Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM625 Other Parts Discussed in Thread: AM623 , AM6546 , AM6442 , AM2432 , TDA4VH-Q1 , TDA4VH
Tool/software:
HI TI experts,
I have queries related to the voltage monitoring capability of the SOC POK module types, accuracy., design recommendations…
Part Number: AM625
Tool/software:
SOC_UID is a device specific identifier calculated by ROM based on "KEK of the device which is unique to every single device, plus other ROM mata-data structure". - unique per SoC and persistent - available on HS…
Part Number: AM625
Tool/software:
Hi
we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board.
In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface.
Does this "min" specification…
Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM
Tool/software:
Hi TI Expert,
How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ?
Regards
Part Number: AM62
Tool/software:
The IgH EtherCAT stack is an open source EtherCAT stack.
It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
