TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] Linear vs. Limited Mode in Redrivers

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 Linear Mode: In linear mode the data received from the GPU’s transmitter is the data that will be sent out of the TX end of the redriver. This means that the GPU’s voltage swing, pre-emphasis…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB216I: How do you create a system with a 10 meter passive cable using a USB2 redriver?

    Ryan Kitto
    Ryan Kitto
    Part Number: TUSB216I Other Parts Discussed in Thread: TUSB217A , TUSB216-Q1 , , TUSB216 , TUSB211A I want to create a system that can support USB2 while utilizing a 10 meter passive cable. Which redriver(s) should I use, and how should they be configured…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB-C CC and PD controller differences

    Shane Hauser
    Shane Hauser
    Do I need to use a CC controller or PD controller for my USB-C application?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to control VBUS on a USB-C port

    Shane Hauser
    Shane Hauser
    Other Parts Discussed in Thread: TUSB320 How do I control the VBUS on my USB-C downstream facing or dual-role port?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TDP1204: When to AC or DC couple the HDMI 2.1 output?

    Zach Dryer
    Zach Dryer
    Part Number: TDP1204 Up until HDMI 2.1, source output AC coupling was not clearly defined. However, now with HDMI 2.1 AC coupling is clearly defined. However, how can the designer determine when to AC or DC couple the HDMI 2.1 output?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Potential TI Solutions for Video Protocol Conversion

    Zach Dryer
    Zach Dryer
    What potential solutions does TI offer for video protocol conversion?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: Where can I find the latest Linux Drivers for DP83TG720 and DP83TG812/3/4?

    Melissa Chang
    Melissa Chang
    Part Number: DP83TG720S-Q1 Attached are the latest drivers tested on Kernel 5.10: GitHub - TexasInstruments/ti-ethernet-software: Repository for Ethernet PHY drivers for Linux and RTOS. The DP83TC812 driver can be used for the DP83TC813 and DP83TC814…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS160PR410: Difference Between IBIS-AMI versus IBIS Modeling

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: DS160PR410 Other Parts Discussed in Thread: DS160PR810 , LMH0340 IBIS stands for Input/Output Buffering Information Specifications while AMI stands for Algorithm modeling Interface. In short, IBIS is used to describe analog behavior of…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: My PHY won't link up

    David Creger
    David Creger
    Part Number: DP83TC812S-Q1 Link status is shown in register 0x1 bit[2]. Link failing to show as up can be caused by many issues. Please see the following debug guide which walks through several of the possible causes and fixes. Specifically see section…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC813S-Q1: How to output LED1 signal on pin 14

    David Creger
    David Creger
    Part Number: DP83TC813S-Q1 By default, pin 14 of the DP83TC813 will output the CLKOUT signal. To instead have the LED1 signal on pin 14, write to the below registers. 0x045F = 0x000F 0x0452 = 0x0000 0x0451 = 0x0009
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TMDS181: Do any of the I2C-based Tx termination options cause the chip to use less power? 0 Locked

    368 views
    1 reply
    Latest over 7 years ago
    by JMMN
  • Suggested Answer

    DS99R106: Using an FPGA as a transmitter - DCA and DCB bits 0 Locked

    920 views
    3 replies
    Latest over 7 years ago
    by Darryl Jeong
  • Answered

    DS250DF810: Minimum Power Consumption 0 Locked

    329 views
    1 reply
    Latest over 7 years ago
    by Nasser Mohammadi
  • Answered

    DS75176BT: PCN questions 0 Locked

    526 views
    1 reply
    Latest over 7 years ago
    by Miguel Robertson
  • Suggested Answer

    DS90UB954-Q1EVM: Unable to initialize the camera through the serializer 0 Locked

    1157 views
    3 replies
    Latest over 7 years ago
    by Sally Cheung95
  • Suggested Answer

    TUSB3410: TUSB3410 - Driver for Windows 10 0 Locked

    3968 views
    8 replies
    Latest over 7 years ago
    by Brian Quach
  • Suggested Answer

    DS90UB953-Q1: About SI analysis method of FPD-LINK3 0 Locked

    664 views
    5 replies
    Latest over 7 years ago
    by Davor Glisic
  • Answered

    TUSB8044: Type C USB HUB Design Issues 0 Locked

    1093 views
    6 replies
    Latest over 7 years ago
    by Eric Beljaars
  • Suggested Answer

    [SN1408009] USB Charging Port Controller can not recognize Apple's device at CDP mode 0 Locked

    1108 views
    3 replies
    Latest over 7 years ago
    by Adam Mc Gaffin
  • Answered

    TUSB8041: Windows Software to Configure USB Hub 0 Locked

    2961 views
    8 replies
    Latest over 7 years ago
    by Sarah Weinberger
  • Suggested Answer

    SN75DPHY440SS: What is the maximum distance when using multiple MIPI extenders 0 Locked

    1066 views
    1 reply
    Latest over 7 years ago
    by Malik Barton57
  • Answered

    Linux/DS90UB953-Q1: help about Pattern Generation of DS90UB953 0 Locked

    439 views
    1 reply
    Latest over 7 years ago
    by Jonathan Nguyen
  • Suggested Answer

    SN65DP159: Device unstable 0 Locked

    360 views
    1 reply
    Latest over 7 years ago
    by JMMN
  • Answered

    TUSB8041: EEPROM programming tool link 0 Locked

    522 views
    2 replies
    Latest over 7 years ago
    by Avinash Muralidaran
  • Suggested Answer

    Replacement for AK3-430C from littlefuse? 0 Locked

    437 views
    2 replies
    Latest over 7 years ago
    by Rakesh
  • Not Answered

    TUSB8041: "No attached TUSB840 device was found" error 0 Locked

    970 views
    5 replies
    Latest over 7 years ago
    by Sarah Weinberger
  • Suggested Answer

    TPS2549: D+, D- Voltage level & current profile setting 0 Locked

    2678 views
    3 replies
    Latest over 7 years ago
    by Adam Mc Gaffin
  • Suggested Answer

    PCA9306: Is there a condition falling malfunction? 0 Locked

    356 views
    5 replies
    Latest over 7 years ago
    by BOBBY
  • Suggested Answer

    TCA6424A: Pull Up resistor of Address Pin 0 Locked

    338 views
    1 reply
    Latest over 7 years ago
    by BOBBY
  • Answered

    HD3SS3212: OEn Pin low at startup 0 Locked

    463 views
    3 replies
    Latest over 7 years ago
    by Malik Barton57
<>