TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DP83867CR: How to generate recovered clock using DP83867?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867CR To generate clock in sync with the link-partner (recovered clock of 125MHz or 25MHz) on the CLKOUT pin of DP83867 : program register 0x0170[12:8] = 00000 for 125MHz program register 0x0170[12:8] = 00100 for 25MHz Note…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] ESD and TVS Protection Devices: All Technical Documentation

    Chris Murphy
    Chris Murphy
    Application Notes Protecting Automotive Can Bus Systems from ESD Overvoltage Events ESD and Surge Protection for USB Interfaces Automotive SerDes ESD Protection MSP430 System-Level ESD Considerations (Rev. B)…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: Can we use a transformer instead of Capacitor for AC coupling on the MDI side for DP83TD510?

    Hillman Lin
    Hillman Lin
    Part Number: DP83TD510E Yes, transformer can be used for filtering out the DC signal when the data is passing through the MDI side. In fact, we use transformer to filter out the AC signal in the Power over Data Line (PoDL) application. Here are the…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] What is the difference between RMII slave signaling and RMII master signaling?

    Hillman Lin
    Hillman Lin
    RMII slave signaling is connecting 50MHz Crystal to two XI pin of the PHY and/or MAC RMII master signaling is connection 25MHz Crystal to one Master and provide a 50MHz reference lock through REF_CLK pin to the XI pin of the slave side. Slave side does…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812R-Q1: How can I connect PHYs back to back over RMII?

    Hillman Lin
    Hillman Lin
    Part Number: DP83TC812R-Q1 There are two type of mode that RMII can support: RMII normal mode and RMII Repeater mode: RMII normal mode is also known as MAC to PHY RMII connection. This mode is set as default mode in DP83TC812 so it did not need…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC811S-Q1: Why is Slave/Managed mode PHY linking up with Master/Autonomous PHY link partner?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83TC811S-Q1 Other Parts Discussed in Thread: DP83TC811R-Q1 When using DP83TC811S-Q1 (or DP83TC811R-Q1), and setting the PHY into managed mode as a slave device via bootstrapping settings, if this device is connected to a master link partner…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH949-Q1: Disable HDCP to work with UB Deserializer

    Alex Reid1
    Alex Reid1
    Part Number: DS90UH949-Q1 Hello, My customer would like to use DS90 UH949 -Q1 devices in place of the DS90 UB949A -Q1 to keep production running. In reviewing the details they have the following questions. Can the HDCP function be disabled? If…
    • Answered
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] Why am I getting "clause-45 not supported" and "error-95" errors with PHY drivers?

    Vikram Sharma
    Vikram Sharma
    Possible reason can be : - "phy_read_mmd" and "phy_write_mmd" are not supported in your kernel version (if version is old). Possible solution to be evaluated : - Change "phy_write_mmd" to "phy_write_mmd_indirect" function and do the corresponding…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UB960-Q1: BIST Duration

    ReedKacz
    ReedKacz
    Part Number: DS90UB960-Q1 Hi Team, What is the recommended duration to run the BIST? Thanks Reed
    • Answered
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] How to select correct RGMII delay mode for PHY and MAC?

    Vikram Sharma
    Vikram Sharma
    RGMII standard asks for the introduction of delay in the clock (RX_CLK/TX_CLK) with respect to the respective data (RX_D*/RX_CTRL or TX_D*/TX_CTRL). This delay can be introduced at the source of the clock or at the receiver side. Following table should…
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TCAN1051-Q1: Our CAN driver(e.g. TCAN1051-Q1) is voltage mode or current mode driver? 0 Locked

    335 views
    4 replies
    Latest over 2 years ago
    by Danny Bacic
  • Suggested Answer

    TCA9543A: TCA9543APWR 0 Locked

    203 views
    2 replies
    Latest over 2 years ago
    by Jack Guan
  • Suggested Answer

    SN75DP149: SN7149 incompatibility problem 0 Locked

    331 views
    6 replies
    Latest over 2 years ago
    by David (ASIC) Liu
  • Answered

    DS90UR916Q-Q1: Can it replace DS90UR906Q without hardware and software change? 0 Locked

    192 views
    1 reply
    Latest over 2 years ago
    by Ryan Kitto
  • Answered

    DP83867IR: DP83867IR: power sequence 0 Locked

    409 views
    5 replies
    Latest over 2 years ago
    by Rahul
  • Suggested Answer

    TFP410: Recommendations for functional devices with the same industrial temperature range 0 Locked

    260 views
    3 replies
    Latest over 2 years ago
    by David (ASIC) Liu
  • Suggested Answer

    SN65DP159: input rise time 0 Locked

    201 views
    5 replies
    Latest over 2 years ago
    by David (ASIC) Liu
  • Not Answered

    DS90UB929-Q1: I2C communication problem 0 Locked

    772 views
    13 replies
    Latest over 2 years ago
    by Ben Dattilo
  • Answered

    TPIC8101EVM: TPIC8101EVM doesn't work fine 0 Locked

    463 views
    10 replies
    Latest over 2 years ago
    by argini fabrizio
  • Suggested Answer

    SN65HVD10: SN65HVD10 isolation between two modules 0 Locked

    324 views
    3 replies
    Latest over 2 years ago
    by Vikas Jeevannavar
  • Answered

    DP83867CS: About 1000BASE-T JITTER test 0 Locked

    394 views
    1 reply
    Latest over 2 years ago
    by Gokul Koraganji
  • Suggested Answer

    TUSB321AI: Need schematic verification for USB 3.1 Type-C circuit. 0 Locked

    510 views
    6 replies
    Latest over 2 years ago
    by Brian Zhou
  • Suggested Answer

    TCA9802: TCA9802 leakage current problem 0 Locked

    481 views
    3 replies
    Latest over 2 years ago
    by Tyler Townsend
  • Suggested Answer

    SN75DPHY440SS: Questions of SN75DPHY440SS 0 Locked

    185 views
    1 reply
    Latest over 2 years ago
    by David (ASIC) Liu
  • Not Answered

    TCAN1145-Q1: tcan1145 FRAME_OVF wake up and fail mode problem 0 Locked

    237 views
    1 reply
    Latest over 2 years ago
    by Eric Schott1
  • Answered

    TUSB2046I: Review of Design 0 Locked

    398 views
    9 replies
    Latest over 2 years ago
    by Alan Varghese
  • Suggested Answer

    TUSB212: Baking temp and time 0 Locked

    208 views
    1 reply
    Latest over 2 years ago
    by Josh Baik
  • Answered

    SN65DSI86: replacement LT9711 0 Locked

    463 views
    1 reply
    Latest over 2 years ago
    by David (ASIC) Liu
  • Answered

    TLK10232: TLK10232CTR Linux Drivers availability --- 0 Locked

    359 views
    3 replies
    Latest over 2 years ago
    by Nasser Mohammadi
  • Answered

    Interface forum 0 Locked

    326 views
    3 replies
    Latest over 2 years ago
    by weilun luo
<>