiver for CPU with RGMII interface supporting up to 1000Mb/s 0 Locked

    383 views
    1 reply
    Latest over 5 years ago
    by Aniruddha Khadye
  • Answered

    TPS65987D: Power Duo mode not available in GUI 0 Locked

    311 views
    1 reply
    Latest over 5 years ago
    by Darren Jenkins
  • Answered

    LMH1228: Manual setting of EQ strength in simulation of IBIS AMI model 0 Locked

    313 views
    1 reply
    Latest over 5 years ago
    by Nasser Mohammadi
<>