TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] BQ76952: Accumulated charge returns -32768

    Nhan Mai
    Nhan Mai
    Part Number: BQ76952 Other Parts Discussed in Thread: BQSTUDIO Hello everyone, Before discharging I had set accumulated charge value back to 0, then I have sent ALL_FETS_ON command from Bqstudio. Suddenly read accumulated charge value was changed…
    • Answered
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS65086x: TPS650861, TPS6508641: Buck Controller External Feedback Set-Up

    James Steenbock
    James Steenbock
    Part Number: TPS650861 This thread applies to the TPS65086x devices, and specifically to the TPS650861 and TPS6508641 devices with regard to BUCK1. The TPS650861 PMIC has three Buck controllers: BUCK1, BUCK2, and BUCK6. Each controller has an external…
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] LP8732-Q1: PGOOD Triggers when output voltage is adjusted

    Tomi Koskela
    Tomi Koskela
    Part Number: LP8732-Q1 This FAQ applies to LP8732x, LP8733x, LP8732x-Q1, LP8733x-Q1. In LP873x-Q1 devices the PGOOD triggers always when output voltage is adjusted through I2C command no matter how small voltage step is applied. To overcome this and…
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] LP87561-Q1: PGOOD triggers when output voltage is adjusted

    Tomi Koskela
    Tomi Koskela
    Part Number: LP87561-Q1 This FAQ applies to LP8756x-Q1, LP8752x-Q1. In LP875x-Q1 devices the PGOOD triggers always when output voltage is adjusted through I2C command no matter how small voltage step is applied. To overcome this and avoid SoC reset…
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] LP8732-Q1: How can I used LP873x PMIC PGOOD as a nRESET signal for a SoC

    Tomi Koskela
    Tomi Koskela
    Part Number: LP8732-Q1 This FAQ applies to LP8732x-Q1, LP8733x-Q1, LP8732x, LP8733x devices. In LP873x PGOOD monitoring is masked with EN signal, meaning when bucks are disabled the PGOOD is not monitored and the signal is high. This is done to allow…
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] LP8733-Q1: Where can I find register default information (OTP) for a LP873x PMIC

    Tomi Koskela
    Tomi Koskela
    Part Number: LP8733-Q1 Other Parts Discussed in Thread: LP8733 This FAQ applies for LP8732x-Q1, LP8733x-Q1, LP8732, LP8733 family devices. Datasheet for LP873x-Q1 devices typically does not include OTP default information since there are hundreds…
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] LP87561-Q1: Where can I find register default values (OTP) for a LP875x-Q1 device

    Tomi Koskela
    Tomi Koskela
    Part Number: LP87561-Q1 This FAQ applies for LP8752x-Q1 and LP8756x-Q1 family devices. Datasheet for LP875x-Q1 devices typically does not include OTP default information since there are hundreds of OTP spins on this product family and maintaining…
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] LP87561-Q1: How can I use LP875x-Q1 PGOOD as nRESET signal for SoC

    Tomi Koskela
    Tomi Koskela
    Part Number: LP87561-Q1 This FAQ applies to LP8752x-Q1 and LP8756x-Q1 devices. In LP875x PGOOD monitoring is masked with EN signal, meaning when bucks are disabled the PGOOD is not monitored and the signal is high. This is done to allow combining…
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS6594-Q1: Residual Voltage Check

    Chris Sterzik
    Chris Sterzik
    Part Number: TPS6594-Q1 How does the residual voltage check work?
    • Answered
    • over 3 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS6594-Q1: Schematics and PCB Checklist for TI Review Feedback

    Phil Yi
    Phil Yi
    Part Number: TPS6594-Q1 Other Parts Discussed in Thread: TPS6593-Q1 , This thread applies to TPS6593-Q1, TPS6594-Q1. Please download and complete the schematic checklist first and then ask TI team to review for feedback. ------------------------…
    • over 3 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TPS2378EVM-602: enabling on-board switch-mode regulator 0 Locked

    381 views
    4 replies
    Latest over 5 years ago
    by Darwin Fernandez
  • Answered

    BQ27541-G1: RC and FCC becomes double or more issue after idle long time 0 Locked

    290 views
    1 reply
    Latest over 5 years ago
    by Kang Kang
  • Answered

    TPS7A33: TPS7A3301RGW & Feedforward Capacitor 0 Locked

    486 views
    2 replies
    Latest over 5 years ago
    by Shmuel Davis
  • Answered

    TPS40210: problem with Fet gate drive 0 Locked

    347 views
    6 replies
    Latest over 5 years ago
    by Soumitra Bhattacharjee
  • Suggested Answer

    Unable to launch PSPICE after installation 0 Locked

    1016 views
    7 replies
    Latest over 5 years ago
    by Anurag Kumar20
  • Answered

    WEBENCH® Tools/LM5161: LM5161 flybuck configuration for 3V3 with dual supply 0 Locked

    509 views
    6 replies
    Latest over 5 years ago
    by Anurag Kumar20
  • Not Answered

    UCC256402: HV to VCC to VREG concerns and other questions 0 Locked

    308 views
    2 replies
    Latest over 5 years ago
    by Benjamin Lough
  • Answered

    BQ40Z50-R1: How to understand the register function of Device Gauging Data (at the Time of the PF Event)? 0 Locked

    233 views
    3 replies
    Latest over 5 years ago
    by Statham Su
  • Answered

    BQ40Z60: Production steps for BQ40Z60 0 Locked

    483 views
    6 replies
    Latest over 5 years ago
    by R D2
  • Suggested Answer

    BQ40Z60EVM-578: the default values 0 Locked

    424 views
    9 replies
    Latest over 5 years ago
    by Kang Kang
  • Suggested Answer

    BQ40Z60: Learning and configuration issue. 0 Locked

    661 views
    24 replies
    Latest over 5 years ago
    by Kang Kang
  • Suggested Answer

    BQ27426EVM-738: Short circuit while connection of Fuel Gauge with Protection IC and Battery 0 Locked

    444 views
    3 replies
    Latest over 5 years ago
    by Kang Kang
  • Not Answered

    BQ24773: BQ24773 Losing adapter detection after some time, ACOK not working correctly 0 Locked

    339 views
    1 reply
    Latest over 5 years ago
    by Angelo Zhang87
  • Answered

    UCC27524: What is the difference between using a PNP and a Pmos as dual-polarity, symmetrical drive-gate transformer turn off SW? 0 Locked

    1489 views
    5 replies
    Latest over 5 years ago
    by Mamadou Diallo
  • Answered

    TPSM84212: Can I use TPSM84212 in parallel in order to have more current output and how? 0 Locked

    330 views
    2 replies
    Latest over 5 years ago
    by user5946246
  • Suggested Answer

    LM5066: Questions 0 Locked

    477 views
    3 replies
    Latest over 5 years ago
    by Rakesh
  • Answered

    TPS2663: two devices parallel gives "oscilation" during startup with big capacitive load 0 Locked

    511 views
    4 replies
    Latest over 5 years ago
    by Rakesh
  • Answered

    TPS53353: How the ESR of output capacitor affect the stability? 0 Locked

    1901 views
    6 replies
    Latest over 5 years ago
    by Peter James Miller
  • Answered

    TPS546C23: pull high resistor value of PMBUS(data/ Alert) 0 Locked

    289 views
    2 replies
    Latest over 5 years ago
    by Peter James Miller
  • Suggested Answer

    BQ25606: Reverse battery polarity protection circuit 0 Locked

    854 views
    3 replies
    Latest over 5 years ago
    by Ning T
<>