TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS250DF410: How to setup PRBS pattern generation/checker using divide by 2, 4, or 8 clock

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: DS250DF410 Other Parts Discussed in Thread: SIGCONARCHITECT Using a simple clock, DS250DFxxx and DS280DFxxx can generate different prbs patterns at different data rate up to 28Gbps. To make it very simple, SigconArchitect can be used to achieve…
    • Answered
    • over 7 years ago
    • Interface
    • Interface forum
  • [FAQ] PCA9306: Voltage levels translation

    Simon Arthur
    Simon Arthur
    Part Number: PCA9306 To allow proper translation of I2C signals from one voltage reference to another, both the high-level and low-level voltage thresholds need to be translated. However, these threshold voltages are not mentioned in the datasheet of…
    • Answered
    • over 9 years ago
    • Interface
    • Interface forum
<

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TPS65983B: TPS65983 TID 0 Locked

    645 views
    9 replies
    Latest over 3 years ago
    by Ghouse Mohiuddin23
  • Suggested Answer

    TPD6S300: Waveform during OVP to recovery 0 Locked

    374 views
    3 replies
    Latest over 3 years ago
    by Ghouse Mohiuddin23
  • Suggested Answer

    TLK10022: What to do with unused in and outputs 0 Locked

    347 views
    1 reply
    Latest over 3 years ago
    by Drew Miller1
  • Not Answered

    DP83867E: Link Down when configured in 1000Mbps, full duplex mode and auto negotiation disabled 0 Locked

    422 views
    1 reply
    Latest over 3 years ago
    by David Creger
  • Not Answered

    DP83TG720S-Q1: Pin compatible design for DP83TG720S-Q1 0 Locked

    286 views
    1 reply
    Latest over 3 years ago
    by David Creger
  • Not Answered

    DP83TC811S-Q1: 1.During the debugging, we found that the 25Mhz crystal oscillator would start to vibrate for a period of time after power-on, but it would stop later. I don't know what is the cause? The chip goes into low power mode? 0 Locked

    242 views
    1 reply
    Latest over 3 years ago
    by David Creger
  • Not Answered

    DP83TC811S-Q1: The RX-CLK sent by the PHY to the MAC will catch the 84Mhz waveform when it is powered on, and the 84Mhz frequency feels abnormal 0 Locked

    497 views
    1 reply
    Latest over 3 years ago
    by David Creger
  • Suggested Answer

    Part recommendation - Level translator 5V to 1.8V 0 Locked

    358 views
    6 replies
    Latest over 3 years ago
    by Yuan Rao
  • Answered

    DS125DF410: Duty cycle of REF CLK consult 0 Locked

    384 views
    5 replies
    Latest over 3 years ago
    by Drew Miller1
  • Answered

    DS125DF1610: Programming guide 0 Locked

    290 views
    1 reply
    Latest over 3 years ago
    by Drew Miller1
  • Suggested Answer

    TFP401PZPEVM: When no HDMI signal - ODCK problem 0 Locked

    522 views
    4 replies
    Latest over 3 years ago
    by David (ASIC) Liu
  • Suggested Answer

    SN65LVDS100: SN65LVDS100DGK NC PIN 0 Locked

    293 views
    1 reply
    Latest over 3 years ago
    by David (ASIC) Liu
  • Suggested Answer

    SN65DSI83: SN65DSI83 0 Locked

    382 views
    1 reply
    Latest over 3 years ago
    by David (ASIC) Liu
  • Not Answered

    IO-EXPANDER-EVM: Setup IO-Expander-EVM without MSP430 0 Locked

    884 views
    3 replies
    Latest over 3 years ago
    by BOBBY
  • Suggested Answer

    SN65DSI83-Q1: Timing variation of LVDS output 0 Locked

    1858 views
    25 replies
    Latest over 3 years ago
    by David (ASIC) Liu
  • Answered

    DP83869HM: Recommended layout infomration for 1000base-X 0 Locked

    355 views
    5 replies
    Latest over 3 years ago
    by David Creger
  • Not Answered

    Magnetics Requirement 0 Locked

    211 views
    5 replies
    Latest over 3 years ago
    by David Creger
  • Answered

    DP83825I: Power up sequence 0 Locked

    1003 views
    6 replies
    Latest over 3 years ago
    by David Creger
  • Answered

    DP83TG720R Sleep mode 0 Locked

    1851 views
    22 replies
    Latest over 3 years ago
    by Gerome Cacho
  • Suggested Answer

    THVD1510: Marking + Frame 0 Locked

    306 views
    1 reply
    Latest over 3 years ago
    by Danny Bacic
<>