TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to read and write Ethernet PHY registers using a Linux terminal?

    David Creger
    David Creger
    There are several different tools available in a Linux environment to read and write registers on a TI PHY. Several of these options are listed below. MII read: This is the only command which can and must be used in U-boot. Stop the autoboot process…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: How to disable 25MHz clock on clkout pin?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TC812S-Q1 For DP83TC812S/R and DP83TC814-Q1 if clkout pin is not being used to provide a clock signal to another component, then it is recommended to shut down this clock output and reduce its impact on EM emissions. Clkout's output…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] Which conformal coating is recommended for Ethernet PHY products?

    Vikram Sharma
    Vikram Sharma
    TI does not have a recommendation for any specific conformal coat or underfill product. In some temperature ranges these materials can be detrimental if the conformal coating or underfill product has a mismatched CTE vs. solder joint (Z axis). This…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867IR: How to test the link-quality using DP83867's BIST and status registers?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83867IR DP83867 PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These parameters…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TD510E: How to check throughput without depending upon MAC?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TD510E DP83TD510E PHY (and other TI industrial and automotive PHYs) have the capability to : 1. Generate the packetized data 2. Capture the number of frames received 3. Capture the number of frames received with errors. These…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83867E: How do I choose magnetics for my industrial PHY?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83867E There are 5 key parameters to look out for when selecting magnetics: Magnetic type (specifically for integrated RJ-45/Magnetic component) Can the recommended MDI configuration still be met with this component? Turns…
    • over 2 years ago
    • Interface
    • Interface forum
  • [FAQ] TLK2711-SP: Eye Mask Recommendations

    Drew Miller1
    Drew Miller1
    Part Number: TLK2711-SP There have been some questions regarding the TLK2711-SP eye mask related to the following E2E thread, so I am hoping to clarify them in this post. TLK2711-SP: Is there an EYE diagram mask definition available? - Space & High…
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DS90UH941AS-Q1: How to configure FPD-Link III 94x audio

    Ryan Fleetham
    Ryan Fleetham
    Part Number: DS90UH941AS-Q1 How do I configure audio for FPD-Link III 94x devices?
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83826E: In enhanced mode, how does DP83826 strapping work?

    Gerome Cacho
    Gerome Cacho
    Part Number: DP83826E When configuring DP83826 in Enhanced Mode, please consult the following flowchart to understand how the different strap pins configure the PHY into various modes.
    • over 3 years ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: How to read or write registers in extended register space of Ethernet PHY?

    Vikram Sharma
    Vikram Sharma
    Part Number: DP83TG720S-Q1 write procedure for MMD "1F" registers: write reg<000D> = 0x001F write reg<000E> = <address> write reg<000D> = 0x401F write reg<000E> = <value> read procedure for MMD "1F" registers: write reg<000D> = 0x001F …
    • over 3 years ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    SN65HVD3086E clarification 0 Locked

    437 views
    1 reply
    Latest over 15 years ago
    by Thomas Kugelstadt
  • Answered

    SN65HVD10 - RS485 ESD protection recommendation? 0 Locked

    3497 views
    1 reply
    Latest over 15 years ago
    by Thomas Kugelstadt
  • Not Answered

    SRC4382 - Is there a device that can handle Doby E from an AS bit stream 0 Locked

    342 views
    0 replies
    Started over 15 years ago
    by wanjeri kirubi
  • Answered

    Mini PCI to PCI Bridge using PCI2050B 0 Locked

    436 views
    1 reply
    Latest over 15 years ago
    by -DK-
  • Answered

    ISO7421, ISO7421M 200Mbps or 1Mbps ? 0 Locked

    499 views
    1 reply
    Latest over 15 years ago
    by Neel Seshan
  • Answered

    Issue with ISO3088 0 Locked

    529 views
    1 reply
    Latest over 15 years ago
    by Thomas Kugelstadt
  • Suggested Answer

    about pci1510 chip 0 Locked

    572 views
    1 reply
    Latest over 15 years ago
    by DHarmon
  • Not Answered

    PCI2040 interface with ARM 0 Locked

    387 views
    1 reply
    Latest over 15 years ago
    by DHarmon
  • Suggested Answer

    TLK1221 hold time measure on RX of TBI 0 Locked

    757 views
    5 replies
    Latest over 15 years ago
    by Jonathan Nerger
  • Not Answered

    TLK2501 at 74MHz 0 Locked

    286 views
    0 replies
    Started over 15 years ago
    by Jason Albanus
  • Answered

    TFP401a - need 2.5V or less output drivers 0 Locked

    316 views
    1 reply
    Latest over 15 years ago
    by Undrea Fields
  • Discussion

    TFP410 Delay Locked

    311 views
    1 reply
    Latest over 15 years ago
    by Undrea Fields
  • Answered

    USB Hub LED indicator? 0 Locked

    377 views
    1 reply
    Latest over 15 years ago
    by JMMN
  • Answered

    CAN tranceiver hvd233 package sizes 0 Locked

    423 views
    1 reply
    Latest over 15 years ago
    by Thomas Kugelstadt
  • Answered

    Does TUSB1310 support USB OTG (On-The-Go)? 0 Locked

    640 views
    1 reply
    Latest over 15 years ago
    by Wes Ray
  • Suggested Answer

    IBIS model for SN55LVDS31W and SN55LVDS32W 0 Locked

    540 views
    3 replies
    Latest over 15 years ago
    by Hai Zhou56288
  • Answered

    SN65HVD1781 propagation distance? 0 Locked

    451 views
    3 replies
    Latest over 15 years ago
    by yukun hu
  • Answered

    Project on Laser distance measure 0 Locked

    689 views
    1 reply
    Latest over 15 years ago
    by Alex Davidson
  • Answered

    Orcad footprint for MLVD082 0 Locked

    425 views
    1 reply
    Latest over 15 years ago
    by Atul Patel
  • Answered

    XIO3130 PCIe Switch downstream reference clocks are disabled. 0 Locked

    702 views
    1 reply
    Latest over 15 years ago
    by -DK-
<>