TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] USB-C CC and PD controller differences

    Shane Hauser
    Shane Hauser
    Do I need to use a CC controller or PD controller for my USB-C application?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to control VBUS on a USB-C port

    Shane Hauser
    Shane Hauser
    Other Parts Discussed in Thread: TUSB320 How do I control the VBUS on my USB-C downstream facing or dual-role port?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TDP1204: When to AC or DC couple the HDMI 2.1 output?

    Zach Dryer
    Zach Dryer
    Part Number: TDP1204 Up until HDMI 2.1, source output AC coupling was not clearly defined. However, now with HDMI 2.1 AC coupling is clearly defined. However, how can the designer determine when to AC or DC couple the HDMI 2.1 output?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Potential TI Solutions for Video Protocol Conversion

    Zach Dryer
    Zach Dryer
    What potential solutions does TI offer for video protocol conversion?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: Where can I find the latest Linux Drivers for DP83TG720 and DP83TG812/3/4?

    Melissa Chang
    Melissa Chang
    Part Number: DP83TG720S-Q1 Attached are the latest drivers tested on Kernel 5.10: GitHub - TexasInstruments/ti-ethernet-software: Repository for Ethernet PHY drivers for Linux and RTOS. The DP83TC812 driver can be used for the DP83TC813 and DP83TC814…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS160PR410: Difference Between IBIS-AMI versus IBIS Modeling

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: DS160PR410 Other Parts Discussed in Thread: DS160PR810 , LMH0340 IBIS stands for Input/Output Buffering Information Specifications while AMI stands for Algorithm modeling Interface. In short, IBIS is used to describe analog behavior of…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: My PHY won't link up

    David Creger
    David Creger
    Part Number: DP83TC812S-Q1 Link status is shown in register 0x1 bit[2]. Link failing to show as up can be caused by many issues. Please see the following debug guide which walks through several of the possible causes and fixes. Specifically see section…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC813S-Q1: How to output LED1 signal on pin 14

    David Creger
    David Creger
    Part Number: DP83TC813S-Q1 By default, pin 14 of the DP83TC813 will output the CLKOUT signal. To instead have the LED1 signal on pin 14, write to the below registers. 0x045F = 0x000F 0x0452 = 0x0000 0x0451 = 0x0009
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: How to to adjust slew rate of MAC IOs

    David Creger
    David Creger
    Part Number: DP83TC812S-Q1 Reducing the slew rate of MAC interface IOs can provide improvement in EMC emissions for some frequencies. This can be done using register 0x456. 0x456 bits [5] and [0] control the impedance of the RX and TX MAC interface…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Announcing New GUI Application for Ethernet EVM & PHY Evaluation

    Evan Mayhew
    Evan Mayhew
    All, Excited to share the initial release of DIEP (Debug Interface for Ethernet PHYs). The Windows GUI is designed to simplify the process for PHY-level configuration and debug with register access. Using a valid USB connection to an on-board MSP…
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    DP83867IR: Pulse trans and common mode filter 0 Locked

    1058 views
    3 replies
    Latest over 8 years ago
    by Aniruddha Khadye
  • Answered

    DS90UB964-Q1: REFCLK 0 Locked

    1790 views
    7 replies
    Latest over 8 years ago
    by Nao
  • Answered

    TPS65982: Data role issue in CC communication 0 Locked

    1646 views
    6 replies
    Latest over 8 years ago
    by Jeffrey Mueller
  • Answered

    TPS65982: How to Use This Device for Data processing 0 Locked

    550 views
    2 replies
    Latest over 8 years ago
    by Jeffrey Mueller
  • Not Answered

    XIO2213B: Preemphasis on PCIe 0 Locked

    690 views
    1 reply
    Latest over 8 years ago
    by Dennis Wu
  • Suggested Answer

    SN65LBC184: compatibility with SN75176A 0 Locked

    827 views
    1 reply
    Latest over 8 years ago
    by Richard Broughton
  • Suggested Answer

    DS280BR820: DS280BR820 lockup time 0 Locked

    1003 views
    4 replies
    Latest over 8 years ago
    by Vladimir Yudovich
  • Answered

    SN65DP149: GPU's AUXp/N connection to DP140 0 Locked

    1145 views
    3 replies
    Latest over 8 years ago
    by Moises Garcia
  • Answered

    TUSB422: USB HOST SINK 0 Locked

    1378 views
    3 replies
    Latest over 8 years ago
    by Diego Cortes
  • Answered

    SN65DSI86EVM: AUX_DEFR returned when doing semi-auto link training 0 Locked

    672 views
    2 replies
    Latest over 8 years ago
    by Joel Jimenez0
  • Not Answered

    DS64BR401: PCIe over Cable 0 Locked

    553 views
    1 reply
    Latest over 8 years ago
    by Lee Sledjeski
  • Answered

    HD3SS214: The reference schematic 0 Locked

    700 views
    1 reply
    Latest over 8 years ago
    by Moises Garcia
  • Suggested Answer

    TI PCIE retimer 0 Locked

    1658 views
    2 replies
    Latest over 8 years ago
    by Lee Sledjeski
  • Answered

    DS90UB934-Q1: BISTEN duration 0 Locked

    493 views
    2 replies
    Latest over 8 years ago
    by Hamzeh Jaradat
  • Suggested Answer

    DS90UB927Q-Q1: Help review schematic 0 Locked

    444 views
    1 reply
    Latest over 8 years ago
    by Steven(Shenzhen) Shi
  • Answered

    SN65HVD11: Applied in multi-voltage networks 0 Locked

    654 views
    2 replies
    Latest over 8 years ago
    by Walsh
  • Answered

    TPS2549-Q1: Black Berry charging test 0 Locked

    604 views
    2 replies
    Latest over 8 years ago
    by Kuramochi Tadahiko
  • Answered

    MAX3232: DOUT voltage issue 0 Locked

    898 views
    4 replies
    Latest over 8 years ago
    by NAOKI AOYAMA
  • Not Answered

    DP83848T: TXD pin be driven during power-on reset 0 Locked

    1698 views
    4 replies
    Latest over 8 years ago
    by Daisuke Maeda
  • Answered

    MAX208: External Capacitor polarity and capacity value 0 Locked

    742 views
    2 replies
    Latest over 8 years ago
    by Katsuhiko Kaizawa
<>