TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198289 Discussions
  • Not Answered

    High bandwidth interface to additional C647x DSPs 0 Locked

    144 views
    0 replies
    Started over 14 years ago
    by Josh King
  • Not Answered

    UART staying in reset using PSP drivers when AIS booting from SPI flash 0 Locked

    210 views
    1 reply
    Latest over 14 years ago
    by jc-ti
  • Answered

    OMAPL138 power down options 0 Locked

    478 views
    3 replies
    Latest over 14 years ago
    by clam
  • Not Answered

    TMS320C5515EVM - bootloader problem 0 Locked

    233 views
    2 replies
    Latest over 14 years ago
    by Peter Chung
  • Answered

    BT.656 to 1808 experimenter's kit 0 Locked

    347 views
    3 replies
    Latest over 14 years ago
    by Anonymous
  • Answered

    Warm reset issue 0 Locked

    2500 views
    13 replies
    Latest over 14 years ago
    by DavidVescovi
  • Not Answered

    DMVA2IPNC triggered mode 0 Locked

    129 views
    0 replies
    Started over 14 years ago
    by umair khan
  • Not Answered

    ### DM6446 Nand Boot 0 Locked

    352 views
    1 reply
    Latest over 14 years ago
    by Gaurav Agarwal
  • Not Answered

    Spread spectrum calculation clarification 0 Locked

    146 views
    0 replies
    Started over 14 years ago
    by Chris Chapman
  • Not Answered

    AM3505 Warm Reset 0 Locked

    508 views
    2 replies
    Latest over 14 years ago
    by Ken Turocy
  • Not Answered

    Queries related to McBSP configuration 0 Locked

    163 views
    3 replies
    Latest over 14 years ago
    by PaulM
  • Not Answered

    How to get access to the ADC on dm365? 0 Locked

    497 views
    3 replies
    Latest over 14 years ago
    by Marcus Cooksey
  • Answered

    L1D and L1P space properties in .tcf file 0 Locked

    308 views
    3 replies
    Latest over 14 years ago
    by RandyP
  • Answered

    C6748 UPP problem 0 Locked

    679 views
    4 replies
    Latest over 14 years ago
    by Scott Colson
  • Not Answered

    H264 codecs cannot use in demo 0 Locked

    419 views
    2 replies
    Latest over 14 years ago
    by philip lee46717
  • Not Answered

    OMAP3530 EVM fatload error 0 Locked

    209 views
    1 reply
    Latest over 14 years ago
    by Adeneo Embedded support team
  • Suggested Answer

    BIOS Sizing - removing dynamic management of BIOS objects 0 Locked

    443 views
    4 replies
    Latest over 14 years ago
    by Jordon
  • Not Answered

    DSS Software reset 0 Locked

    191 views
    1 reply
    Latest over 14 years ago
    by Adeneo Embedded support team
  • Not Answered

    DM365 IPNC MT5 - file system update 0 Locked

    323 views
    1 reply
    Latest over 14 years ago
    by Raghu Kudva
  • Not Answered

    Problem Running the Encode Decode demos 0 Locked

    423 views
    0 replies
    Started over 14 years ago
    by Aditya Barawkar
<>