TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] Peripheral Component Interconnect Express (PCIe) Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page PCIe Protection Highlights: PCIe: High speed serial bus expansion standard Slots come in different sizes: x1, x4, x8, x16, x32, x64 Each lane has two differential signaling pairs (Tx, Rx) PCIe Gen 5 bandwidth…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] LIN Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page LIN Protection Highlights: LIN: Single ended data transfer interface LIN clusters consist of 1 master and up to 16 slave nodes Construction: One wire for data transfer + ground Bidirectional configuration is…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] I2C Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page I2C Protection Highlights: 2 Lines to Protect Low Capacitance required to minimize signal interference Speeds up to 5Mbps TI Products Recommendations Working Voltage (V) IEC 61000-4-2 ESD…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Human-Machine Interface (HMI) Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page Human-Machine Interface (HMI) Protection Highlights: Protection needed for interfaces exposed to human contact Pushbuttons Keypads Touchscreens Any other points of frequent contact Operating Voltage…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] HDMI Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page HDMI Protection Highlights: High speed media, data transfer interface with 6 control lines & 8 data lines Operating voltage: For each data and control line, 3.3V and 5V respectively This requires a protection…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] GPIO Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page GPIO Protection Highlights: Operating Lines: I/Os Dataline operating voltage: 1.8 - 3.3 V, recommended breakdown > 3.6 V Capacitance is not a huge concern < 30 pF Multi-channel recommended for multiple I/Os…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] FPD-Link Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page FPD-Link Protection Highlights: FPD Link: Digital audio/video transfer protocol used in video screens or for driver assistance cameras in Automobiles, etc., Mode of operation: Single ended & differential mode …
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Ethernet Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page Ethernet Protection Highlights: 10 Mhz to 125 Mhz (10Mbps to 1Gbps) Operating line voltage ranges from -3.1 to 3.1V Recommended capacitance < 5 pF TI Products Recommendations Working Voltage…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DisplayPort Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page DisplayPort Protection Highlights: Data speeds up to 20Gbps 8 data lines, 20 total pins 3.3V, 500mA Input Low capacitance required on data lines Device V RWM Cap (pF) ESD(kV)…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] CAN ESD Protection

    Josh Prushing
    Josh Prushing
    Back to Interface Home Page CAN Protection Highlights: Protocol constructed with CAN-High and CAN-Low lines Requires a 2-channel diode to protect both lines and to match capacitance Bi-directional Configuration is needed to protect from…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    THVD1510: Fail-safe bias circuits 0 Locked

    244 views
    4 replies
    Latest 6 months ago
    by BOBBY
  • Not Answered

    TSS721A: This IC is not communicating with Micro-controller 0 Locked

    143 views
    3 replies
    Latest 6 months ago
    by Eric Hackett
  • Suggested Answer

    ESD451: Thunder bolt 4 application 0 Locked

    102 views
    1 reply
    Latest 6 months ago
    by Sebastian Muriel
  • Not Answered

    TUSB2E11: Can it be configured as USB2 to eUSB host? 0 Locked

    203 views
    5 replies
    Latest 6 months ago
    by Nicholaus_Malone
  • Suggested Answer

    TMUXHS4212: Does the high speed I/O capable for VCM of USB3.2 - 10Gbps? 0 Locked

    129 views
    1 reply
    Latest 6 months ago
    by Nir Gilgur
  • Suggested Answer

    TUSB422: a few questions to consult 0 Locked

    146 views
    1 reply
    Latest 6 months ago
    by Vishesh Pithadiya
  • Answered

    DP83848I: Active LED doesn't work 0 Locked

    142 views
    1 reply
    Latest 6 months ago
    by J
  • Answered

    DP83822I: Issue accessing the PHY address 0 Locked

    227 views
    7 replies
    Latest 6 months ago
    by Vivaan Jaiswal
  • Suggested Answer

    PCA9306: Can PCA9306 support 1Mhz I2C communication? 0 Locked

    170 views
    1 reply
    Latest 6 months ago
    by Jack Guan
  • Not Answered

    DS90UB953A-Q1: FPD CABLE DRIVER 0 Locked

    86 views
    1 reply
    Latest 6 months ago
    by Glenn Uranga
  • Answered

    TRSF3221E: Difference between TRSF3221E and TRS3227E 0 Locked

    131 views
    2 replies
    Latest 6 months ago
    by BOBBY
  • Not Answered

    TSD05C: 8V VRMS 0 Locked

    110 views
    2 replies
    Latest 6 months ago
    by Sebastian Muriel
  • Answered

    TCAN1145-Q1: CAN Transceiver "TCAN1145-Q1" take long time to wakeup 0 Locked

    210 views
    3 replies
    Latest 6 months ago
    by Eric Schott1
  • Suggested Answer

    THVD1400V: THVD1400V wire resistance on Bus input/output & Digital input 0 Locked

    151 views
    4 replies
    Latest 6 months ago
    by Parker Dodson
  • Suggested Answer

    DS160PT801: Electrical characteristics and pin mapping with description 0 Locked

    139 views
    1 reply
    Latest 6 months ago
    by David Waier
  • Answered

    SN65C1168E-SEP: Lack of steering diodes to power rails 0 Locked

    139 views
    1 reply
    Latest 6 months ago
    by Parker Dodson
  • Answered

    TCAN1164-Q1: Looking for a device 0 Locked

    116 views
    3 replies
    Latest 6 months ago
    by Ethan Sempsrott
  • Suggested Answer

    TCA39306-Q1: Design support for interfacing of I2C between MCU and I/O Expander TCAL9539-Q1 with different voltage level 0 Locked

    329 views
    7 replies
    Latest 6 months ago
    by Tyler Townsend
  • Suggested Answer

    DP83869HM: Crystal load capacitance 0 Locked

    128 views
    1 reply
    Latest 6 months ago
    by Gerome Cacho
  • Answered

    DS90UB914A-Q1: Upon changing the camera position and camera buffer and camera size, the cyan color got overlayed and there is color distortion. Red become blue, yellow become light green? 0 Locked

    295 views
    2 replies
    Latest 6 months ago
    by SubGA-singleton
<>