Texas Instruments (TI) Audio support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search audio IC content or ask technical support questions on everything from audio amplifiers (op amps) and audio converters (Codecs and ADCs) to audio interface and media processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: PCM2906C When running this USB Audio Converter device on Linux System, no capture/record control is seen in ALSA MIXER GUI thus the record volume can not be adjusted. How do you enable the volume control in this scenario?
Read First: High-quality, comprehensive questions can help you solve problems faster
According to your question, please follow the prompts below to select the relevant information you can provide, which will help you get fast and accurate support.
Basic…
Other Parts Discussed in Thread: JFE150 , TINA-TI We recently launched the JFE150, a discrete N-channel JFET targeting low noise applications.
JFE150 data sheet
Product information and support
Some key specs of the JFE150:
0.8 nV/rtHz broadband noise at…
Part Number: TLV320ADC3101 Other Parts Discussed in Thread: TLV320ADC3100
Hello,
What is the transfer function relationship between the input voltage applied to the TLV320ADC3101 and TLV320ADC3100 devices and the resulting output codes?
Part Number: PCM1840EVM Other Parts Discussed in Thread: PCM1840 The audio format selection settings outlined in the PCM1840EVM User's Guide and board silkscreen do not match the PCM1840 datasheet, which is correct?
Part Number: PCM3060
Dear TI
I would like to know the ESD (MM/HBM/CDM) rating of PCM3060.
A customer of mine is asking for the ESD ratings so that they can protect against harming the part during handling and loading on PCB. Please advise.
Best regards…
Part Number: TLV320AIC3254EVM-K
My customer is having issues getting the Eval Board started. It is connected via USB (D2 lights up). But when the GUI is launched nothing is displayed and here is an image of what we're getting:
I changed the settings…