Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] TDA2PXEVM: Temperature calculation at runtime for hlos usecase

    Hello, I am working on hlos use case and want to calculate the temperature at runtime. Please suggest some solution. Thank you in advance!

  • [FAQ] PROCESSOR-SDK-DRA8X-TDA4X: How to use IPC Example Application Echo Test on PSDKQA7.0

    Part Number: PROCESSOR-SDK-DRA8X-TDA4X How is the IPC echo test application built and run on the PSDKQA7.0 release?

  • [FAQ]: How to connect CAL to VIP on TDA2Px?

    Part Number: TDA2PXEVM TDA2Px supports Camera Adapter Layer (CAL) module to capture input over CSI interface. When YUV camera is connected to CAL over CSI interface, the data captured by CAL can be redirected to VIP module and VIP can be used for on…

  • [FAQ]: How to configure DSS for BT656 or BT1120 output format?

    Part Number: PROCESSOR-SDK-DRA8X-TDA4X Many of the LCDs and encoders accept the video over BT656 or BT1120 format. How t0 change PSDKRA to configure DSS for BT656 and BT1120 output format?

  • [FAQ] TDA4VM: Application in the PSDKRA runs standalone from SBL but doesn't run alongside Linux

    Part Number: TDA4VM I took an PSDKRA example ran it using SBL and it ran fine. But now when I copy the same application executable and put it in /lib/firmware of the SD card, it doesn't load. What could be the problem?

  • [FAQ]: How to run multi-cam usecase for YUV sensors?

    Part Number: PROCESSOR-SDK-DRA8X-TDA4X Multi-Cam example on PSDKRA currently supports RAW sensor. How to change it to use for YUV sensors?

  • [FAQ] TDA4VM: Routing interrupts via the interrupt router

    Part Number: TDA4VM How to route an interrupt from a peripheral via the interrupt router to the core?

  • [FAQ]: How to detect erroneous input frame in VIP?

    VIP receives input data over digital parallel input. Due to various reasons, the input signals could sometimes have errors and the frames captured during this needs to be detected, so that they don't get processed further. How can application detect these…

  • [FAQ] CCS/TDA4VM: How to view c6x trace buffer on Linux?

    Part Number: TDA4VM Tool/software: Code Composer Studio How to Debug/view the contents of c6x trace buffer in CCS? In the absence of CCS how to view the trace buffer from Linux side?

  • [FAQ] TDA2x: How to flash images to the QSPI memory from the u-boot prompt in vision SDK Linux?

    Hi, The use-guide (file::/PROCESSOR_SDK_VISION_03_07_00_00/vision_sdk/docs/Linux/VisionSDK_Linux_UserGuide.pdf) has steps to flash the images to QSPI memory from the host machine, for this we need to connect a USB cable from P2/USB1 to host PC. This…

View FAQ threads
  • Threads 198122 Discussions