TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] Interface Protection Guides

    Josh Prushing
    Josh Prushing
    Back to FAQ Home Page Interface Protection Guides Part Recommendation Packaging & Layout Models Transient Standards System/Device Level Design Power Dissipation and Temperature Top Threads …
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] SN75DPHY440SS: Is it okay to swap the polarity and lane order?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: SN75DPHY440SS My customer asked about changing positive signal and negative signal. (i.e. applying positive input to DA0N, negative input to DA0P, positive input to DA1N, negative signal to DA1P, and so on.) Is it okay to use this device…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS280DF810: Can I use a signal conditioning device at a lower data rate than its target application?

    Drew Miller1
    Drew Miller1
    Part Number: DS280DF810 Other Parts Discussed in Thread: DS160PR410 , A common question when using a signal conditioning device is can the device support a data rate that is lower than the target data rate. The answer to this is device dependent, but…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Debug procedure if TI TUSB80xx or TUSB40xx hub can not be detected by USB host

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A 1: Check power on reset sequence waveform for 3.3v ,1/1v and GRSTz pin and see if it meets hub power on reset sequence timing 2: Check voltage on USB_VBUS pin and see if the voltage is around 0.5v 3: Check if the crystal is…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TMUXHS4212: When and how to AC coupling the passive MUX?

    David (ASIC) Liu
    David (ASIC) Liu
    Part Number: TMUXHS4212 When and how do I place the AC coupling capacitors for the passive MUX?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: Does redriver power consumption vary with data rate?

    Evan Su
    Evan Su
    Part Number: DS320PR810 Other Parts Discussed in Thread: DS160PR421 , DS160PR1601 , DS160PR410 , DS160PR810 , DS160PR412 , , DS320PR1601 , DS320PR410 , SN75LVPE5412 , SN75LVPE5421 Applicable to all TI PCIe redrivers for Gen 4: DS160PR410, DS160PR810…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB8041A: Difference between TUSB804x USB3 hub family

    Brian Zhou
    Brian Zhou
    Part Number: TUSB8041A Other Parts Discussed in Thread: TUSB8041 , , TUSB8042A , TUSB8043A , TUSB8044A Over the time, TI TUSB804x USB3 hub family has been transitioned from USB3.0 to USB3.1, from TUSB8041 to TUSB8041A/8042A/8043A/8044A. Here is the…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to enable snoop mode with HDMI re-driver/re-timer

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Brief Overview of HDMI PHY: The HDMI physical layer is composed of 4 high-speed lanes, one Display Data Channel (DDC) which operates with I2C signaling, Hot Plug Detect (HPD) for device detection, Consumer Electronic Control …
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS560DF810: Explanation of Crosspoint and Gearbox Modes

    Lucas Wolter
    Lucas Wolter
    Part Number: DS560DF810 Other Parts Discussed in Thread: DS560DF410 , DS560DF810 and DS560DF410 offer a variety of crosspoint and gearbox modes which can be used for 1:2 fanout, channel crossing, and NRZ/PAM4 modulation conversion. In this thread, I will…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR1601: Receiver Detect Reset for x2 SSD Hot Plug Applications

    Nick Peabody
    Nick Peabody
    Part Number: DS320PR1601 Other Parts Discussed in Thread: DS320PR810 In this E2E FAQ, I am going to provide an overview of RX detect with specific information on the RX detect pulse width and frequency, then, I am going to discuss hot plug functionality…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    SN65LVCP204 and SFP Gigabit Transceiver 0 Locked

    862 views
    1 reply
    Latest over 9 years ago
    by Moises Garcia
  • Answered

    ONET1151l I2C read 0 Locked

    820 views
    1 reply
    Latest over 9 years ago
    by Barry W
  • Answered

    DP83848 with MII-Lite (to connect with MPC5748G) 0 Locked

    2358 views
    1 reply
    Latest over 9 years ago
    by Patrick OFarrell
  • Answered

    dp83849 configuration 0 Locked

    1515 views
    10 replies
    Latest over 9 years ago
    by Patrick OFarrell
  • Answered

    LMH1218 - EVM Schematic, R35 on VDD (pin 21) 0 Locked

    614 views
    2 replies
    Latest over 9 years ago
    by Kawai
  • Answered

    LMH1218 - EVM schematic, cap between pin 17-18 0 Locked

    638 views
    2 replies
    Latest over 9 years ago
    by Kawai
  • Not Answered

    XIO2001 initialization problem 0 Locked

    1108 views
    3 replies
    Latest over 9 years ago
    by Joel V
  • Not Answered

    about TLK1221 DK 0 Locked

    940 views
    4 replies
    Latest over 9 years ago
    by Seyong Han
  • Suggested Answer

    USB Type-C CC Pin Logic 0 Locked

    857 views
    1 reply
    Latest over 9 years ago
    by Diego Cortes
  • Answered

    DP130 EQ setting 0 Locked

    733 views
    3 replies
    Latest over 9 years ago
    by Moises Garcia
  • Answered

    TCA9535 / Delta Icc 0 Locked

    778 views
    3 replies
    Latest over 9 years ago
    by Siby James
  • Suggested Answer

    IBIS Model Required : TUSB211IRWBR 0 Locked

    709 views
    1 reply
    Latest over 9 years ago
    by Diego Cortes
  • Suggested Answer

    PCA9306 driving current 0 Locked

    432 views
    1 reply
    Latest over 9 years ago
    by Jonathan Valdez
  • Not Answered

    DS125DF111EVM Gerbers 0 Locked

    681 views
    2 replies
    Latest over 9 years ago
    by Scott Hooper
  • Answered

    SN65HVD3082E baud rate issue 0 Locked

    1077 views
    4 replies
    Latest over 9 years ago
    by Pradhan Rivankar
  • Answered

    TMDS181 Power On/Off Sequence 0 Locked

    1631 views
    6 replies
    Latest over 9 years ago
    by Sadanori Kato
  • Answered

    Who can kindly provide 10Gb/s Line drive buffer TLK1102E ibis & Hspice model? 0 Locked

    653 views
    1 reply
    Latest over 9 years ago
    by Luis Omar Moran
  • Not Answered

    USB charger IC selection 0 Locked

    1120 views
    3 replies
    Latest over 9 years ago
    by Patrick Zeng
  • Answered

    TMDS181 VIL and VIH Parameter for SCL_SRC and SDA_SRC 0 Locked

    937 views
    4 replies
    Latest over 9 years ago
    by Sadanori Kato
  • Answered

    RMII with DP83848 0 Locked

    3442 views
    9 replies
    Latest over 9 years ago
    by Patrick OFarrell
<>