TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198305 Discussions
  • Not Answered

    problem with dm368 h264encoder with 1080p 0 Locked

    189 views
    0 replies
    Started over 14 years ago
    by siva prasad
  • Not Answered

    problem with dm368 h2643nc 0 Locked

    213 views
    0 replies
    Started over 14 years ago
    by siva prasad
  • Discussion

    debugging dsplink on omap l138, how to connect with wince on arm Locked

    854 views
    10 replies
    Latest over 14 years ago
    by Kevin the almighty
  • Answered

    Specifying section location in CCS4 0 Locked

    467 views
    5 replies
    Latest over 14 years ago
    by Peter Steinberg
  • Answered

    C6747 UART, PSP driver and GIO_submit of buffer size=1 0 Locked

    885 views
    2 replies
    Latest over 14 years ago
    by Fawad Nackvi62335
  • Answered

    PowerVR library and interrupts 0 Locked

    281 views
    1 reply
    Latest over 14 years ago
    by Mauricio Sanchez15270
  • Answered

    DM355 mpeg4enc 03_10_00_02 datasheet & user guide 0 Locked

    343 views
    4 replies
    Latest over 14 years ago
    by Robin Iddon
  • Not Answered

    Android BSP for OMAP3430-VE 1.0.0 0 Locked

    204 views
    2 replies
    Latest over 14 years ago
    by Kobe Shapira
  • Answered

    DM365 IPNC-MT5 Kernel fails to start 0 Locked

    453 views
    3 replies
    Latest over 14 years ago
    by Anshuman Saxena
  • Suggested Answer

    TMS320C6748 interrupt pin question 0 Locked

    538 views
    2 replies
    Latest over 14 years ago
    by Sathish
  • Answered

    psp 2.0 error in nand llc driver? 0 Locked

    474 views
    7 replies
    Latest over 14 years ago
    by Sandeep Krishnaswamy
  • Not Answered

    Configuring CS3 of OMAP3530 GPMC to Memory map a 8bit Non-Multiplexed ASIC device in Windows CE. 0 Locked

    287 views
    0 replies
    Started over 14 years ago
    by Sabin Soman
  • Answered

    DM6437 Previewer in Busy state 0 Locked

    234 views
    1 reply
    Latest over 14 years ago
    by Brijesh Jadav80
  • Not Answered

    glFramebufferBlit or equivalent in SGX Graphics SDK for OMAP/Sitara (dirty region redraw implementation) 0 Locked

    442 views
    1 reply
    Latest over 14 years ago
    by Prabindh Sundareson
  • Not Answered

    DM365 D+ pull-up enabled while device is in deepsleep mode for USB suspend operation 0 Locked

    295 views
    0 replies
    Started over 14 years ago
    by Andrew Hamill
  • Answered

    "Implementing DDR2/3 PCB Layout on the TMS320C6A816x..." application report 0 Locked

    212 views
    2 replies
    Latest over 14 years ago
    by Bonzai
  • Answered

    OMAP3530 to DM3730 Migration - package considerations 0 Locked

    628 views
    5 replies
    Latest over 14 years ago
    by Michael T
  • Not Answered

    How to retransmit an Ethernet packet 0 Locked

    353 views
    5 replies
    Latest over 14 years ago
    by Varada Bellary
  • Not Answered

    Multiple processes reading from /dev/video0 0 Locked

    433 views
    1 reply
    Latest over 14 years ago
    by Brijesh Jadav80
  • Not Answered

    flash sector read operation fails, but the ecc could not detect this? 0 Locked

    135 views
    2 replies
    Latest over 14 years ago
    by Huai Hellen
<>