TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] LM25118: Why can't operate when Vin is lower than 4V?

    Paul Yeh
    Paul Yeh
    Part Number: LM25118 Hi team, My customer used this device in their system but they need support Vin voltage low to 3.5V. But currently they found when input voltage is lower than 4V, our device will be off. Below is their circuit and please advise…
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] LM2663: How much ESR and capacitance are recommended for external capacitor?

    Yoshiki Ochi
    Yoshiki Ochi
    Part Number: LM2663 Hi team, Could you tell me How much ESR and capacitance (range) are recommended for external capacitor as C1 and C2? I would like to use LM2633 as +2.5V input and -2.5V output converter. Regards, Ochi
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ77216: How do I reduce the cell count?

    WM5295
    WM5295
    Part Number: BQ77216 When I don't need all 16 cells of the BQ77216, how should I connect the inputs?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS650864: What to do with unused voltage regulators / rails?

    Kevin LaRosa
    Kevin LaRosa
    Part Number: TPS650864 Hello, The TPS650864 has multiple default settings options (orderable part numbers) but it is common that they won't be a perfect match for a given design. What should I do if I don't want to use one of the regulators that…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] UCC5310: Logic input characteristics of UCC53XX family

    Don Dapkus
    Don Dapkus
    Part Number: UCC5310 Other Parts Discussed in Thread: UCC5304 , UCC5350-Q1 , UCC5390 , , UCC5390SCDEVM-010 , UCC5350 , UCC5320SCEVM-058 , UCC5390ECDWVEVM , UCC5320 , UCC5390-Q1 , UCC5304EVM-035 The UCC53XX family, excluding UCC5304, have "CMOS compatible…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] UCC5304: Do you have a version of UCC5304 with an ENABLE pin?

    Don Dapkus
    Don Dapkus
    Part Number: UCC5304 Other Parts Discussed in Thread: UCC5350 Do you have a version of UCC5304 with an ENABLE pin?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] UCC5310: Do you have a version of UCC53XX with an ENABLE pin?

    Don Dapkus
    Don Dapkus
    Part Number: UCC5310 I would like to use UCC53XX, but I need an ENABLE input. Do you have a part like UCC53XX with an ENABLE pin?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] UCC5304: How do I implement interlock protection using the UCC5304 in half-bridge applications?

    Don Dapkus
    Don Dapkus
    Part Number: UCC5304 How do I implement interlock protection using the UCC5304 in half-bridge applications?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] UCC5310: How do I implement interlock protection using the UCC53XX family in half-bridge applications?

    Don Dapkus
    Don Dapkus
    Part Number: UCC5310 Other Parts Discussed in Thread: UCC5304 How do I implement interlock protection using the UCC53XX family?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] UCC27517A-Q1: Why should I replace discrete gate drivers with low-side driver ICs in automotive PTC modules?

    Tristan Foro
    Tristan Foro
    Part Number: UCC27517A-Q1 Hello, I'm currently using a discrete gate driver for my PTC heater application. What are the benefits of using a gate driver IC instead?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    UCC21551: Technical Inquiry on UCC21551: Cost Structure, High-Frequency Reliability, and Fault Modes 0 Locked

    292 views
    3 replies
    Latest 5 months ago
    by Hiroki Honda
  • Answered

    BQ25895: REG00 bit6-EN_ILIM reset value 0 Locked

    148 views
    1 reply
    Latest 5 months ago
    by Alec Lehman
  • Suggested Answer

    TPS25762-Q1: Board review 0 Locked

    203 views
    4 replies
    Latest 5 months ago
    by Chuck Branch
  • Suggested Answer

    LM334: The LM334 output current tolerance 0 Locked

    101 views
    1 reply
    Latest 5 months ago
    by Andrew Li
  • Suggested Answer

    TPSM64406: For TPSM64406EVM-4PH: Need schematic/layout project that will convert to OrCAD X 0 Locked

    246 views
    5 replies
    Latest 5 months ago
    by Rahil Ajani
  • Suggested Answer

    UCC5350: Drive two MOSFETs in parallel with a single gate drive for Miler clamp connection 0 Locked

    205 views
    3 replies
    Latest 5 months ago
    by Sean Cashin
  • Answered

    BQ25798: Premature charge termination prevents gas gauge from waking up 0 Locked

    367 views
    10 replies
    Latest 5 months ago
    by Jeff LaBundy
  • Suggested Answer

    BQ41Z90: LED Configuration for 5-LED RSOC Display. 0 Locked

    202 views
    2 replies
    Latest 5 months ago
    by Diego
  • Answered

    LM2596: Schematic Check 0 Locked

    100 views
    1 reply
    Latest 5 months ago
    by Rahil Ajani
  • Suggested Answer

    TPS51200: The difference between REFOUT and VO 0 Locked

    101 views
    1 reply
    Latest 5 months ago
    by James Steenbock
  • Suggested Answer

    LM25180: Is LM25180 pin to pin replacement of LT8301? Will it work in the attached design 0 Locked

    141 views
    1 reply
    Latest 5 months ago
    by Manuel Alva Hernandez
  • Suggested Answer

    BQ24610: Charging IC 0 Locked

    148 views
    1 reply
    Latest 5 months ago
    by Christian Moyer
  • Not Answered

    BQ25756: Unexpected jump (increase) in charging current when the charger is in taper charge mode 0 Locked

    232 views
    6 replies
    Latest 5 months ago
    by Christian Moyer
  • Not Answered

    BQ27Z558: Parameters 0 Locked

    273 views
    10 replies
    Latest 5 months ago
    by Alan Frias
  • Suggested Answer

    TPS1HB08-Q1: maximum inrush current of the TPS1HB08-Q1 0 Locked

    93 views
    2 replies
    Latest 5 months ago
    by Alan Whitehead
  • Suggested Answer

    BQ76940: Sudden non-answering questions in the communication 0 Locked

    187 views
    3 replies
    Latest 5 months ago
    by Luis H. S.
  • Suggested Answer

    TPS65217: Dual output for buck/boost application 0 Locked

    114 views
    1 reply
    Latest 5 months ago
    by Sathish Vallamkonda
  • Suggested Answer

    BQ76930: ADC sampling reference voltage 0 Locked

    115 views
    2 replies
    Latest 5 months ago
    by Luis H. S.
  • Suggested Answer

    BQ76930: Sampling accuracy 0 Locked

    124 views
    2 replies
    Latest 5 months ago
    by Luis H. S.
  • Not Answered

    TPS65994QFNEVM: EEPROM programming device 0 Locked

    81 views
    2 replies
    Latest 5 months ago
    by Alex Liu
<>