TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS280DF810: Can I use a signal conditioning device at a lower data rate than its target application?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Other Parts Discussed in Thread: DS160PR410 , A common question when using a signal conditioning device is can the device support a data rate that is lower than the target data rate. The answer to this is device dependent, but…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Debug procedure if TI TUSB80xx or TUSB40xx hub can not be detected by USB host

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A 1: Check power on reset sequence waveform for 3.3v ,1/1v and GRSTz pin and see if it meets hub power on reset sequence timing 2: Check voltage on USB_VBUS pin and see if the voltage is around 0.5v 3: Check if the crystal is…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TMUXHS4212: When and how to AC coupling the passive MUX?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: TMUXHS4212 When and how do I place the AC coupling capacitors for the passive MUX?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: Does redriver power consumption vary with data rate?

    Evan Su
    Evan Su
    Part Number: DS320PR810 Other Parts Discussed in Thread: DS160PR421 , DS160PR1601 , DS160PR410 , DS160PR810 , DS160PR412 , , DS320PR1601 , DS320PR410 , SN75LVPE5412 , SN75LVPE5421 Applicable to all TI PCIe redrivers for Gen 4: DS160PR410, DS160PR810…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Difference between TUSB804x USB3 hub family

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A Other Parts Discussed in Thread: TUSB8041 , , TUSB8042A , TUSB8043A , TUSB8044A Over the time, TI TUSB804x USB3 hub family has been transitioned from USB3.0 to USB3.1, from TUSB8041 to TUSB8041A/8042A/8043A/8044A. Here is the…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to enable snoop mode with HDMI re-driver/re-timer

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Brief Overview of HDMI PHY: The HDMI physical layer is composed of 4 high-speed lanes, one Display Data Channel (DDC) which operates with I2C signaling, Hot Plug Detect (HPD) for device detection, Consumer Electronic Control …
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS560DF810: Explanation of Crosspoint and Gearbox Modes

    Lucas Wolter
    Lucas Wolter
    Part Number: DS560DF810 Other Parts Discussed in Thread: DS560DF410 , DS560DF810 and DS560DF410 offer a variety of crosspoint and gearbox modes which can be used for 1:2 fanout, channel crossing, and NRZ/PAM4 modulation conversion. In this thread, I will…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR1601: Receiver Detect Reset for x2 SSD Hot Plug Applications

    Nick Peabody
    Nick Peabody
    Part Number: DS320PR1601 Other Parts Discussed in Thread: DS320PR810 In this E2E FAQ, I am going to provide an overview of RX detect with specific information on the RX detect pulse width and frequency, then, I am going to discuss hot plug functionality…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Linear vs. Limited Mode in Redrivers

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 Linear Mode: In linear mode the data received from the GPU’s transmitter is the data that will be sent out of the TX end of the redriver. This means that the GPU’s voltage swing, pre-emphasis…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB216I: How do you create a system with a 10 meter passive cable using a USB2 redriver?

    Ryan Kitto
    Ryan Kitto
    Part Number: TUSB216I Other Parts Discussed in Thread: TUSB217A , TUSB216-Q1 , , TUSB216 , TUSB211A I want to create a system that can support USB2 while utilizing a 10 meter passive cable. Which redriver(s) should I use, and how should they be configured…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    SN65LVDS349: Do TI has one replacement for ON's MC10H116, when used in Fiber optic HFBR-25X6 circuit. 0 Locked

    1841 views
    1 reply
    Latest over 7 years ago
    by Yaser Ibrahim
  • Suggested Answer

    TUSB3410: TUSB3410 Driver Source Code 0 Locked

    387 views
    1 reply
    Latest over 7 years ago
    by Brian Quach
  • Suggested Answer

    TCA6408A: High Level at the condition of "High than 3V" 0 Locked

    460 views
    3 replies
    Latest over 7 years ago
    by Miguel Robertson
  • Suggested Answer

    TPD4S014: TPD4S014 ACK behavior on VBUS removal 0 Locked

    1885 views
    11 replies
    Latest over 7 years ago
    by Chuck Branch
  • Suggested Answer

    ISO5452: Is ISO5452 PIN2PIN of ADuM4135? 0 Locked

    841 views
    4 replies
    Latest over 7 years ago
    by Mamadou Diallo
  • Suggested Answer

    HD3SS215: followed by a SN75DP130 0 Locked

    486 views
    2 replies
    Latest over 7 years ago
    by vincent himpe
  • Suggested Answer

    LMH0303: SDI jitter issue with vertical transition jumping 0 Locked

    916 views
    1 reply
    Latest over 7 years ago
    by Nasser Mohammadi
  • Answered

    DS80PCI402: DS80PCI402 Smbus EEPROM Access 0 Locked

    560 views
    3 replies
    Latest over 7 years ago
    by Lee Sledjeski
  • Answered

    TPS65981: No USB2.0 Data on RP Bus 0 Locked

    466 views
    3 replies
    Latest over 7 years ago
    by Eric Beljaars
  • Answered

    TMDS181: VSADJ pin function at IBIS-AMI model 0 Locked

    448 views
    2 replies
    Latest over 7 years ago
    by David (ASIC) Liu
  • Answered

    TMDS181: VotingThreshold and SettlingTime in IBIS-AMI Models user's guide 0 Locked

    394 views
    2 replies
    Latest over 7 years ago
    by David (ASIC) Liu
  • Answered

    DS90CR286A: RSKM at f=56MHz (DS90CR286A, DS90CR288A) 0 Locked

    909 views
    5 replies
    Latest over 7 years ago
    by KAEDE KUDO
  • Answered

    TPS25740: Simplest way to accomplish USB C PD and USB 3.1 host 0 Locked

    521 views
    3 replies
    Latest over 7 years ago
    by Bengt Karlsson
  • Answered

    SN65DP159: SN65DP159 EyeScan Tool Supported USB-to-I2C Adapters 0 Locked

    611 views
    3 replies
    Latest over 7 years ago
    by JMMN
  • Answered

    SN75DP126: Reference schematic for SN75DP126 0 Locked

    827 views
    2 replies
    Latest over 7 years ago
    by Roger Wang
  • Suggested Answer

    DS90UB948-Q1: Abnormal displaying using DS90UB949/948 0 Locked

    375 views
    1 reply
    Latest over 7 years ago
    by Steven(Shenzhen) Shi
  • Answered

    DS80PCI102: Auto RX-detect 0 Locked

    390 views
    2 replies
    Latest over 7 years ago
    by NAOKI AOYAMA
  • Answered

    DS125BR111: Signal Detect function 0 Locked

    388 views
    2 replies
    Latest over 7 years ago
    by NAOKI AOYAMA
  • Suggested Answer

    DS90UB953-Q1: EMI issues with 954/953 at 1.6Ghz and above with external refrence clock 0 Locked

    545 views
    1 reply
    Latest over 7 years ago
    by Liam Keese
  • Answered

    TB5T1: Reference design documents 0 Locked

    268 views
    1 reply
    Latest over 7 years ago
    by Yaser Ibrahim
<>