TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADC12DJ5200-SP: SYSREF_P/N Input Clarity 0 Locked

    97 views
    1 reply
    Latest over 1 year ago
    by Joseph Sanchez
  • Suggested Answer

    ADS1299: Original waveform problem 0 Locked

    536 views
    11 replies
    Latest over 1 year ago
    by Jiahao Zhou
  • Suggested Answer

    ADS1286: ADS1286UL/2K5 0 Locked

    443 views
    12 replies
    Latest over 1 year ago
    by zhang zijian
  • Answered

    ADS1278-SP: thermal pad 0 Locked

    239 views
    3 replies
    Latest over 1 year ago
    by Keith Nicholas
  • Suggested Answer

    ADS8883: Data overflow issue 0 Locked

    192 views
    1 reply
    Latest over 1 year ago
    by Samiha Sharif
  • Suggested Answer

    DAC3482: Differential Mode with EVM 0 Locked

    252 views
    3 replies
    Latest over 1 year ago
    by Kang Hsia
  • Answered

    ADS1247: 18 Channel Multiplexing 0 Locked

    257 views
    1 reply
    Latest over 1 year ago
    by Bryan Lizon86
  • Suggested Answer

    ADC12DL2500: Pin termination 0 Locked

    214 views
    1 reply
    Latest over 1 year ago
    by Eric Kleckner
  • Answered

    ADC12D1600QML-SP: Inputs during Calibration Cycles 0 Locked

    215 views
    2 replies
    Latest over 1 year ago
    by Richard Katz
  • Suggested Answer

    ADS1299: Power consumption in Continuous Conversion mode vs. Single-Shot mode 0 Locked

    859 views
    3 replies
    Latest over 1 year ago
    by Ryan Andrews
  • Answered

    ADS1261: ADS1261 Reference voltage 0 Locked

    451 views
    6 replies
    Latest over 1 year ago
    by Bryan Lizon86
  • Suggested Answer

    AMC1304M25: Insulation according to IEC61800-5-1 0 Locked

    219 views
    1 reply
    Latest over 1 year ago
    by Alexander Smith
  • Not Answered

    DAC8775: BUCK-BOOST converter implementation 0 Locked

    373 views
    5 replies
    Latest over 1 year ago
    by Joseph Wu
  • Answered

    AMC7924: Inquiry on device control for DAC output 0 Locked

    299 views
    2 replies
    Latest over 1 year ago
    by JH Shin
  • Answered

    ADC12DL2500: input output Ground connection 0 Locked

    189 views
    1 reply
    Latest over 1 year ago
    by Rob Reeder
  • Answered

    ADC12QJ1600EVM: S-parameters for ADC12SJ800/1600 to simulate with different balun 0 Locked

    263 views
    3 replies
    Latest over 1 year ago
    by Rob Reeder
  • Answered

    DAC3482: PARITYP/PARITYN pins terminations when not using parity 0 Locked

    198 views
    1 reply
    Latest over 1 year ago
    by Kang Hsia
  • Answered

    ADS127L18: Check Block Diagram 0 Locked

    203 views
    1 reply
    Latest over 1 year ago
    by Keith Nicholas
  • Answered

    ADS8339: The lower 3 bits of ADS8339 (16bit ADC) are become biased to 1 or 0. 0 Locked

    245 views
    1 reply
    Latest over 1 year ago
    by Yolanda Gonzalez
  • Suggested Answer

    TI-JESD204-IP: IP Release-v1.12 compatibility with Vivado 2023.1 0 Locked

    646 views
    2 replies
    Latest over 1 year ago
    by David Chaparro
<>