TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] Linear vs. Limited Mode in Redrivers

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 Linear Mode: In linear mode the data received from the GPU’s transmitter is the data that will be sent out of the TX end of the redriver. This means that the GPU’s voltage swing, pre-emphasis…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB216I: How do you create a system with a 10 meter passive cable using a USB2 redriver?

    Ryan Kitto
    Ryan Kitto
    Part Number: TUSB216I Other Parts Discussed in Thread: TUSB217A , TUSB216-Q1 , , TUSB216 , TUSB211A I want to create a system that can support USB2 while utilizing a 10 meter passive cable. Which redriver(s) should I use, and how should they be configured…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB-C CC and PD controller differences

    Shane Hauser
    Shane Hauser
    Do I need to use a CC controller or PD controller for my USB-C application?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to control VBUS on a USB-C port

    Shane Hauser
    Shane Hauser
    Other Parts Discussed in Thread: TUSB320 How do I control the VBUS on my USB-C downstream facing or dual-role port?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TDP1204: When to AC or DC couple the HDMI 2.1 output?

    Zach Dryer
    Zach Dryer
    Part Number: TDP1204 Up until HDMI 2.1, source output AC coupling was not clearly defined. However, now with HDMI 2.1 AC coupling is clearly defined. However, how can the designer determine when to AC or DC couple the HDMI 2.1 output?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Potential TI Solutions for Video Protocol Conversion

    Zach Dryer
    Zach Dryer
    What potential solutions does TI offer for video protocol conversion?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: Where can I find the latest Linux Drivers for DP83TG720 and DP83TG812/3/4?

    Melissa Chang
    Melissa Chang
    Part Number: DP83TG720S-Q1 Attached are the latest drivers tested on Kernel 5.10: GitHub - TexasInstruments/ti-ethernet-software: Repository for Ethernet PHY drivers for Linux and RTOS. The DP83TC812 driver can be used for the DP83TC813 and DP83TC814…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS160PR410: Difference Between IBIS-AMI versus IBIS Modeling

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: DS160PR410 Other Parts Discussed in Thread: DS160PR810 , LMH0340 IBIS stands for Input/Output Buffering Information Specifications while AMI stands for Algorithm modeling Interface. In short, IBIS is used to describe analog behavior of…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: My PHY won't link up

    David Creger
    David Creger
    Part Number: DP83TC812S-Q1 Link status is shown in register 0x1 bit[2]. Link failing to show as up can be caused by many issues. Please see the following debug guide which walks through several of the possible causes and fixes. Specifically see section…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC813S-Q1: How to output LED1 signal on pin 14

    David Creger
    David Creger
    Part Number: DP83TC813S-Q1 By default, pin 14 of the DP83TC813 will output the CLKOUT signal. To instead have the LED1 signal on pin 14, write to the below registers. 0x045F = 0x000F 0x0452 = 0x0000 0x0451 = 0x0009
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    SN65HVD33: Data rate dependency 0 Locked

    904 views
    10 replies
    Latest over 7 years ago
    by Hao L
  • Answered

    TPD1E05U06-Q1: Looking for smaller Diode 0 Locked

    1078 views
    5 replies
    Latest over 7 years ago
    by Cameron Phillips
  • Suggested Answer

    TUSB1310A: Pin States in Chip Reset 0 Locked

    793 views
    3 replies
    Latest over 7 years ago
    by JMMN
  • Suggested Answer

    SN75DP159: SN75DP159 40 pin & 48 pin different 0 Locked

    473 views
    1 reply
    Latest over 7 years ago
    by JMMN
  • Suggested Answer

    TPL7407LA: TPL7407LDR gone from the TI's product list? 0 Locked

    432 views
    1 reply
    Latest over 7 years ago
    by Alpha H
  • Suggested Answer

    ULQ2003A-Q1: ULQ2003A-Q1 Use question 0 Locked

    509 views
    1 reply
    Latest over 7 years ago
    by Alpha H
  • Answered

    TUSB1002A: About MODE pin 0 Locked

    389 views
    4 replies
    Latest over 7 years ago
    by Hide
  • Answered

    DP83822I: Problem with DP83822i internal pulldown resistors 0 Locked

    450 views
    6 replies
    Latest over 7 years ago
    by Geet Modi
  • Answered

    ISO1540: ISO1540DR P2P MAX14933ASE+T 0 Locked

    513 views
    1 reply
    Latest over 7 years ago
    by Koteshwar Rao
  • Suggested Answer

    Roadmap for USB Power Delivery switch 0 Locked

    551 views
    1 reply
    Latest over 7 years ago
    by Eric Beljaars
  • Answered

    DS90UB947-Q1EVM: Why can't set the four registers ? 0 Locked

    477 views
    2 replies
    Latest over 7 years ago
    by Went Cao
  • Suggested Answer

    DS90UB927Q-Q1: DS90UB927 0 Locked

    348 views
    1 reply
    Latest over 7 years ago
    by Steven(Shenzhen) Shi
  • Suggested Answer

    DS90UB913A-CXEVM: If power supply with POC, PCLK will failed in lock 0 Locked

    536 views
    2 replies
    Latest over 7 years ago
    by Steven(Shenzhen) Shi
  • Answered

    Linux/DS90UH927Q-Q1: Receiver ds90ur910 can not recognise clock/data transfered 0 Locked

    2404 views
    11 replies
    Latest over 7 years ago
    by John Zhao
  • Answered

    TPD6E001: Dynamic Resistance of TPD6E001 0 Locked

    758 views
    2 replies
    Latest over 7 years ago
    by Kazuki Kuramochi
  • Answered

    TPS65981: USB Type C Cable, E-Marker 0 Locked

    871 views
    1 reply
    Latest over 7 years ago
    by Rahul Sharma16
  • Answered

    TPS2553D: About minimum of Rise time, output (tr) 0 Locked

    315 views
    2 replies
    Latest over 7 years ago
    by Hide
  • Suggested Answer

    TPS2559: TPS2559 application question 0 Locked

    605 views
    4 replies
    Latest over 7 years ago
    by Chen Bogey8
  • Answered

    DP83867IR: linkup time 0 Locked

    323 views
    3 replies
    Latest over 7 years ago
    by K.Hamamoto
  • Suggested Answer

    TUSB1064: About AC Coupling Capacitor 0 Locked

    2115 views
    3 replies
    Latest over 7 years ago
    by David (ASIC) Liu
<>