Texas Instruments (TI) Microcontrollers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search for content on other microcontrollers or ask technical support questions on the extensive portfolio of microcontrollers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: TMS570LC4357 Other Parts Discussed in Thread: HALCOGEN How to use different peripherals pins as GIO, like
1. MibSPI pins as GIO
2. Lin pins as GIO
3. N2HET pins as GIO
4. ECLK pin as GIO
5. RTP pins as GIO
Part Number: TMS570LC4357 Other Parts Discussed in Thread: HALCOGEN , Explain the detailed process to enable 256 BUFFERS/EXTENDED_BUF_ENA Feature OF MibSPI.
Part Number: MSPM0-SDK Other Parts Discussed in Thread: SYSCONFIG , UNIFLASH ,
Important note for early MSPM0 customers
TI recently launched a new family of Arm Cortex-M0+ MCUs , including the MSPM0L series and MSPM0G series . These MCUs are accompanied…
Part Number: AM2434
Hi,
I'm looking at enabling in the field provisioning (also factory provisioning) of devices that are using the AM243x/AM64x family of Sitara products. I would like to be able to uniquely identify each module and was hoping the…
Part Number: LP-AM243
Hi experts,
I am evaluating AM243x with MCU+SDK 8.5.0.24.
I noticed in the FreeRTOS docs that FreeRTOS has a multiprocessing feature called SMP , which would be an interesting option for AM243x.
Is this feature included in…
Part Number: AM2634
Q1. How to debug TIFS-MCU on Cortex M4 in HS-FS devices ?
Q2. How to debug TIFS-MCU on Cortex M4 in HS-SE devices ?
Q3. In HS-SE devices, is there a way to leverage the flow to open the debug for HSM M4 in development environment…
Part Number: MCU-PLUS-SDK-AM263X Hi Experts,
How do I configure CPSW 2G ALE to filter packets based on VLAN, Ethernet Type, Source MAC, Destination MAC, IP address etc?
Part Number: MCU-PLUS-SDK-AM263X Other Parts Discussed in Thread: SYSCONFIG
Hi
How to Configure GPIO Interrupts in AM263x for individual GPIO pins.
How is it different from the existing GPIO Bank Interrupt Configuration example in the SDK.
Other Parts Discussed in Thread: TMDSCNCD263 , TMDS243EVM , LP-AM263 , LP-AM243 , TUSB320 The following FAQ applies to AM243x LaunchPad (LP-AM243), AM263x LaunchPad (LP-AM263), AM243x General Purpose Evaluation Module (TMDS243GPEVM, TMDS243EVM), AM263x…
Part Number: MCU-PLUS-SDK-AM243X
How to identify which image should I use ? Should I use *.hs_fs.tiimage or *.tiimage for SBL programing on my device.
Does it matter ? Does it affect any of my application ?