TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197662 Discussions
  • Answered

    Using Semaphore_Params_init 0 Locked

    908 views
    1 reply
    Latest over 14 years ago
    by Karl Wechsler
  • Not Answered

    Unknown command 'mmcinit' - try 'help' 0 Locked

    2563 views
    7 replies
    Latest over 14 years ago
    by Adeneo Embedded support team
  • Not Answered

    Recording Issue with OMAP3530 REV G EVM. 0 Locked

    143 views
    0 replies
    Started over 14 years ago
    by preetam reddy
  • Discussion

    QualiTI cgtools path Locked

    684 views
    4 replies
    Latest over 14 years ago
    by Helmut Forren
  • Not Answered

    arecord - error (pcm_read:1529: read error: input/output error) 0 Locked

    1725 views
    1 reply
    Latest over 14 years ago
    by Adeneo Embedded support team
  • Not Answered

    DM365 SDHC Encode 0 Locked

    311 views
    2 replies
    Latest over 14 years ago
    by toowudi
  • Not Answered

    How to set PCIe subvendor/subdevice info during PCIe boot. 0 Locked

    549 views
    3 replies
    Latest over 14 years ago
    by Stephen Turner
  • Not Answered

    OMAP-L138 ARM config the EMIFA 0 Locked

    446 views
    1 reply
    Latest over 14 years ago
    by jc-ti
  • Not Answered

    Programming AIC23 for DSP6713 0 Locked

    280 views
    2 replies
    Latest over 14 years ago
    by Meriem Demraoui
  • Discussion

    MV range for DM365 H264 encoder Locked

    2350 views
    23 replies
    Latest over 14 years ago
    by Mahant S
  • Answered

    Power sequence without AVS 0 Locked

    446 views
    1 reply
    Latest over 14 years ago
    by MarcPyne
  • Answered

    Problem of resizer on DM365 in AV_SERVER structure 0 Locked

    935 views
    9 replies
    Latest over 14 years ago
    by Parry Huang
  • Answered

    IMGENC1_create/process vs. IIMGENC1_Fxns 0 Locked

    344 views
    3 replies
    Latest over 14 years ago
    by Gennadiy Kiryukhin
  • Not Answered

    High bandwidth interface to additional C647x DSPs 0 Locked

    143 views
    0 replies
    Started over 14 years ago
    by Josh King
  • Not Answered

    UART staying in reset using PSP drivers when AIS booting from SPI flash 0 Locked

    202 views
    1 reply
    Latest over 14 years ago
    by jc-ti
  • Answered

    OMAPL138 power down options 0 Locked

    471 views
    3 replies
    Latest over 14 years ago
    by clam
  • Not Answered

    TMS320C5515EVM - bootloader problem 0 Locked

    230 views
    2 replies
    Latest over 14 years ago
    by Peter Chung
  • Answered

    BT.656 to 1808 experimenter's kit 0 Locked

    342 views
    3 replies
    Latest over 14 years ago
    by Anonymous
  • Answered

    Warm reset issue 0 Locked

    2475 views
    13 replies
    Latest over 14 years ago
    by DavidVescovi
  • Not Answered

    DMVA2IPNC triggered mode 0 Locked

    127 views
    0 replies
    Started over 14 years ago
    by umair khan
<>