TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM64X/ AM62X : How to Reset the SOC when WDT timer expires in AM64X and AM62X?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Introduction: The primary application of a watchdog timer is as a system monitor to detect and reset an "out of control" SOC. When program execution goes wrong or software or devices are not functioning properly, the watchdog…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH/AM62A: How to create the CAC mesh LUT for DCC tuning tool input?

    Gang Hua
    Gang Hua
    CAC in VPAC3-VISS or VPAC3L-VISS is very similar to LDC in VPAC. To prepare the CAC LUT for DCC tuning tool input, we may use similar matlab/octave script as LDC. You may refer to the LDC FAQ in the link below for more details. e2e.ti.com/.../faq-tda4vm…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] DRA821: canTxstatus is busy even after Cancellation of Finished messages is set for respective Tx Buffer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customer has enabled AUTO retransmission of messages, and Using the CAN channel on TDA4x device to continuously send messages, and then remove other nodes on the CAN bus. Later it entered into Error passive state , and the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J784S4: How Do I Build Yocto Images and Packages for J7 Devices?

    Jared McArthur
    Jared McArthur
    Part Number: PROCESSOR-SDK-J784S4 Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , AM68 , AM69 , SK-AM68 , SK-AM69 How do I build the default yocto images and install new packages for J7 devices?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP : LFOSC usage in the processor

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P-Q1 , , AM62A7-Q1 , AM623 Hi, I have a question from my customer for LFOSC (external 32.668kHz). According to datasheet section 7.11.4.1 Input Clocks / Oscillators, it seems the clock…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62A7 / AM62A3 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Custom board hardware design – EXTINTn pin pullup connection

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Hi TI Experts, I have the below queries regarding the use of EXTINTn pin. Termination recommendations when used. Termination recommendations when not used. Let me know your thoughts.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62A-LP , AM62P , TMUX1308-Q1 , TPS65224-Q1 Hi Board designers, Refer FAQs listed below related to custom board design for AM62Ax and AM62D-Q1 processor families that could be used along with other available…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625, AM623, AM620-Q1, AM625-Q1, AM625SIP Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62 , SK-AM62B-P1 , SK-AM62-LP , SK-AM62-SIP , SK-AM62B , AM62P , TMUX1308-Q1 , TPS65219 Hi Board designers, Refer FAQs listed below related to custom board design for AM62x processor family that could…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1 / AM625-Q1 Custom board hardware design – Collaterals to Get started

    Lavanya M R
    Lavanya M R
    Part Number: AM625-Q1 Other Parts Discussed in Thread: AM620-Q1 , AM625 , AM623 , , AM625SIP , AM62D-Q1 , TPS65219 , SK-AM62-LP , SK-AM62B-P1 , SYSCONFIG Hi TI Experts, Can you provide a List of collaterals that can be referred when starting a custom…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VL How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198206 Discussions
  • Suggested Answer

    AUDIO-AM62D-EVM: How to Activate Audio Weaver Designer License for AM62D AWE SDK 0 Locked

    151 views
    1 reply
    Latest 2 months ago
    by Santosh Jha
  • Answered

    AM623: QSPI Communication Between AM623 and FPGA – Read Operation working but Writing 0 Locked

    213 views
    4 replies
    Latest 2 months ago
    by Mehmet Fide
  • Suggested Answer

    DRA821U: Issues with the QuadPhy on the J7200-EVM 0 Locked

    111 views
    5 replies
    Latest 2 months ago
    by Doredla Sudheer Kumar
  • Not Answered

    AM625: LVDS integration with custom panel and HMI modification 0 Locked

    92 views
    4 replies
    Latest 2 months ago
    by Divyansh Mittal
  • Not Answered

    SK-TDA4VM: boot logs 0 Locked

    137 views
    4 replies
    Latest 2 months ago
    by Gokul S
  • Answered

    IND-COMMS-SDK: PRU does not start 0 Locked

    250 views
    17 replies
    Latest 2 months ago
    by Harsha Begihally Shanmukhaswamy
  • Answered

    TDA4VM-Q1: Uniflash tool fails to flash the keywriter. 0 Locked

    233 views
    6 replies
    Latest 2 months ago
    by Diwakar Dhyani
  • Suggested Answer

    TDA4VM-Q1: Does keywriter APP has software (PDK) dependency problems 0 Locked

    110 views
    2 replies
    Latest 2 months ago
    by Diwakar Dhyani
  • Answered

    AM62L-PROCESSOR-SDK: Weston support in the latest SDK 0 Locked

    141 views
    4 replies
    Latest 2 months ago
    by Dheeraj K
  • Answered

    PROCESSOR-SDK-J7200: Boot failure with custom R5F-Firmware 0 Locked

    188 views
    10 replies
    Latest 2 months ago
    by Tarun Mukesh Puvvada
  • Suggested Answer

    AM5728: [AM5728] MCSPI1 receives only 0x00 on MISO (SPI1_D1) despite valid waveform observed 0 Locked

    61 views
    1 reply
    Latest 2 months ago
    by Josiitaa RL
  • Answered

    AM62A7: MCU Access to Main CAN Modules 0 Locked

    85 views
    1 reply
    Latest 2 months ago
    by Meet Thakar
  • Answered

    TDA4VH-Q1: About the maximum resolution of DMPAC of the TDA4Vx 0 Locked

    80 views
    1 reply
    Latest 2 months ago
    by Brijesh Jadav
  • Not Answered

    AM3359: Request for Guidance on Achieving <1ms Ethernet Latency on AM335x with DP83867 PHY 0 Locked

    90 views
    1 reply
    Latest 2 months ago
    by vaishnavi h v
  • Not Answered

    TDA4VM: Sciclient_init is blocked when using IPCLLD 0 Locked

    464 views
    18 replies
    Latest 2 months ago
    by Karthikeyan S
  • Not Answered

    SK-AM62A-LP: During power cycle testing, IPC errors sometimes occur and gstreamer TIOVX elements do not work. +1 Locked

    396 views
    4 replies
    Latest 2 months ago
    by Bas Vermeulen
  • Suggested Answer

    AM62L: Can we compiler "ti-lvgl-demo" without docker? 0 Locked

    79 views
    1 reply
    Latest 2 months ago
    by Divyansh Mittal
  • Answered

    AM625-Q1: OTP keywriter shows no output when loaded over serial 0 Locked

    184 views
    5 replies
    Latest 2 months ago
    by Prashant Shivhare
  • Not Answered

    TDA4AEN-Q1: Can not set breakpoint in MCU Cortex R5_1 in Code Composer Studio 12.8.1 0 Locked

    218 views
    9 replies
    Latest 2 months ago
    by Tarun Mukesh Puvvada
  • Not Answered

    AM3358: Getting I2C write error very intermittently with pixcir touchscreen sensor 0 Locked

    155 views
    5 replies
    Latest 2 months ago
    by Prafull Barpute
<>