Because of the holidays, TI E2E™ design support forum responses will be delayed from Dec. 25 through Jan. 2. Thank you for your patience.

Texas Instruments (TI) Sensors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search sensors IC content or ask technical support questions on everything from temperature and humidity sensors to magnetic sensors and mmWave sensors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] PGA900: Is there general information and guidance regarding the PGA900?

    Part Number: PGA900 Tool/software: I'm having some issues and need some guidance regarding the PGA900. What information is available?

  • [FAQ] PGA900: Is there general device comparison and overview of the PGA devices?

    Part Number: PGA900 Other Parts Discussed in Thread: PGA300 , PGA302 , PGA305 Tool/software: I've been looking at various PGA devices, and was wondering if there is an overview and comparison for the different devices to measure pressure?

  • [FAQ] PGA900: Answers to Common Questions for TI's PGA900 and PGA30x Devices

    Part Number: PGA900 Other Parts Discussed in Thread: PGA300 , PGA302 , PGA305 Tool/software: Does TI have answers to various device questions for the PGA devices, including the following? PGA900 PGA300 PGA302 PGA305 Thanks!

  • [FAQ] IWRL6432: How do I set the minor motion velocity inclusion threshold to include points?

    Other Parts Discussed in Thread: IWRL6432 Minor mode on the IWRL6432 requires users to set an argument for the maximum velocity that the IWRL6432 can detect minor mode points with. Points detected in minor mode with a velocity greater than this threshold…

  • [FAQ] AWR2944: X-Ray Sensitivity

    Part Number: AWR2944 Other Parts Discussed in Thread: AWR2E44 TI does not typically specify acceptable x-ray levels on the device datasheet. Experience has shown that most TI products will NOT be sensitive to typical x-ray inspection (with typical exposures…

  • [FAQ] LDC5072-Q1: How do you add a sensor, target and resonating cap to the LDC5072-Q1 EVM to prototype an inductive resolver system?

    Part Number: LDC5072-Q1 Theory of Operation The LDC05072-Q1 is a front-end for inductive position sensors for measuring absolute rotary position in automotive and industrial applications. Inductive position sensors work on the principle of eddy curre…

  • [FAQ] IWRL6432: Steps Rapid Debugging on the IWRL6432

    Part Number: IWRL6432 Other Parts Discussed in Thread: UNIFLASH Writing code to the IWRL6432 can be accelerated using a few developer tips. Here is a sequence of steps that may accelerate rapid iteration on software. Much of the information here is the…

  • [FAQ] IWRL6432: Toggling a GPIO to indicate presence detection

    Part Number: IWRL6432 The IWRL6432 can be used to detect presence for video camera systems. Integrating the IWRL6432 radar into an existing camera solution may require the user to send a signal to the camera from the radar when presence is detected. …

  • [FAQ] IWRL6432: Exporting the radar cube over UART

    Part Number: IWRL6432 Introduction When developing a product with the IWRL6432, some tasks may benefit from the ability to stream off the radar cube from the device. In certain scenarios, this may be possible over UART instead of the typical DCA1000…

  • [FAQ] IWRL6432: Debugging with Deep Sleep

    Part Number: IWRL6432 Other Parts Discussed in Thread: SYSCONFIG The xWRLx432 devices are designed with a deep sleep power state that allows the device to consume very little power when not chirping or processing data. When the device goes to deep sleep…

View FAQ threads