TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS127L01 SPI interface 0 Locked

    805 views
    1 reply
    Latest over 8 years ago
    by Ryan Andrews
  • Not Answered

    Can ADS5400 use DC-coupled to sample signal from -2V to 0.5V? 0 Locked

    1175 views
    8 replies
    Latest over 8 years ago
    by Richard Prentice
  • Suggested Answer

    ADC12J4000EVM GUI 0 Locked

    422 views
    1 reply
    Latest over 8 years ago
    by Jim Brinkhurst1
  • Suggested Answer

    How to synchronize multiple ADCs and FPGAs across JESD204B link 0 Locked

    6473 views
    9 replies
    Latest over 8 years ago
    by Jim Brinkhurst1
  • Suggested Answer

    ADC synchronization 0 Locked

    405 views
    1 reply
    Latest over 8 years ago
    by Jim Brinkhurst1
  • Answered

    ADS1192 channel 2 causes interference to channel 1 0 Locked

    6083 views
    11 replies
    Latest over 8 years ago
    by Tom Hendrick
  • Not Answered

    AFE 4490 GUI python error 0 Locked

    651 views
    3 replies
    Latest over 8 years ago
    by Prabin Yadav
  • Answered

    Can I get the password for the ads1675evm_fw.zip and ads1675evm_source.zip please. 0 Locked

    603 views
    1 reply
    Latest over 8 years ago
    by Tom Hendrick
  • Not Answered

    ADC342x DCLK & FCLK 0 Locked

    860 views
    4 replies
    Latest over 8 years ago
    by David Guidry
  • Not Answered

    ADC3424 EVB 0 Locked

    378 views
    1 reply
    Latest over 8 years ago
    by David Guidry
  • Answered

    Bioimpedance Maximum 0 Locked

    532 views
    1 reply
    Latest over 8 years ago
    by Prabin Yadav
  • Suggested Answer

    ADS7822 & ADS7841 Deviation of 3σ 0 Locked

    735 views
    5 replies
    Latest over 8 years ago
    by RahulVK
  • Answered

    Custom firmware for TI ADS1118 BoosterPack 0 Locked

    2226 views
    14 replies
    Latest over 8 years ago
    by pi314rules
  • Answered

    ADS54J60 Fs/4 spur 0 Locked

    2334 views
    13 replies
    Latest over 8 years ago
    by Patrice Plante
  • Not Answered

    testing DAC3484 0 Locked

    656 views
    4 replies
    Latest over 8 years ago
    by jim s
  • Answered

    AMC7812EVM-PDK works with AMC7812EVM GUI when communicating over SPI, but, does not work over I2C 0 Locked

    975 views
    6 replies
    Latest over 8 years ago
    by Roger Leff
  • Answered

    ADS1220 noise when channel switching at high temperature 0 Locked

    1590 views
    4 replies
    Latest over 8 years ago
    by Bob Benjamin
  • Suggested Answer

    ADS1248 input RC-filter design for 2 wire PT1000 0 Locked

    4139 views
    6 replies
    Latest over 8 years ago
    by Joseph Wu
  • Suggested Answer

    ADS1248 ADC drift 0 Locked

    827 views
    3 replies
    Latest over 8 years ago
    by Joseph Wu
  • Suggested Answer

    RE: ADS9110EVM-PDK Zone 1 operation 0 Locked

    430 views
    1 reply
    Latest over 8 years ago
    by Luis Chioye
<>