Texas Instruments (TI) C2000™ microcontrollers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search C2000™ microcontroller content or ask technical support questions on our families of real-time control MCUs. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM13E23019
Hi ,
When trying to connect am13x launchpad we get the following errors;
CS_DAP_0: Error connecting to the target: (Error -615 @ 0x0) The target failed to see a correctly formatted SWD header. The connection to the target…
Part Number: TMS320F280033 Other Parts Discussed in Thread: SYSCONFIG , UNIFLASH
The default boot to flash entry point is 0x80000 in the F28003x Boot ROM, which is not in the memory map for the F280033/F280034 subset parts. This thread will detail how…
Other Parts Discussed in Thread: C2000WARE
This thread will discuss the best practices for custom bootloading on the following devices:
F2807x
F2837xS
F2837xD
F28004x
F2838x
F28002x
F28003x
F280013x
F280015x
F28P65x
F28P55x …
Part Number: F29H850TU Other Parts Discussed in Thread: SYSCONFIG
Is there any document explaining CAN module configuration parameters and how to configure these parameters in Sysconfig tool?
Part Number: TMS320F28P550SJ
Hello,
I followed outlined steps in gain calibration section of TRM chapter, but for some reason my ADCRESULT register does not show 0.9 * VREFHI, but a floating value. What could be the reason?
Part Number: TMS320F28P550SJ
I had an issue with ADC Zero Offset calibration. I followed steps outlined in TRM, but for some reason my Vreflo ADCRESULTREG keeps showing zero instead of certain offset. Could you help me with this issue, please?
Other Parts Discussed in Thread: C2000WARE , SYSCONFIG
This post is meant to specify erratas /document any refinements or clarifications discovered after the C2000Ware release.
Sysconfig migration/Switch feature in Sysconfig 1.26 does not work with…
Part Number: TMS320F2800137 Other Parts Discussed in Thread: C2000WARE
Hello,
I want to port the E-Metrology library fom F28P55 to F2800137. I want to enable only single-phase calculations and I do not wish to calculate THD. What steps can I follow…
Part Number: TMS320F28P550SJ
Hello!
Thank you for your interest in the E-Metrology Library for F28P55x and F28P65x. If you are interested in knowing more about how the metrology parameters are calculated and the mathematical formulae used to do please…
