TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197692 Discussions
  • Answered

    I2C and UART 0 Locked

    3334 views
    11 replies
    Latest over 9 years ago
    by ABHINAV KUMAR
  • Answered

    tirtos system clock 0 Locked

    454 views
    3 replies
    Latest over 9 years ago
    by user4245952
  • Answered

    AM5728 Linux: omap_hsmmc timeout on cache enable at powerup 0 Locked

    1749 views
    5 replies
    Latest over 9 years ago
    by Jason Howard65
  • Not Answered

    Processor SDK 2.00.107 ethernet speed question 0 Locked

    1831 views
    5 replies
    Latest over 9 years ago
    by justin wang1
  • Answered

    Help resetting c5515 eZdsp 0 Locked

    802 views
    3 replies
    Latest over 9 years ago
    by Mark M
  • Suggested Answer

    How to make ROM image using MAD tools? 0 Locked

    1529 views
    6 replies
    Latest over 9 years ago
    by Yoo Yong-Gil
  • Not Answered

    TIRTOS USBMSCHFatFs, when is it safe to power down USBI am using 0 Locked

    449 views
    3 replies
    Latest over 9 years ago
    by Barry Andrews
  • Suggested Answer

    Two TLV320AIC3204 Audio CODECs on C5505 eZdsp 0 Locked

    947 views
    2 replies
    Latest over 9 years ago
    by Bhargav AK
  • Answered

    ADC multiple channel with tasks 0 Locked

    468 views
    1 reply
    Latest over 9 years ago
    by Gilbert Rodriguez III
  • Answered

    C5535 interrupt vector table 0 Locked

    1620 views
    3 replies
    Latest over 9 years ago
    by Vasantha K
  • Not Answered

    non-handle interrupt causes context switch corruption in TI-RTOS 0 Locked

    1583 views
    8 replies
    Latest over 9 years ago
    by Emmanuel Trinidad - Alicea
  • Suggested Answer

    C6657 DDR3 IFRDY bit of STATUS Register 0 Locked

    797 views
    1 reply
    Latest over 9 years ago
    by Tom Johnson 16214
  • Answered

    L2/L3?L4 classification problem on EVM6678 (multicore work). 0 Locked

    1334 views
    8 replies
    Latest over 9 years ago
    by LeonL
  • Suggested Answer

    0,1 % frame lost with 1GBit ethernet 0 Locked

    797 views
    4 replies
    Latest over 9 years ago
    by Pototo Clark
  • Answered

    AES mode of AM5728 0 Locked

    2304 views
    3 replies
    Latest over 9 years ago
    by Bin Liu
  • Suggested Answer

    Am335x EVM problem with FT5x06 capacitive tochscreen 0 Locked

    17447 views
    50 replies
    Latest over 9 years ago
    by Brad Griffis
  • Suggested Answer

    AM4378 DDR3 memory Spec 0 Locked

    1085 views
    1 reply
    Latest over 9 years ago
    by Biser Gatchev-XID
  • Answered

    Can I get the reason that a Semaphore_pend(timeout) returned? 0 Locked

    1097 views
    2 replies
    Latest over 9 years ago
    by JackJohnson
  • Answered

    Simple Timer Operations Failing 0 Locked

    1685 views
    7 replies
    Latest over 9 years ago
    by Emmanuel Trinidad - Alicea
  • Suggested Answer

    I2C Test: 400Kbps: Data Mismatch 0 Locked

    3823 views
    7 replies
    Latest over 9 years ago
    by Lalindra Jayatilleke
<>