Part Number: AM6411

Tool/software:

Hi TI Experts,

In the AM243x data sheet, i see 2 packages.

Can you summarize the difference is peripherals and IOs.

This is the companion FAQ for

 [FAQ] [Alert] DM R5F can crash in certain conditions: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A  

Please read the alert first.

General questions

What is the root cause of the issue?

Is this a silicon bug?

When was the issue fixed?

Our design meets all the conditions for a crash, but we do not want to update the DM R5F firmware. Will our system actually crash after running for 49 days?

The A53 cores in my design are not running Linux. Could my design still be affected?

What are typical scenarios where RPMsg IPC communication is not initialized between the DM R5F and Linux?

We are writing custom DM R5F firmware. Could our design be affected?

Other FAQs

Linux: How to check what binary is running on the DM R5F

Linux: How to check whether the Linux remoteproc & RPMsg drivers are attaching to the DM R5F and initializing the RPMsg infrastructure

SPL boot: How to find the DM R5F binary that is built into tispl.bin

SBL boot: How to check the DM R5F firmware that is loaded by SBL

How do I trigger the DM R5F crash? How do I verify that the crash is actually fixed?

Does the DM R5F need to run the IPC Echo demo task?

Part Number: AM62L

Tool/software:

Hi TI Experts, 

Usually add RC filter on RESET signal to anti-noise, but the slew rate requirement of RESET signal on AM62x datasheet is quite sharp, on customer board it is about 10V-100V/ms, can it meet AM62x reset requirement, if not please help to explain the basic mechanism. 

Part Number: TDA4VH-Q1

Tool/software:

DSS includes a hardware-enabled freeze frame checker at each pipeline output and vp output. When enabled,
it generates a data signature of pixels from a user define region for each frame. The current frame signature is
then saved and compared with next frame data signature to determine if any data in the region has changed
or not. If the signature remains unchanged more than a user defined threshold value, the DSS HW generates a
freeze frame detection event to indicate a possible frozen display.

Part Number: AM62L

Tool/software:

Hi TI Experts

I see the below status on TI.com for AM62L

Can you provide additional inputs on the collaterals to be referred or guidelines to follow during custom board design

Part Number: AM62L

Tool/software:

Hi TI experts

help me understand the supported bootmode configurations for the below family of processors

AM625 / AM623 / AM620-Q1 / AM64x / AM243x / AM62Ax / AM62Px / AM62D-Q1 / AM62L

Part Number: AM62L

Tool/software:

Hi TI Experts,

I am designing custom board using AM62L.

Can you provide your inputs on the supported power architecture when custom board design is configured for RTC mode or RTC + IO DDR mode or without low-power mode

Part Number: AM62P

Tool/software:

I've successfully tested low power modes on AM62P using the default images. But I've tried to build my own U-Boot images, but now low power modes are not working. What is the cause and solution to this?

Part Number: AM62L

Tool/software:

Hi TI Experts,

Could you confirm that the voltage domains are correct for the MMC1_SDCD and MMC1_SDWP pins?  The datasheet shows both MMC0 and MMC2 as having all member pins bellowing to the same voltage domain.  For MMC1 however, the pins are shown split across VDDSHV3 and VDDSHV1

Part Number: TDA4VM

Tool/software:

After a CPSW reset recovery from ETHFW, gPTP fails to re-establish synchronization, impacting time-sensitive applications.