• Threads 50342 Discussions
Texas Instruments (TI) Microcontrollers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search for content on other microcontrollers or ask technical support questions on the extensive portfolio of microcontrollers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] AM2634-Q1: How to use CCS studio to compile my MCAL projects?

    Part Number: AM2634-Q1 Currently, the MCAL projects seems to be a makefile based environment and how to use CCS studio to create, compile and debug our MCAL based projects easily? We're seeing lot of errors regarding missing assembly and source files…

  • [FAQ] MCU-PLUS-SDK-AM263X: How to add code into TCM using linker.cmd file

    How to edit the linker.cmd file to add new sections in TCM and how to add the application code into these TCM sections for faster code execution?

  • [FAQ] TMS570LC4357: What are the differences among the memory attributes, memory types and cache policy in MPU settings?

    Part Number: TMS570LC4357 Other Parts Discussed in Thread: DBCA What are the MPU used for? What is the read allocate and write allocate in MPU settings? What are the procedures to setup up the MPU region? What is the attribute of an overlapped…

  • [FAQ] TMS570LC4357: How to solve the cache coherency issues when accessing the shared memory through CPU and DMA?

    Part Number: TMS570LC4357 After CPU has updated the data buffer, but the DMA still transfers the old content in the buffer instead of the updated one.

  • [FAQ] TMS570LC4357: FEE Configuration Parameters in HALCOGen

    Part Number: TMS570LC4357 Other Parts Discussed in Thread: HALCOGEN , To generate FEE drivers from Halcogen software I had some questions about the highlighted parameters shown in images below. I read the Technical Reference Manual of TMS570LC4357 but…

  • [FAQ] Flash Programming Options in Mass Production Phase

    What is the recommended production method of loading an flash device during mass production?

  • [FAQ] TMS570LS1224: When reading from Flash ECC space or SRAM ECC space, does a double-bit error detected generate data abort?

    Part Number: TMS570LS1224 The Hercules microcontrollers protect all accesses to the on-chip flash memory and on-chip SRAM memory by dedicated Single-Error-Correction-Double-Error-Detection (SECDED) logic. The access to the program memory (bank 0 or bank…

  • [FAQ] TMS570LC4357: After erasing, the flash contents should become 0xFFFFFFFF. Why the flash content in CCS memory browser is not 0xFFFFFFFF?

    Part Number: TMS570LC4357 After the flash is erased, why the flash content doesn't become 0xFFFFFFFF?

  • [FAQ] TMS570LC4357: There are three instances of temperature sensors in this MCU, how to configure the pin multiplexing (pinmux) to select ADC pins for those temperature sensors?

    Part Number: TMS570LC4357 1. How to enable those three temperature sensors? 2. Can the temperature sensor be used to measure the room temperature? 3. How to configure the pin multiplexing to select AD1IN[31] for the temperature sensor 1? 4. How…

  • [FAQ] TMS570LC4357: How to use DMA for CAN message transmit and receive?

    Part Number: TMS570LC4357 The CAN module has three message interface registers: IF1, IF2 and IF3. How can I enable DMA to transfer message to IF1 of IF2 data registers and from IF3x data registers?

View FAQ threads