TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DS110DF111: How common 10G ethernet specifications fit into a typical application

    Lucas Wolter
    Lucas Wolter
    Part Number: DS110DF111 In this FAQ, I will explain how common 10G ethernet specifications fit into a typical application. The below application diagram comes from the DS110DF111 datasheet. Many 10G ethernet specifications are defined by the IEEE…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83869HM: Bridge Mode Clarification

    Alvaro (Al-vuh-roe) Reyes
    Alvaro (Al-vuh-roe) Reyes
    Part Number: DP83869HM The DP83869HM supports two types of Bridge Modes to translate data between two MAC interface types. The two types are: RGMII-to-SGMII mode SGMII-to-RGMII mode The naming convention implies MAC-to-PHY and the functionality…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] LMH1297: Why should I pay attention to the return loss performance?

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: LMH1297 When signal goes through two different transmission line, signal may get reflected based on difference between these two medias impedances. Return loss is the ratio of the reflected signal to the launched signal. If signal goes…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB522P: Linear vs limited re-driver

    Shane Hauser
    Shane Hauser
    Part Number: TUSB522P Other Parts Discussed in Thread: TUSB1002A , TUSB1044 , TUSB542 Hi Experts, I see parts like the TUSB1002A and 1044 described as "linear" re-drivers while the TUSB522P is a "limited" re-driver. Which one is better to use in a USB…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB1002A: What loss does the TUSB1002A compensate for in a USB system?

    Shane Hauser
    Shane Hauser
    Part Number: TUSB1002A Other Parts Discussed in Thread: TUSB1064 , TUSB1044 Hi Experts, Will the TUSB1002A recover the loss before or after the re-driver? Best, Shane
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867CR: DP83867 Harmonic Distortion compliance test mode

    Hillman Lin
    Hillman Lin
    Part Number: DP83867CR How to configure test mode for Harmonic Distortion Compliance test?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TS3USB221: Choosing The Right USB2.0 Passive Mux

    Ryan Kitto
    Ryan Kitto
    Part Number: TS3USB221 Other Parts Discussed in Thread: TS3USB30E , TS3USB3000 , , , I want to implement a USB2.0 multiplexer (mux) into my system, and have certain requirements for the functionality of the mux. What choice would be best for my system…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How DP8386x RGMII Straps Work

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E Other Parts Discussed in Thread: DP83869HM , When configuring DP83867 or DP83869HM (aka DP8386x) for RGMII communication, there two RGMII modes that the PHY can be strapped into; shift or align. In align mode, there is no skew between…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822H: How do I configure MDI swing levels to assist with VoD compliance?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83822H When testing DP83822 for PMD compliance testing, it may be required to adjust the swing level of the device if the levels are outside the range. A first check would be to ensure the schematic and layout design are the most optimal…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page USB Protection Highlights: USB Type-CTM has a 24-pin connector that can support USB 3 .1 Gen2, DisplayPort, HDMI, and a variety of other alternate modes: SuperSpeed USB lines for USB 3 .1 Gen2 (Tx1+, Tx1–, Rx1…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ISO7240CF Power only one side of isolator 0 Locked

    382 views
    1 reply
    Latest over 12 years ago
    by Thomas Kugelstadt
  • Answered

    AC coupling SN65LVDS179 LVDS inputs 0 Locked

    1013 views
    4 replies
    Latest over 12 years ago
    by Stephen Petlak
  • Answered

    SN65MLVD047 vs SN65MLVD047A ? 0 Locked

    536 views
    1 reply
    Latest over 12 years ago
    by Michael Peffers
  • Answered

    TUSB8040 - Concurrent device access 0 Locked

    318 views
    2 replies
    Latest over 12 years ago
    by JMMN
  • Answered

    SN65LV1224B does not lock 0 Locked

    674 views
    8 replies
    Latest over 12 years ago
    by Michael Peffers
  • Not Answered

    I2C Pass Through - DS92LX2121 / DS92LX2122 0 Locked

    630 views
    2 replies
    Latest over 12 years ago
    by Bradley Helsel
  • Answered

    Pin compatibility SN75174 and SM75LBC174 0 Locked

    560 views
    2 replies
    Latest over 12 years ago
    by jgerhardy
  • Answered

    About CANH and CANL on CAN driver 0 Locked

    652 views
    2 replies
    Latest over 12 years ago
    by Kevin Weng
  • Answered

    Output impedance of DS90CR215/16 0 Locked

    418 views
    2 replies
    Latest over 12 years ago
    by Madhu Vatte
  • Answered

    TUSB1310A TX_CLK 0 Locked

    312 views
    4 replies
    Latest over 12 years ago
    by kent zhou
  • Not Answered

    TUSB2046 power 0 Locked

    261 views
    1 reply
    Latest over 12 years ago
    by Elias Villegas M.
  • Not Answered

    DS90C387/DS90CF388 0 Locked

    299 views
    1 reply
    Latest over 12 years ago
    by Dac Tran
  • Answered

    Question about TLK1221 0 Locked

    290 views
    1 reply
    Latest over 12 years ago
    by Michael Peffers
  • Not Answered

    power on reset sequence for TUSB1310A 0 Locked

    3532 views
    11 replies
    Latest over 12 years ago
    by Elias Villegas M.
  • Answered

    DP83848K LED_LINK indication error 0 Locked

    284 views
    1 reply
    Latest over 12 years ago
    by Patrick OFarrell
  • Answered

    TUSB2046BIRHB Hub not powering on the devices connected to its ports 0 Locked

    507 views
    2 replies
    Latest over 12 years ago
    by Mahendra varman
  • Not Answered

    DS92LV2422 / Sampling window 0 Locked

    598 views
    0 replies
    Started over 12 years ago
    by S.Satoshi
  • Answered

    Problems configuring TL16C550D 0 Locked

    297 views
    1 reply
    Latest over 12 years ago
    by Jason Matusiak
  • Discussion

    Having problem with TUSB3410 VCP driver on 64-bit PC Locked

    2731 views
    19 replies
    Latest over 12 years ago
    by sreedhar Dhamotharan
  • Answered

    TLK1501 Recommended Rref Value 0 Locked

    593 views
    5 replies
    Latest over 12 years ago
    by Michael Peffers
<>