TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to read and write Ethernet PHY registers using a Linux terminal?

    David Creger
    David Creger
    There are several different tools available in a Linux environment to read and write registers on a TI PHY. Several of these options are listed below. MII read: This is the only command which can and must be used in U-boot. Stop the autoboot process…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: How to disable 25MHz clock on clkout pin?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TC812S-Q1 For DP83TC812S/R and DP83TC814-Q1 if clkout pin is not being used to provide a clock signal to another component, then it is recommended to shut down this clock output and reduce its impact on EM emissions. Clkout's output…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Which conformal coating is recommended for Ethernet PHY products?

    Vikram Sharma
    Vikram Sharma
    TI does not have a recommendation for any specific conformal coat or underfill product. In some temperature ranges these materials can be detrimental if the conformal coating or underfill product has a mismatched CTE vs. solder joint (Z axis). This…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: How to test the link-quality using DP83867's BIST and status registers?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867IR DP83867 PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These parameters…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: How to check throughput without depending upon MAC?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TD510E DP83TD510E PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How do I choose magnetics for my industrial PHY?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E There are 5 key parameters to look out for when selecting magnetics: Magnetic type (specifically for integrated RJ-45/Magnetic component) Can the recommended MDI configuration still be met with this component? Turns…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TLK2711-SP: Eye Mask Recommendations

    Drew Miller1
    Drew Miller1
    Part Number: TLK2711-SP There have been some questions regarding the TLK2711-SP eye mask related to the following E2E thread, so I am hoping to clarify them in this post. TLK2711-SP: Is there an EYE diagram mask definition available? - Space & High…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH941AS-Q1: How to configure FPD-Link III 94x audio

    Ryan Fleetham
    Ryan Fleetham
    Part Number: DS90UH941AS-Q1 How do I configure audio for FPD-Link III 94x devices?
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: In enhanced mode, how does DP83826 strapping work?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E When configuring DP83826 in Enhanced Mode, please consult the following flowchart to understand how the different strap pins configure the PHY into various modes.
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: How to read or write registers in extended register space of Ethernet PHY?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TG720S-Q1 write procedure for MMD "1F" registers: write reg<000D> = 0x001F write reg<000E> = <address> write reg<000D> = 0x401F write reg<000E> = <value> read procedure for MMD "1F" registers: write reg<000D> = 0x001F …
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    TCAN4550: TCAN4550 write register unable to enter normal mode 0 Locked

    236 views
    1 reply
    Latest over 3 years ago
    by Eric Schott1
  • Suggested Answer

    TCAN1145-Q1: Detection of "TXD Dominant Time Out" by software 0 Locked

    298 views
    1 reply
    Latest over 3 years ago
    by Eric Schott1
  • Answered

    TCA9803: THERMAL MODEL 0 Locked

    269 views
    5 replies
    Latest over 3 years ago
    by Eric Hackett
  • Answered

    TCAN1145-Q1: Tolerance to 8Mbps CAN FD frames in passive mode 0 Locked

    447 views
    3 replies
    Latest over 3 years ago
    by Eric Schott1
  • Not Answered

    TFP401A: How to set the resolution and screen parameters 0 Locked

    158 views
    1 reply
    Latest over 3 years ago
    by David (ASIC) Liu
  • Suggested Answer

    TIC10024-Q1: Why do we need wetting current control? 0 Locked

    1018 views
    1 reply
    Latest over 3 years ago
    by Danny Bacic
  • Suggested Answer

    MAX3232-EP: thermal resistance 0 Locked

    393 views
    5 replies
    Latest over 3 years ago
    by Eric Hackett
  • Suggested Answer

    SN65LVDS4: Lead Frame Plating Thickness 0 Locked

    153 views
    1 reply
    Latest over 3 years ago
    by David (ASIC) Liu
  • Suggested Answer

    TMUXHS4212: open short Test 0 Locked

    158 views
    3 replies
    Latest over 3 years ago
    by Brian Zhou
  • Answered

    DS90UB954-Q1: Registers to check whether video is correctly received 0 Locked

    193 views
    4 replies
    Latest over 3 years ago
    by Hamzeh Jaradat
  • Not Answered

    TCAN1042H: spec check 0 Locked

    135 views
    1 reply
    Latest over 3 years ago
    by Eric Hackett
  • Suggested Answer

    DS90UB940N-Q1: DS90UB940N-Q1with Single channel LVDS input 0 Locked

    282 views
    2 replies
    Latest over 3 years ago
    by Hamzeh Jaradat
  • Not Answered

    THVD1550: THVD1550 BiCMOS? 0 Locked

    203 views
    2 replies
    Latest over 3 years ago
    by Hao L
  • Answered

    TRSF3223E: Thermal Information 0 Locked

    348 views
    6 replies
    Latest over 3 years ago
    by Jejomar Ildefonso
  • Not Answered

    DS90UB954-Q1: Internal Pull Down Value and Tolerances 0 Locked

    116 views
    1 reply
    Latest over 3 years ago
    by Nicholas Darash
  • Answered

    98x(SER) paired with 94X(DES) , whether GPIO need map to the same number? 0 Locked

    425 views
    5 replies
    Latest over 3 years ago
    by Joey Jin
  • Suggested Answer

    PCA9306: Changed values of VIK 0 Locked

    195 views
    1 reply
    Latest over 3 years ago
    by BOBBY
  • Suggested Answer

    SN65LVDS93A-Q1: Delta VOD Spec Clarification 0 Locked

    341 views
    1 reply
    Latest over 3 years ago
    by Aaron Heng
  • Not Answered

    DS90UB934-Q1: Serializer ID automatically load failed issue 0 Locked

    1435 views
    41 replies
    Latest over 3 years ago
    by Shruti More
  • Answered

    TUSB1044RNQEVM: Can I use single TVS diode instead of TPD6S300? 0 Locked

    400 views
    4 replies
    Latest over 3 years ago
    by Chase Jeong
<>